Loading…
Loading…
Eligibility, documents, scope, Go/No-Go checksEligibility, required documents, scope of work and Go/No-Go checks for this tender, in one click.
Tender Value
₹12.0 Cr
EMD Value
₹23.9 L
Closing Date
30 Oct 2026, 11:30 am
Eligibility, documents, scope, Go/No-Go checksEligibility, required documents, scope of work and Go/No-Go checks for this tender, in one click.
Yes (up to 3 members)
No
Two Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
90 days
Expenditure
Capital (RSP)
Above/Below/Par
SNT PROJEC
14 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less, where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-I, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
(a)The tenderer must have successfully completed or substantially completed any of the following (by any Government organizations) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited. Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or Two similar works costing not less than the amount equal to 40% of advertised value of the tender, or One similar work costing not less than the amount equal to 60% of advertised value of the tender.
Defination of Similar Work :- • Any signaling work of PI or RRI or EI or ABS or IBS/IBH involving indoor work.OR• Any work of alteration in PI or RRI or EI or ABS or IBS/IBH.Note 1: Tenderer may be required to submit the schedule of those works, Completion/Performance Certificates of which have been submitted by him/her in support of 30 /40 / 60% (as the case may be) criterion of similar nature of work.Note 2: The tenderer should be OEM or have an MOU with OEM (OEM of the EI in which alteration is to be done). Tenderer will have to submit the proof of the same with the tender document.
17 conditions · 9 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Upload filled & signed Annexure-D:"Declaration regarding constitution of firm".(Copy attached with Vol-I of tender document)
Upload filled and signed Annexure-M:"Mandatory Certificate to be submitted by tenderer alongwith the tender documents.". (Copy attached with Vol-I of tender document).
Upload filled & Signed Annexure-H: Work in Hand - in support of Bid Capacity (Mandatorily for tender value more than Rs.20 crore) (copy of format available in Vol-I of Tender Document).
Upload filled and signed Annexure-I:Detail of Contractual Payment received in previous three financial years and the current financial year.(Copy of format available in Vol-I of tender document)
Upload filled & signed Annexure-J:Real Time Gross Saving (RTGS)/National Electronic Fund Transfer(NEFT) Model Mandate Form (copy of format available in Vol-I of tender document)
Upload filled & signed Annexure-L: Completion Certificate(copy of format available in Vol-I of tender document)
Upload filled & signed Annexure-N: Contractual payment received in last three years - in support of Bid Capacity (Mandatorily for tender value more than Rs. 20 crore).(Copy of format available under Vol-I of tender document)
Upload filled & signed Annexure-Q: Mandatory undertaking Regarding Employment/ Partnership of Retired Railway Employees.(copy of format available in Vol-I of tender document).
Upload filled & signed Annexure K-3 & K-4: If tender submitted on behalf of Partnership Firm, relevant Annexures K-3 and K-4 as Declaration to be submitted by the tenderer alongwith tender document.
Upload filled & signed Annexure-C:Declaration form regarding site etc.(Format attached with Vol-I of tender document)
Upload filled and signed Annexure-E: List of plant and Machinery.(Copy attached with Vol-I of tender document)
Upload filled and signed Annexure-F: List of Engineers/Personnel (Copy attached with Vol-I of tender document).
Upload filled & Signed Annexure-G:Statement of work executed/completed during last 7 years ending last day of the month previous to the one in which tender is invited (Format available in Vol-I of tender document).
Upload filled and signed Annexure-I: Detail of Annual Contractual Turnover Data for previous 3/4 Years (Copy of format available in Vol-I of tender document)
Upload filled & signed Annexure-L: Completion Certificate(copy of format available in Vol-I of tender document)
Upload filled & signed Annexure-AB: STATEMENT OF DEVIATIONS.(copy of format available in Vol-I of tender document)
S&T work for Interlocking of 27 Nos Non-Interlocked LC gates having TVU >20000 and < 50000 over Firozpur Division.List of LC-Gates:- JRC-HSX Section 6 LC Gates(C-2,C-11,C-25, C-34 , C-41,C-49).JUC-FZR 11 LC Gates (C-6, C-19, C-20, C-24, C-57, C-80, C-88, C-90, C-98, C-118, C-129). PHR-LNX 4 LC Gates (C-7, C-13, C-20, C-22). FZP-FKA 3 LC Gates (C-13, C-54, C-58), BTI-FZR Section 1 LC Gate (C-33). KKP-FKA 1 LC Gate (B2-32), FZR-FZP 1 LC Gate (C-59).
02-SnT-PROJ-UMB-2026-27~NR
02-SnT-PROJ-UMB-2026-27
Open
Works - General
12 Months
Unknown (Unspecified Location)
₹0
₹23.9 L
6 Oct 2026
6 Oct 2026
16 Oct 2026
126 items across 4 schedules
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 2,82,94,989.69 | ||
| Design and preparation of wiring diagram for Level-Xing MACLS on the basis of approved interlocking plan,typical circuit diagram and as per Railway practice and latest rules prescribed by the Railway and obtaining approval of the competent authority. Designing , preparation of locking table, selection table, circuit diagram,contact analysis chart, relay rack chart etc, preparation of operating & indication panel Domino type diagram, (circuit shall be designed by the contractor with the use of Q series relays on the basis of approved signal Interlocking plan and obtaining approval of Competent Authority). The operating & indication panel may have addition & alteration to an extent of 5% variation in number of Domino. Designing should be as per Railway specifications and as per latest rules prescribed by Rly. This also includes preparation of cable route plan,Cable core chart,Station working rule diagram,Power supply arrangement,Cable termination chart in relay room and location boxes,Location wiring plan,Cable insulation chart,Fuse analysis,Indoor circuit diagram,Track circuit jumper plan,Terminal and Contact analysis chart,Outdoor circuits and other outdoor diagrams and obtaining approval of the engineer as per following :-Supply of 6 copies of complete set of superior quality paper including one set laminated,properly bound in file with cushioned cover. Software backup of complete set in the form of CD (2 Nos.) One complete set of tracings Design through CAD. Drawings in A-3 size & plan in bigger size papers. (six sets). (Inspection: JE/SSE/P/D&D). | — | — | — | 10,74,529.53 | |
| Modification /Alteration/Augmentation of existing Electronic Interlocking (EI) System as per RDSO/SPN/192/2019 Ver.2.0 or latest (with latest amendment), as per approved Signaling planand selection table/locking table of stations in connection with signalling work at station of FZR division as per requirement, technical specifications & conditions of contract. This includes- 1) Design & drawing of Indoor circuit diagram. 2) Modification to the existing Application Software of VDU & MT. 3) Modification to the existing interface & Interlocking circuit for stations. 4) Alteration to the existing Relay Rack wiring as per the modified interface circuit for Stations. 5) Modification to the existing CCIP at stations. 6) Upgradation of Datalogger Data base.7) Necessary modification in existing PI/RRI Panel.8) Supply of additional EI Hardware modules/cards for doing the alteration at above mentioned stations.9) FAT and SAT as per the modified and approved Application logic. 10)Installation, wiring,programming, testing & commissioning of complete yard for data input & configuration,simulation & functional testing, diagnostic & trouble shooting and commissioning of Electronic interlocking System as per Signal Interlocking plan.Installation is to be done as per RDSO specification no. RDSO/SPN/192/2019Ver. 2.0 or latest and RDSO practice circulated vide TAN no.STS/E/TAN/3012 Ver. 2.0Dt.10.08.2016 or latest,TAN no. STS/E/TAN/3007Ver. 1.0 Dt. 02.11.2012 orlatest and TAN no.STS/E/TAN/3006, Ver.3.1, dt. 30.06.2025 orlatest for earthing and bonding scheme (as applicable) for Electronic Interlocking. (Inspection by RDSO). A) (M/s Kyosan) on JRC-HSX Section 3 LC Gates (C-25,C-41,C-49), PHR-LNX Section 1 LC Gate (C-20). B) (M/s Ansaldo) on JUC-FZR Section 1 LC Gate (C-20), BTI-FZR Section 1 LC Gate (C-33). C) (M/s Medha) on FZP-FKA Section 2 LC Gates (C-54,C-58) from same station, KKP-FKA Section 1 LC Gate (B2-32). | — | — | — | 2,72,20,460.16 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
TypicalDrawingsofLCGates.pdf
ATTACHMENT
TENDERDOCUMENT27LCINTERLOCKINGFZRDIV.pdf TENDER DOCUMENT
ATTACHMENT
TENDERDOCUMENT27LCINTERLOCKINGFZRDIV.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .