Annual Plan-Omalloor GP 298/2024-25-Construction of Mini MCF in various wards Of Omalloor GP

Amount

Mini MCF

2.8.1:Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

10.1:Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

OD250170/2024-2025:Providing and fixing Aluminium powder coated profile sheet ( size, shape and pitch of corrugation as approved by engineer incharge) 0.40 mm ( + 0.05%) . Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 m as directed by Engineer incharge. The sheet shall be fixed using self drilling/ self tapping screws of size ( 5.5 x 55 mm ) with EPDM seal complete up to any pitch in horizontal/vertical or curved surfaces excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required

OD250171/2024-2025:Providing and fixing aluminium sheet roofing accessories 0.40mm (+0.05%) and polyester top coat 15 - 18 microns using self drilling/ self tapping screws complete Ridge plain (500 - 600 mm)

13.52.1:Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer's specifications including appropriate priming coat, preparation of surface, etc. complete.On steel work

OD303700/2024-2025:Steel fabricated name board 90 cm x 60 cm.Providing and fixing informative name board written over GI sheeting 0.80 mm supported with 32 mm dia GI pipe section firmly fixed to the ground by means of foundation with M10 grade cement concrete 250 mm x 250 mm x250 mm below ground level including painting with approved paint and including the cost of lettering as per drawings.

VG JAYAN (BID ID -2118641)

Bidder Name

PRASAD.K.V

VG JAYAN