Development of Ichinda-Nitigotha Square transporting road (Balance portion-215m) from chainage 1.040 KM to 1/.255 KM at village Ichinda of G.I.O.M. in the district of Keonjhar (Under CSR Scheme)

Excavation,loading,unloding and carriage by mechanical means of all kinds of soil, including stoney earth, gravel and moorum etc interspread with boulders upto 1/2 cum size with all lifts and delifts including trimming of slopes and bed to design section and depositing the excavated materials away from work site as per the specifacation and by the Engineer -in-charge within an initial lead of 1 km from the place of excavation complete.

Loosening, leveling and Compacting original ground supporting embankment to facilitate placement of first layer of embankment, scarified to a depth of 150 mm, mixed with water at OMC and then compacted by rolling so as to achieve minimum dry density as given in Table 300-2 for embankment construction & clause 305 of MoRT&H specification for Road & Bridge (5th revision) as per direction of EIC.

Construction of embankment with approved materials obtained from borrow pits with all lifts and leads transporting to site, spreading, grading to required slope and compacting to meet required density etc complete as per Clause No.305 of specifications for Road and Bridge works of Ministry of Road Transport & Highways (5th Revision) & including cost of all materials, labour, T&P, taxes, royalty etc complete in all respect and as per direction of the Engineer-in-charge.

Construction of Granular Sub Base Grading II material as per table 400-1 spreading in uniform layers with moto grader on prepared surface, mixing by mix in place method with rotavator at OMC & compacting with vibrator roller to achieve the desired density complete as per clause 401 of Mo SRT&H specifications for Road & Bridge works (By mix in place method).

Construction of dry lean cement concrete sub-base over a prepared sub-grade with coarse and fine aggregate conforming to IS-383 the size of coarse aggregate not exceeding 25mm, aggregate cement ratio not to be exceeded 15:1, aggregate gradation after blending to be as per Table 600.1. cement content not to be less than 150kg/Cum. Optimum moisture content to be determined during trial length construction, contrete strength not to be less than 10Mpa at 7 days, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher placement to site, compaction with vibratory roller, finishing and curing etc completed with cost conveyance and of all materials Hire and running charges machineries and cost of all labour, T&P etc. completed as per the direction of EIC.

Construction of un-reinforced, dowel jointed (at expansion and construction joint only) plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement of M40 grade concrete with coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25mm, mixed in a concrete mixer of not less than 0.28/0.40cum capacity using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete the shovels rakes, compacted using needle, screed and plate vibrators and finished in continous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars near approaches to bridge/culvert and construction joints with admixtures and curing compound as directed by EIC. complete in all respect.

PCC M-20 grade concrete with 20mm & down graded hard crusher broken granite chips including hoisting and laying concrete, watering and curing for three weeks centering and shuttering and finishing the exposed surfaces smooth, providing beads or grooves where necessary including cost, conveyance, royalty of all material, dismantling the centering, shuttering work after the period as specified by the EIC and cost of all labour, T&P required for the work comp. in all respect, excluding cost of reinforcement, binding wires and labour charges for bending, binding and tying the grills.In Footing

Construction of embankment with approved materials deposited at site from road-way cutting and other structures with all lifts and leads graded and compacted to meet requirement as per approved drawing and technical specifications as per Section 900 and Clause 305 of MoRT&H Specification for Road & Bridge works (5th Revision) and as per direction of Engineer-in-Charge.

Earth work in excavation of foundation treaches in all kinds of soil including moorum, stoney earth and earth mixed with boulders ( except sheet rocks and boulders requiring for blasting) including dressing and levelling the bed up to the required depth and depositing the excavated materials at places away from the work site with all leads and lifts, T&P shoring and shuttering and dewatering if required etc. comp. as directed by EIC.(1.5m to 3.00 mtr depth)

Filling foundation and plinth with river sand, well watered, rammed including cost, conveyance, royalties of materials, cost of all labour and T&P required for the work etc. complete as per direction of EIC.

P.C.C .of prop.(1:3:6) in foundation using 40 mm. size crusher broken hard granite metal of approved quality from approved quarry including lowering, laying concrete to required levels laid in layers not exceeding 150mm thick including cost, conveyance, royalties of all materials, watering and curing and cost of all labour, T&P required for the work etc. compleete as per direction of EIC.

PCC M-15 grade concrete in foundation and plinth with 20mm & down graded hard crusher broken granite chips including lowering,laying concrete to required levels, watering and curing finishing the exposed surfaces smooth including cost, conveyance, royalities of all materials,cost of all labour,T & P required for the work etc.required to complete as per direction of EIC.(In retaining wall)

Providing Weep Holes in plain / reinforced concrete abutment, wing wall, retaining wall, toe wall with 110mm dia PVC pipe as per drawing and technical specifications and asper Clause-2706 of MORT&H Specifications for Road & Bride works (5th Revision) & including cost of all materials, labour, T&P, royalty etc complete in all respect and as per direction of the Engineer-in-charge.

Providing and laying of filter media with stone crushed aggregate of 40mm size satisfying the requirements laid down in clause 2504.2.2 of MORT&H specification to a thickness of not less than 600mm with smaller size towards the soil and bigger size towards the wall and provided to the entire surface behind abutment, wing wall, return wall to the full height compacted to a firm condition complete as per drawing and technical specification and as per direction of EIC.

Filling in foundation and plinth or floor with excavated earth or moorum or extra good earth including laying, watering and ramming in 23 Cm (9") thick layers with all necessary leads and lifts complete inclusive of all cost of labour T&P etc. complete as per direction of EIC.

Supplying and fixing of 150mm dia and 1.0 Mtr long of RCC M-15 guard post (Pre cast) of standard design as per IRC, fixing in position as per direction of EIC. (Below Ground 45Cm)

Painting two coats with appd. Brand of synthetic enamel paint cost, carriage and quality over a coat of primer to masonry works including cost of all materials cost of all labour and T&P, scaffolding etc required for the work etc. comp. (paints of Burger, Nerolac, J&N & Asian ICI Brand is to be used.)

Please Enable Macros to View BoQ information