Preparation of In-house Fabrication work of various steel materials for use of Nadiad(R) division at Nadiad(R) Division Store Campus

SCHEDULE-B.TENDER NOTICE NO.: NDR/FABRICATION/2026-27/15

SR. E-URJA item DESCRIPTION UNIT RATE AS

NO. CODE NO PER COST

1 3611000016 9FT TOP ANGLE - MS ANGLE TOP FAB No

2 2609000005 ANGLE BRACING 2FT 6INCH - M.S. No

ANGLE CROSS ARM FAB 750 MM. 2 FT 6 INCH

3 2609000011 ANGLE BRACING 4FT 6INCH - MS No

ANGLES CROSS ARM FABRICATED 1200MM-4

4 3611000029 MS ANGLE FABRICATED 50X50 MM FOR No

CROSS BRACING 11K

5 2609000004 SIDE ANGLE 2FT - MS ANGLES CROSS No

ARM FABRICATED 600 MM-2 FT

6 3611000018 SIDE ANGLE 2FT - MS ANGLES CROSS No

ARM FABRICATED 600 MM-2 FT

7 2609000029 GUARDING ANGLE CROSS ARMS FOR No

8 2609000044 TAPPING CHANNEL 5FT - MS CHANNEL No

CROSS ARM FAB STRAIGHT

9 2614000002 ANCHOR RODS No

10 2614000009 TURN BUCKLE MS 16MM No

11 2614000012 EYE BOLT WITH NUT No

12 2601000094 TOP CLAMP FITTING FOR PSC POLE No

13 2601000040 C CLAMP FOR LT SHACKLE No

14 2601000049 SIDE CLAMP PSC- C CLAMP FOR PSC No

15 2601000061 SIDE CLAMP RSJ - C CLAMP FOR No

116X100MM GIRDER POLES - SIDE

16 2601000052 SIDE CLAMP FOR PSC POLE-G I No

17 2601000069 STAY CLAMP FOR PSC POLES Pair

18 2601000071 STAY CLAMP FOR 116 X 100 MM Pair

19 2601000150 STAY CLAMP FOR HT AB CABLE PSC Pair

20 2601000151 STAY CLAMP FOR HT AB CABLE RSJ Pair

SAVE ENERGY FOR BENEFIT OF SELF AND NATION”

MADHYA GUJARAT VIJ COMPANY LIMITED

Regd.& Corporate Office: Sardar Patel Vidyut Bhavan, Race Course, Vadodara-

NADIAD O&M DIVISION OFFICE

OPP: 132 KV SUB STATION, P.O: DABHAN – 387 320, TAL: NADIAD

Tel. No. 0268 – 2581836 E-Mail: [email protected]

CIN NO: U40102GJ2003SGC042907

21 2010000066 EYE HOOKS No

22 2609000034 11 KV V CROSS ARM - MS ANGLE Pair

23 2609000048 11KV EXTENSION V CROSS ARM No

24 2609000080 EXTENTION OF RSJ POLE100 X116 No

FROM 9 MTR TO 11 MTR.

25 2609000081 EXTENTION OF RSJ POLE 100X116 No

FROM 9 MTR TO 13 MTR.

26 2613000002 THREE HOLE PATTI No

27 3611000006 MS CHANNEL BOTM FAB FOR TRANS No

TOTAL ESTIMATED VALUE

Total Tender Amt.(Incl.GST) 29,58,047.60*

The rates are asked above only on percentage basis against estimated amount i.e. item wise

rates stated in the Schedule-B. The tender offer must be specifying the percentage either above

or, below to the estimated amount and it should be clearly specified both in figures and words.

Note- The Quantum of work (quantity) will be given as per requirement.

 Rate of item are consider as per cost data 2024-25

 Labour charges for fabrication of HT/LT line & T/C items from various sizes

of MS Angles / Channels / Flats / Round bar , G.I.Wire no 8 swg etc. As per

our requirement and as per sample and specification with two coat of red

oxide including cost of red oxide, loading, unloading stacking of all

fabricated item inside store yard.

 Above said items are in variable quantity but order value is not more than

 1% scrap allowed to fabricator IN MS ITEM, No Scrap Allowane Will be given

 All fabrication item and Earthing coil should be prepared in house and

necessary energy bill paid by contractor.

 All Rates are excluding of GST.

Seal & Sign of Executive Engineer

Contractor with Rubber Stamp MGVCL, Nadiad O&M Division