RM of LWSS Baleer Dainkwan Gujjer Nallah Phase-3rd in Tehsil Indora

Supply of submersible pumping set of Kirloskar/Kilburn/Clama/Crompton/KSB make conforming to BIS; 8034-1976 latest suitable for lifting clean water (latest with uptodate ammendments) fitted with bronze impellers/suitable alloy directly coupled to squirrell case electric induction motor of same make as (manufacturer standard) conforming to BIS; 9283-1979 (latest with uptodate ammendments) and totally water proof for submersible duty, isolated from the pump by intermediate casing with double mechanical seal in oil chamber, grease packed lubricated bearings & provided with stainless steel thrust bearing plate to with stand vertical loads with minimum wear & tear. It should also be fitted with a device to take up expansion of water with the heating of motor including water level guard,errection clamps,cable clips & depth gauge etc. The pump shall be suitable for operation on data given below:-

i) Total Head 62.50 Mtrs

ii ) Discharge required from each pump. 6.5 LPS

iii) No. of pump required 1.00 Nos.

iv) Location of the site of installation of machinery. The site is located at a distance of 27 KM from Pathankot (chakki) Railway station by road & 0.100 KM on head load (for the installation of both machineries.

v) The Altitude of installation. The altitude of place is 310.00 mtrs. Above MSL

vi) Type of current. AC Three phase supply with

vii) Rate Voltage 415+ 10%

viii) Type of water and its source Tubewell Dainkwan

ix) Charactristics of water. -

a)Ambient Temperature dig.c 20 dig. C

b)Turbidity NTU 113NTU

c)Hardness260Mg/Ltrs(as CaCO3) 540 Mg/ltr

d) PH 6.5 to 8.5

e) TDS 540 PPM

f)Other -

x) Depth ofTUbe Well 90 mtrs

xi) LWL in Tube Well 45 mtr

xii) Center line level of Pump 45 mtrs.

xiii) Discharge level of highest point 120 mtrs.

xiv) Total head in Mtrs 62.50 mtrs.

xv) Length of R/Main 1250 mtrs.

xvi) Dia of Rising main 100 mm dia GI pipe 4.80 mm thick (MC)

xvii) No of working hours per day 20 Hours

xviii) Limit of pump operation. (-) 15 % (+) 10% of total head

xix) R.P.M. of pumping set. 2900 RPM

xx) Test run. 8 Hours continueously for 7 days