22/PHandS/PM/2025-26 SL 13

Filling in foundation or plinth by silver sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. (payment to be made on measurement of finished quantity)

Brick work with 1st class bricks in cement mortar (4:1) In Foundation & plinth.

125 mm thick brick work with 1st class bricks in cement mortar (1:4) in ground floor..

Plaster (to wall, floor, celling etc.) with sand and cement morter including rounding off or chamfering corners as directed and raking out joints or roughening of concrete surface including throating nosing and drip course where necessary a) 15mm thick plaster With 4:1 Cement morter

Neat cement punning about 1.5 mm thick in wall , dado window, sills, floor, drain etc.

Ordinary cement concrete ( Mix 3:1:5:1) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any in ground floor as per relevant IS codes. (i) Pakur Variety

Hire and labour charges for shuttering with centering and necessary staging up to 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slubs,beams,columms lintels curved or straight including fitting fixing and striking out after completion of works (upo to roof of ground floor). (a) 25mm to 30mm thick wooden shuttering as per direction & decision of the E.I.C.

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups binders etc including supply of roods, initial straightening and removal of loose rust (if necessary),cutting to requisite length,hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction.(a) for works in foundation, basement and up to roof of ground floor/upto 4m. (i) Tor steel/Mild Steel.

Supplying & laying in the specified pattern of interlocking concrete block Pavements (ICBP) with concrete blocks(with concrete grade as specified as per Table 1 of IS 15658:2006) manufactured in steel mould clamped to a vibrating table by hydraulic pressure (as per cl.No. 6.30 of IRC:SP:63(2018), from BIS licensee manufacturer, with spacer nib(small protruding profiles on the vertical face of a paver block used as device for keeping minimum joint gap inbetween paving blocks, as per CL no.- 3.26 of IS: 15658) and of specified size and shape with aspect ratio (the ratio of length to the thickness of a paver block, as per CI. No. 3.3 of IS: 15658) as per table -2 of IS:15658 with flectural strength/breaking load as per anexture G of IS: 15658, on the prepared base course of specified CBR as per table 1 of IRC Sp 63(2018) or else as mentioned in design and drawing with cushion of compacted bedding sand of 25-35 mm thick (grading the bedding sand as per clause 6.5.1 of IRC SP -63)and filling up the gaps in between paver blocks with joint filling sand (the grading of the joint filling sand will be as per clause 6.5.2 of IRC SP-63 and completing the edges with cut blocks as per CI. No. 8.7 of IRCSP-63(2018) with proper confinement of bedding and joint filling sand, compaction, levelling and filling up of edge gap. 80mm thick. Grey.

GST@18% on S(mailto:GST@18%25%20on%20S塹ᴻ䡿ⲯ嶂藄挧ꮥ)

Add L Cess @1% on Total from Sl No 1 to 10

Please Enable Macros to View BoQ information