Improvement and extension of various LWSS in Fatehpur area in Tehsil Fatehpur construction of LWSS Gubber Moukhar Hoshiana Phase 1

Amount

Excavation in foundation trenches etc.for earth work in all classification of soil such as;spade,pick,jumper,blasting work,soft/hard rock etc.upto all depth stacking the excavated soil within all leads and lifts clear from the edge of excavation and then returning the stacked soil in 15cm.layers when required into plinth sides of foundation etc.consolidating each depo sited layers by ramming,watering and then disposing of all surplus excavated earth.

Providing and laying cement concrete 1:6:12(One Cement:Six Sand:Twelve graded stone aggregate 40mm.nominal size) and curing complete excluding the cost of form work in foundation and plinth.

R.R. masonery/polygonal rubble masonery (uncoursed/brought to course)with hard stones of approved quality in foundation and plinth including level-ing up with cement concrete 1 :6:12 ( 1 cement :6 graded stone agg. 20mm nominal size) at plinth level in cement mortor 1:6 ( 1cement :6sand)

Providing form work with steel plates 3.15mm.thick welded with angle iron frame 30x30x5mm.so as to be give a fair finish including centring,shuttering, strutt-ing and propping etc.with wooden battens and ballies height of propping and centring below supporting floor to ceiling exceeding upto any height and removal of the same for in-situ-reinforced concrete and plain concrete work in:-

Foundation and footing of column

In flat surfaces such as; soffits of suspended floor,roofs,landings and the like floor etc.upto 200mm.thickness.

Slopping or battering surfaces including folded plates where inclination to horizontal plane does not exceeding 30cm.

Beam, cantilever, girders and lintles.

Vertical surface

In stair case beam

In column Pillars Posts etc.

Ordinary timber Planking

Providing and laying cement concrete 1:2:4(One cement:Two Sand:Four graded stone aggregate 20mm.nominal size) and curing complete exclud-ing the cost of form work and reinforcement for reinforced concrete work in-In suspended floor,roof,landing and shelves and their supports,balconies beams,girders,bresssumers and cantilevers etc.

In suspended floors

Beams etc.

Foundation and footing and bases of column etc.

In stair cases

Ist.Class brick work using common burnt clay building bricks in super structure above plinth level upto floor two level in C.M.1 :6(1Cement:6 Sand)

Half brick masonery in column burent clay building bricks in cement mortor 1:4 (1cement :4sand) 1st class bricks.

Providing and fixing pressed steel doors frames manufactured from commer-cial mild steel sheet 0f 1.25mm thickness including hings jump lock jemb beed and if required angles threshold of mild steel angle of section 50x25mm or base ties of 1.25mm pressed mild steel welded or ridgly fixed together by mechanical means adjustable lugs with split and tails to each jemb including steel but things 2.5mm with guard lock strike plate and shock as specified and applying a coat of approved steel primer after pretreatment of the surface as directed by the Engineer-in-Charge.

Profile-'A'.

Providing and fixing of panelled glazed or panelled glazed shutters for door windows and clearstory windows including finished/black enamelled iron butt hinges with necessary screws ( a ). 2nd.Class deodar wood.

Providing and fixing M.S.grills of required pattern in wooden frames of windows etc.with M.S.Flat square or round bars with rammed headed bolts and nuts or by screws plain grill.

Providing and fixing Mild steel tower bolts (barrel type ) with necessasery Screw etc. complete 200x10mm.

Providing and fixing M.S. handles with necessary screws complete 100mm.

Providing and fixing M.S.sliding door bolts bright finished or/and black ena-melled with nuts and screws etc.complete 250mmx16mm.

Providing and fixing M.S.hooks and eyes 150mm.

Supply and fixing glass panes with putty and nails including removal of bro-ken glass pones wherever necessary (Plain glass 4mm.thick).

6mm.thick cement plaster in ceiling in cement mortar 1:3(1 Cement:3 Sand).

15mm.thick cement plaster in single coat on fair side on brick/concrete/stone walls for interior plastering upto floor two level including arrises,internal roun-ded angles,chamfers and/or rounded angles not exceeding 80mm.in girth in girth and finished even and smooth in cement mortar 1:6(1 Cement:6 Sand).

20mm.thick cement plaster in single coat backing coat 10mm.and finishing coat 10mm.thick on fair side of bricks/stone masonry walls for interior plastering upto floor two level including internal rounded angles,chamfers and or rounded angles not exceeding 80mm.in girth and finished even and smooth in cement mortar 1:6(One Cement:Six Sand).

Pointing on brick work with cement mortar 1:3 (1 cement :3 Sand) raised and cut pionting.

Precast terrazzo tiles 20mm.thick9with marbl,e chips of specified sizes) fixed on wall on 10mm.thick cement plaster 1:3(1 Cement:3 Sand) jointed with neat cement slurry mixed with pigment to match the shade of tiles(wherever requi-ed ) including rubbing and plishing complete with tiles of following shades

Providing and laying brick tiles over mumty roots grouted with cement mortar 1:3(1 Cement:3 Sand) over a 12mm layer of cement mortar 1:3(1 Cement:3 Sand) and finished neat.

Providing and fixing on wall face C.I.rain water pipes including fitting the joints with spun yarn and cement 1:2(1 Cement:2 Sand) 100mm.dia.

Providing and fixing M.S.holder bat clamps of approved design to C.I.or SCI pipes embedded in and including cement concrete blocks 10x10x10cm.of 1:2:4 mix.(1 Cement:2 Sand:4 graded stone aggregate 20mm.nominal size) and cost of cutting holes and mixing good the wall etc.100mm.diameter for C.I.Pipe.

Providing plinth protection 50mm.thick in cement concrete 1:3:6(One Cement:Three Sand:Six graded stone aggregate 20mm.nominal size)and including finishing the top surface of concrete smooth.

White washing with lime on undecorated wall surface(Two coats) to give an even shade including throughly brooming the surface to remove all dirt, dust and other foreign matter.

Distempering with dry distemper of approved brand and manufacture (Two coat and of required shade on undecorated wall surface to given an even shade over and including primer coat of whiting after thoroughly brushing the surface free from mortor dropping and other foreign matter including preparing the surface even and sand papered smoth.

Hirmachi Colour wash on undecorated wall surfaces(two Coat) to give an shade including throughly brooming the surface to remove all dirt, dust, mortar drops and other foreign matter.

Cement washing with port-land cement slurry on undecorated wall surfaces (One coat) to give a smooth bodied opaque finish including thoroughly broom- ing the surface to remove all dirt,dust mortar drops and other foreigh matter.

Applying priming coat over new steel and other metal surface after and in-cluding preparing the surface by throughly cleaning oil,dirt and other foreign matter and coursed with wire brushing fine steel wool scrapers and sand paper complete with ready mixed paint brushing red lead red oxide/Zinc oxide chrome.

Painting two coats(exclluding priming coat on new steel other metal surface with enamel paint brushing into give an even shade including cleaning the surface of all dirt,dust and other foreign matter enamel paint other than white

Applying priming coat over new wood and wood based surfaces after and including preparing the surfaces by throughly cleaning oil,grease,dirt and other forein matter and papering and knotting ready mixed paint brushing wood primer pink.

Painting two coats(excluding priming coat) over new wood and wood based surfaces with enamelled paint to give an even shade including cleaning the surfaces of all dirt,dust (a) with enamel paint other than white.

Providing tor steel reinforcement for RCC.work including bending,binding and placing in position complete upto any floor level.

Providing and fixing M.S.fan clamp 16mm.dia M.S.bar bent to 'U' shape. with hooked ends in R.C.C. slab during laying including painting the exposed of loop all as per standared design complete.

Providing and laying cement concrete 1:3:6 (1 cement : 3 sand : 6 Graded stone agreegate 40 mm nominal size ) and curing complete excluding the cost of formwork ,Complete in foundation and plinth

Providing & laying cement concrete1:1.5:3 (1cement :1.5 sand : 3 graded stone aggregate 20 mm nominal size) & curing complete excluding the cost of form work & reinforcement for reinforced concrete work in :-

(i) Columns,pillars posts and struts upto any floor level.

(ii) Lintle beam,girders bressumers and cantilevers upto any floor level.

(iii) In suspended floor roof landings and shelves and their supports balconies,beam,girders, bressumers and cantilevers.

(iv)In Arches(dome etc.) upto any spain.

(v) In wall(any thickness but not less than 0.10metre) including attached pillaster-ing buttresses plinth and string courses etc.from top of foundation level uptoany floor level.

Steel work welded in built up section,trusses and framed work including cutting,hoisting,fixing in position and applying a priming coat of red lead paint in gratings,framed guard bar,ladders,railings,brackets and similar work complete in all respects within all leads and lifts as per direction and complete satisfaction of engineer in charge.

Providing and fixing cast iron man hole cover 500mm.internal diametresincluding frame weight 116Kgs.(The weight of frame 58Kgs.and cover weight 58Kgs.)

Providing,jointing and fixing of G.I.Pipe(M) Class welding of M.S.flanges Table-5 including the cost of nuts,bolts,ferrado make gaskets 4mm.thick complete in all respect of following dias-

inlet pipe 125 mm dia

outlet pipe 125 mm dia

scour pipe 125 mm dia

overflow pipe 125 mm dia

inlet pipe 80 mm dia

outlet pipe 80 mm dia

scour pipe 80 mm dia

overflow pipe 80 mm dia

inlet pipe 50 mm dia

outlet pipe 50 mm dia

scour pipe 50 mm dia

overflow pipe 50 mm dia

Providing,manufacturing and fixing of G.I.Pipe bend(Medium class)to different degrees including welding of M.S.flange Table-5 at both the ends of bend including the cost of nuts and bolts but excluding the cost of pipes.

inlet pipe 125 mm dia

outlet pipe 125 mm dia

scour pipe 125 mm dia

overflow pipe 125 mm dia

inlet pipe 80 mm dia

outlet pipe 80 mm dia

scour pipe 80 mm dia

overflow pipe 80 mm dia

inlet pipe 50 mm dia

outlet pipe 50 mm dia

scour pipe 50 mm dia

overflow pipe 50 mm dia

Providing and fixing cast iron Sluice Valves of different dias with hand wheel complete in all respect.

i)outlet pipe 125 mm dia

ii)scour pipe 125 mm dia

iii) For Outlet 80 mm.nominal bore

iv) For scour line- 80 mm.nominal bore

v) For Outlet 50 mm.nominal bore

vi) For scour line 50 mm.nominal bore

Providing and fixing of M.S.Mosquito proofing ventilators 300mmx300mmx300mm.height.

Providing and fixing of lightening conductors.

Finishing wall with water proofing cement paint of approved brand and manufacturer and of required shade on undecorated wall surfaces (two coats) to give an even shade after thoroughly brushing the surface to remove all dirt, dust and remains of loose powders material within all leads and lifts as per the direction of Engineer-in-charge.

Providing and fixing of M.S.Water Indicator gauge.

Applying priming coat over new steel and other metal surface after and in-cluding preparing the surface by throughly cleaning oil,dirt and other foreign matter and coursed with wire brushing fine steel wool scrapers and sand paper complete with ready mixed paint brushing red lead red oxide/Zinc oxide chrome at steel ladder, railing, GI pipes, Flanges.

Painting two coats(exclluding priming coat on new steel other metal surface with enamel paint brushing into give an even shade including cleaning the surface of all dirt,dust and other foreign matter enamel paint other than white at GI pipes Flanges, Railings Steel Ladders

Provision for structural design and drawing.

Provision for bearing capacity test.

RATTAN LAL

Sarabjit Singh Katoch