E TENDER REGARDING CONSTRUCTION OF BOUNDARY WALL AT LAND AT VILLAGE BIDAWAS BAWAL DISTT REWARI

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m, as directed by Engineer-in-charge.

Filling available excavated earth (excluding rock) in trenches, cum plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m lift up to 1.5m.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 1:4:8 (1 cement : 4 coarse sand (Zone-III): 8 cum graded stone aggregate 40 mm nominal size).

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement – All work up to plinth level. 1:1.5:3 (1 cement: 1.5 coarse sand (Zone –III): 3 cum graded stone aggregate 20mm nominal size).

Centering and shuttering, including strutting, propping etc. and removal of form for columns, pillars, piers, abutments, posts and struts.

Brick work with common burnt clay non-modular bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 Cement: 6 coarse sand).

Brick work with common burnt clay non-modular bricks of class designation 7 .5 in superstructure above plinth level up to floor IV level in all shapes and sizes in: Cement mortar 1:6 (1 cement: 6 coarse sand).

12 mm cement plaster of mix : 1 :4 (1 cement: 4 fine sand)

15 mm cement plaster on the rough side of single or half brick wall of mix : 1 :4 (1 cement: 4 fine sand).

Finishing walls with water proofing cement paint of required shade. New work (Two or more coats applied@ 3.84 kg/10 sqm)

Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect below plinth level. Thermo-Mechanically Treated bars of grade Fe-500D or more.

G.I Barbed Wire Fencing 1.2 Meter High Providing and fixing 1.2 meters high GI barbed wire fencing with 1.8 m angle iron posts 40 mm x 40 mm x 6 mm placed every 3 meters centre to centre founded in M15 grade cement concrete, 0.6 meter below ground level, every 15th post, last but one end post and comer post shall be strutted on both sides and end post on one side only and provided with 9 horizontal lines and 2 diagonals interwoven with horizontal wires, fixed with GI staples, tum buckles etc complete as per clause 807.

P/Laying concrete 1:2:4 for concrete base for water Tanks

In foundation Brick work and plinth in cem. Mortar 1:6

Brick work in super structure in cem. Mortar 1:6

Tile terracing with brick tiles laid in mud phuska over two coats of hot bitumen covered by mud phuska

Cem. Concrete gola on roof

Providing top Khurras

P/f 150mm dia PVC Rain water pipes along the walls

P/F PVC Bends

Base course for flooring

Screed of 50mm thickcem. Concrete 1:8:16

P/ Fixing wall tiles in dado of size 8"x 12" in toilets

Kota stone flooring

Extra for flooring in steps

Extra for nosing in treads

Kota stone in steps and risers/ skirting

Providing and laying plaster 12 mm thick on inside of walls in cem. Mortar 1:6

Providing and laying plaster 15 mm thick on inside of walls in cem. Mortar 1:6

Cem pointing flush 1:2 on tile terracing

P/laying vertical DPC on outer walls

Applying Priming coat with metal primer on new work including preparation of surface ( Stair Railing)

Painting two coats of ready mixed paint on metal surface

Preparation of plastered surface for oil bound distemper

Distempering with oil bound distemper of approved manufacturer and choice shade

Finishing walls with cem. Based paints of choice shade and approved make

Supplying and fixing Rolling shutters

Providing and laying steel bars FE500 EQR TMT as per design

P/F fan hooks 80cm long

Preparation of sub grade for roads

WBM 230 mm thick laid in two layers

laying jointing and fixing of PVC/GI pipe line for water supply with 20mm dia pipes including all special

Fixing Galvanised Malleable holder bats for rain water pipes on walls

Fixing stop cock 20mm dia of approved make

Making connection to existing line upto 40mm dia

Const. Brick masonary Inspection chambers

Extra for every 0.3 mtr depth

Construction of rectangular standard brick masonary chamber

Lowering SWPipes 150mm dia

Jointing and fixing in SW pipes 150 dia

P/F Gully trap 100m dia

Fixing of water tank including all connections for 5000 litre capacity

Providing circuit wiring with 3 core pvc copper wire

Earthing with tinned copper plate 600x600x3mm including all accessories and providing brick masonary enclosure with cover plates etc.

Wiring with 1.5sqmm PVC Insulated Copper conductor cable in 1.6mmthick conduit pipe for medium length points Fan Points

Light points

light point without control

Call bell point including MS box of size 180x100x60mm deep for call bell.

3-pin 5amp plug point with earthing the third pin

3-pin 15amp plug point with 4sqmm PVC Insulated copper conductor cable including earthing the third pin

P/Fixing modular type accessories of app. Make in existing box including fixing and making necessary connections 10amp. 1 way Switch

20amp. Switch

10amp. Socket

16amp. Socket

bell push

Fan Regulator

Blinking plates

supply and erection of doble door sheet steel enclosure for MCBs and ELCBs recessed in walls including all. 12 way SP&N

8 Way SP & N

P/F GI sheet concealed sheet metal box complete 1 & 2 Modules

3 Module

4 Modules

6 Modules

8 Modules

Supply of earth including loading, transportation, unloading and filling under floors in 15cm layers including spreading, ramming, watering consolidation and cost of earth brought at any distance complete in all respects including lead. Consolidated earth to be measured. )

Suppying 75mm stone metal

Providing 20mm id GI pipe B class for water supply

Providing 150mm dia PVC pipes for storm water and waste water disposal

Laying 150mm dia PVC pipe for storm & waste water

Providing 150mm dia SWP

Providing stop cock 20mm dia

Providing Galvanised Holder bats for 150mm dia pipes

Mandana stone flooring 25mm thick and above in any pattern as specified over 12mm thick base of cement coarse sand mortar 1:3 laid and jointed with neat cement slurry mixed with pigment to match thee shade of stone including rubbing and polishingasper specification attached

P/ fixing CI grid tiles 30mmx 300mm weighing 5kg in position as per required slope laid over 37mm cement concrete 1:1.5:3 with stone aggregate 12mm and down grade and holes filled with cement concretw 1:1.5:3 with 3mm down aggregate. The tiles fixed shall be han/Machine polished and holes and joints not properly filled should be redone. The entire top surface should be left smooth. No extra charges shall be paid for cutting of CI tiles. The area shall be kept wet for a minimum of 20 days. The tiles to be supplied as per the Pattern /sample approved.

Providing & Fixing of Powder coated Aluminium glazing/ windows in specified windows. The glazing to include Aluminium sections of size 2.25”x1.5”in frames & 1.5”x1.5” in shutters and 5mm thick glass of Saint Gobain/ Modifloat/ Asahi, all necessary hardware including Hinges, stays, bolts etc. The Aluminium section used to be of 12 gauge shell thickness.

Same as above but for doors and partitions as specified . The section of frame be 4"x1.75" and that of door shutter shall be 3"x1.5" and shell thickness of 12 gauge.

Heavy duty floor spring of Ozone/ dorma

Rebarring with Hilti grout 126mm dia 16mmdia

Extra for Mixing ISI marked integral water proofing compound (liquid) in conc as per manufacturer's specifications

Demolition of brick work

Scrapping of roof brick tiles

Demolition of concrete work (Base of Tanks)

Demolition of RCC

Removal of existing shed including removing brick work, RCC , steel columns etc falling in the new proposed construction as per requirement without disturbing the balance shed.