ATA related miscellaneous rubber lining works in various plants of FACT UC

Amount

Rubber lining works

Removal of old rubber from the damaged portions of equipment, vessels, tanks, ducts, on floors, pipes, etc. at various plants and at various elevations. Preparation of surface by chipping/grinding/wire brushing/Sand/shot blasting etc. as per the instructions of the Engineer-in-charge. Carryout new rubber lining using suitable rubber sheets of 2.5 mm thick in TWO layers to get a thickness of 5 mm with required adhesives, solvents, curing agents, etc. and cure it with steam / hot water to get a hardness of 60 to 70 shore A . All arrangements and materials required for rubber removal and fresh rubber lining will be under the contractor's scope.

Carryout fresh rubber lining after removing the scales, paint etc. by wire brushing / grinding / Sand/Shot blasting or by any means as directed by the Engineer-in-charge so as to get a smooth surface on newly fabricated pipes, ducts, tanks, etc. Supply of suitable rubber sheets and carry out fresh rubber lining with 2.5 mm thick rubber sheets in TWO layers (2.5 mm x 2 = 5 mm thk) with required adhesives, solvents, curing agents, etc. and curing with steam / hot water to get a hardness of 60 to 70 shore-A. All arrangements and materials required for fresh rubber lining will be under the contractor's scope.

Carryout sand/ shot blasting as per applicable standards over ducts, vessels, tanks, and equipment like turbines, various rotors, fans, agitators, pumps etc. Any in situ sand/ shot blasting required shall also be done by the contractor. All the necessary arrangements and equipment including Air- compressor required for sand blasting shall be under the scope of contractor.

SACHINDRA RUBBER PLUS LLP (BID ID -3187833)