R/o Bath room near Samshanghat in Ward No. 3

6.30 Brick work with common burnt clay machine moulded perforated F.P.S. (non modular) bricks of class designation 12.5 conforming IS : 2222 in exposed brick work including making horizontal and vertical grooves 10mm wide 12 mm deep complete in cement mortar 1:6 (1 cement : 6 coarse sand). 6.30.1 From ground level upto plinth level including all lead and lift and other incidental charges complete

Providing and fixing 15 cm wide, 45 cm overall semi- circular plain G.S. sheet gutter with iron brackets 40x3mm size, bolts, nuts and washers etc., including making necessary connections with rain water pipes complete. 12.7.2 0.63 mm thick with zinc coating not less than 275 gm/m² including all lead and lift and other incidental charges complete

Providing 6 mm cement plaster 1:3 (1 cement : 3 fine sand) in ceiling including all lead and lift and other incidental charges complete

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. including all lead and lift and other incidental charges complete

Providing and laying Ceramic glazed floor tiles of size 300x300 mm thickness to be specified by the manufacturer) of 1st quality conforming to IS : 15622 of approved make in colours such as White, Ivory, Grey, Fume Red Brown, laid on 20 mm thick cement mortar1:4 (1 Cement : 4 Coarse sand), Jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete. including all lead and lift and other incidental charges complete

Providing and fixing 16 gauge aluminium work with vakelite sheet glazing for doors, windows, ventilators Shutters with frame with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing / paneling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in charge including taking out old wooden size 0.75x1.80 including all lead and lift and other incidental charges complete