GE I R AND D/CHD-33/2022-23

Amount

Demolition of brick / block masonry built in CM including all quoins, arches, pillars etc and clearing rubbish off the premises.

Demolition of cement concrete (unreinforced) in ground floors and paving n. exc 15 cm thickness below or above GL.

Demolition of reinforced cement concrete slabs etc in ground floor and paving n.exc 15 cm thick (below or above ground level)

Material and labour for PCC (1:4:8) type D2 using 40mm graded aggregate in sub base/ mass concrete.

Material and labour for brick work with subclass B bricks, straight or curved on plan exc 6m mean radius built in cement mortar (1:6) complete all as speecified and directed

All as per serial item no 5.00 above but except brick complete all as speecified and directed

Taking down cement plaster on brick walls including hacking out joints, hacking for key, scrubbing down with water.

Material and labour for Rendering 15 mm thick external using cement plaster in CM 1:4 on fair faces of brick/concrete work surfaces complete all as specified and directed.

Material and labour for for PCC (1:2:4) type B0 using 20 mm graded agg as in coping etc.including necessary form work

Material and labour in repair precast cement concrete type B-0 (1:2:4) using 12.5mm graded stone aggregate for Jallies 25mm thick set in cement mortar 1:4 including all moulding frame complete all as speecified and directed

Material and labour for for TMT bars 10mm dia and over cut to length bent to shape required, including cranking, bending hooking etc & binding with mild steel binding steel wire (annealed) not less than 0.9mm dia conforming to Fe-410-S or Fe-410-O complete all as speecified and directed

All as per serial item no 10.00 above but 8mm dia TMT bars

Dismantiling of existing chain link fencing of any mesh and size incl screw, nut & bolts etc complete all as specefied and direceted.

Dismantling structural steel work including , doors, gates but excluding framed truss etc.

Dismantling of wrought iron or MS work of any description

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion, embedded in concrete, brick work, masonry, and making good disturbed ground etc,

All as per serial item no 14.00 above but embedded in natural ground etc,

Dismantling of GI barbed wire fencings fixed in RCC/Steel fencing posts complete all as specified and directed.

Supply and fixing for mild steel iron posts and strut in fencing including cutting top to shape drilling holes notching for wire etc flat iron fillet and similar work including all necessary drilling, bolting or revalting etc confirming to Fe 410-S complete all as speecified and directed

Supply only for chain link fencing pitch of wires 50mm made of MS galvanised wire conforming to IS:2712-2003 (GI Wire conforming to IS:280-2006 having Zinc Coating as laid down in IS:4826 Hot Dipped Galvanised Coating on round steel wires or IS-12753 Electro Galvanised Coating on round wires having tensile strength within 400 to 500 MPa) of standaed rails staining bolts etc incl provn of binding with mild steel wire not less than 0.9mm dia complete all as speecified and directed

Fixing only new chain link fencing including line wires any mesh any size and to any type standards rails straining bolts etc including provision of binding wire complete all as speecified and directed

Supply and fixing for mild steel screw bolts(machine made)11 to 15mm dia withhexagonal or square heads at one end andscrewed the other, orscrewed both ends, eachscrewed end to be fittedwith washers and onehexagonal or squarenut, n exc 5cm long complete all as speecified and directed

Supply and fixing for Mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips Fe-410-W 432 (Gde.E-250) Part- I quality-A or Fe 290 (Gde -E-165

Material and labour for framed work as in doors or gates and framed grills made of ornamental purpose of angle, sq bars or other sections including plate, rails, braces withe ornamental and intricate etc complete drilled for fixing of steel seating including prepared for hanging sliding bolt, handle etc complete all as specified and directed.

Supply and fixing for GI 2 standed barbed wire2.24mm dia wire with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts including securing or tying at crossing with and provision of galvanised mild steel wire. staples or steel pins etc as directed (Each line wire to be measured) complete all as specified and directed.

All as per serial item no 22.00 above but except barbed wire

All as per serial item no 22.00 above but Restraining, resecuring including making good staples only.

Supply and fixing in repairs for concertina coil 2.64mm dia having a core wire high carbon spacing steel of high tensile strength as per grade of IS-4454 (Pt-I) with a low carbon steel strip punched tape 19mm wide, 0.5mm thick and series of knife edge sharp barbs/blades @ 25mm centre to centre punched all along the length on both the sides of strips at regular interval confirming to IS-513 complete all as specified and directed.

Excavation in post holes (or similar holes) each n exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance n exc 50 m and making good surface in soft/loose soil complete all as specified and directed.

Material and labour for PCC type B-1, 1:2:4 (20 mm graded aggregate) as in foundation, filling and mass-concrete and like filling in fencing post

Material and labour for reinforced cement concrete type B-1, 1:2:4 (20 mm graded aggregate) In precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area in exc 100 sq. cm but n exc 250Sqcm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed.

Material and labour for two coats of cement base paint over a coat of primer on newly plastered surfaces of walls including preparation of surfaces

Material and labour for preparation of new untreated surfaces of steel of any description n exc 10cm width or girth not other wise described and applying two coats of synthetic enamel paint over one coat of red oxide primer. complete all as specified and directed.

Material and labour for providing 100 mm thick PCC 1:2:4 Type B-1 (using 20 mm graded stone aggregate) as in flooring including finishing the cement concrete surface even and smooth with using extra cement complete all as specified and directed.

Dismantling floor hearth or wall tilling including cement mortar bedding (but not backaing coat) removing serviceable tiles to store & rubbish off the premises.

Machine pressed precast conctete interlocking coloured paver block supply and fixing in repair any shape and size confirming to IS 15658-2006 of 80 mm thickness, M-35 Grade laid over a layer of fine river sand, watering and consolidating complete . (Note: Sand will be measured paid for seperately under respective item supplied only).

Supply only river bed fine sand for screed bed min 50mm thick for paving flooring

Material and labour for PCC coloured chequered tiles with grey cement and pigment 25cm X 25cm X 25mm thick set & jointed in neat cement slurry as in path, pavement ,floors, etc. over 20mm thick screeding of CM 1:6 complete all as specified and directed.

Material and labour for for filleting work in CM 1:4 not exc 25 Sqcm

Material and labour for providing, pre cast cement concrete as in kerb stones rounded or chamfered on edges type B1 1:2:4 using 20mm graded aggregate including necessary formworks & moulds and set in cement mortar 1:4 complete all as specified and directed.

Material and labour for preparation of new concrete surfaces of any description, over 10cm width or girth and applying two coats of synthetic enamel paint complete all as specified and directed.

Removing of vegetation growth, bushed including taking out from fencings etc. and removing the rubbish n exc. 50 m complete all as specified and directed.

shree balaji builders

KUKREJA ENGINEERS

M/s Krishan Aggarwal

SONA BUILDERS

M/s APEX ENTERPRISES

GOODWILL ENGINEERS

JOGINDER NATH GUPTA AND SONS