Loading…
Loading…
Tender Value
₹18.7 L
EMD Value
₹37,430
Closing Date
28 Aug 2023, 5:00 pmClosed
GENERAL MANAGER
AMMUNITION FACTORY KHADKI, PUNE
Repair/Renovation of bldg. no. 316 including front and Back verandah and AC shed at F4 section inside factory at AFK.
2023_MIL_162159_1
GM/AFK/EO/DC/1003/2023-24
Open Tender
Civil Works
Item Rate
90 days
AMMUNITION FACTORY KHADKI
Please refer Tender documents.
5 documents required · 5 mandatory
₹0
₹37,430
8 Sept 2023
25 Jul 2023
30 Aug 2023
25 Jul 2023
28 Aug 2023
25 Jul 2023
Amount
Dismantling existing damaged Asbestos cement (corrugated, semi corrugated) sheets in roof covering and cladding.
Dismantling structural steel work including doors, gates/ rolling shutters but excluding framed truss etc.
Taking down cement or cement lime plaster on brick or stone walls etc including raking out joints, hacking for kay, scrubbing down with water etc.
Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thickness (below or above ground level).
M&L for providing cement concrete type I (M-15) 1:2:4 mix (20mm graded aggregate) in foundations, filling and mass concrete fair finished.with necessary centering
M&L for screed bed or bedding layer of mortar 15mm thick for laying floor finishes in CM 1:4
M&L for Jhonson endura tiles 600mm x 600m x 15mm thick with fixing using neat cement slurry and chemical and joint filling with approved sealent make -latticrete, saint globain, roff etc. Thickness of joint 3mm to 4mm with spacers
M&L providing precast cement concrete type C1, 1:3:6 (20mm graded aggregate) in block masonry with solid blocks, exc 10cm width and setting in cement mortar 1:6, complete
M&L for rendering 15mm thick on fair faces of brick or concrete surfaces of walls in CM 1:4 including finishing even and smooth/ rough without using extra cement as directed.
S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/ cladding to wall, fixed with self tappinf screws as specified Make - TATA/JSW/ESSAR
M&L for providing formwork to faces of concrete Walls, retaining walls, abutments, parapets and starcase railing and similar work including attached pillasters and Buttresses etc vertical or to batter rough finished surface of concrete flat.
M&L for providing Reinforced Cement Concrete type B1 1:2:4 (20mm graded aggregate) in Foundation, including rafts, footing, foundation beams, plinth beams; bases for columns, etc basement slabs, under reamed piles and mass concrete etc complete.
M&L for providing precast cement concrete type B1, 1:2:4 (20mm graded aggregate) in drain cover slab and similar articles etc. set in cement mortar 1:6.
M&L for deformed or twisted bars 10mm Dai and over, cut to length bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9mm dia or securing with clips.
M&L for preparing plastered or unplastered old surfaces and applying two coats of white washing on ceiling/ AC sheet.
M&L for preparing brick, stone, concrete, asbestos cement or plastered old painted surfaces of any description over 10cm girth or width, not otherwise described and applying two coats of synthetic enamel paint on walls/ ceiling
M&L for preparing old painted surfaces of any description, not otherwise described, over 10cm width or girth and applying two coats of synthetic enamel paint on wood or wood based surfaces.
M&L for preparing old painted surfaces of any description, not otherwise described, over 10cm width or girth and applying two coats of synthetic enamel paint over steel and iron surfaces.
M&L for preparing plastered or unplastered old surfaces and applying two coats of cement paint on walls.
Removing excavated material (soils) exc. 1.50 km but n exc. 5 km and depositing where directed
V C SHETH
stage.html
html • 0.04 MB
tech_eval.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .