Provn of High Mast Lights at Doraha and Security lights at Dholewal under GE Ludhiana

Amount

Suppling, installing, testing and commissioning of 15 M high Mast system including 9 Nos luminaires & with the following specifications:- (a) Supply installation testing and commission of high mast shaft shall be in Two section hot dip galvanized , inside and outside in single dip, suitable for wind velocity as per IS:875 Part-3. There shall be only one longitudinal seam section and no circumferential weld. it shall also include accessories for high mast including head frame, 2 point suspension system with steel wire roop 6" dia (7/19 construction) double drum winch, galvanized lantem carriage arrangement suitable for up to 9 luminaires symmetrically tighting final & integral power tool for raising and lowering operation of the high mast. (b) Supply of foundation bolts manufactured from special steel alongwith nuts,washers, anchor, plates & templates as recommended by High mast manufacturer. (c) Supply of LED light fitting 1x120 watt complete set-09 Nos. (d) Supply of twin dome aviation obstruction lights of type BJAOL 1 with Neon lamp as recommended by High mast manufacturer. (e) Supply of control panel housing suitable control circuit for automatic switching ON and OFF of the MAST. It shall also have suitable control for operation of power tool. (f) Construction of RCC foundation in RCC 1:1 1/2 : 3 using 20mm graded stone aggregates over lean concrete 1:4:8 all as shown on drawing No BHMRL 16A-50mps sheet No 01 of 01 including excavation and earth work. (g) Erection of the high mast with help of suitable equipment and wiring of luminaires with all wiring material and labour. (h) Provision of GI electrod 60cm x 60 cm x 6mm earthing for high mast with earthing lead with 4 mm GI wire complete-02 Nos (j) Installation of control panel on suitable foundation including all material and labour. (k) Testing and commissioning of above high mast system. Make:-Bajaj/Havells/Crompton Greave Note: The drawing of high mast light shall be got approved from accepting officers before placing of order.

Supply, laying, jointing, testing and commissioning 35 Sqmm 4 Core cable XLPE insulated , armoured heavy duty electric cable with aluminium conductor, 1100 volts grade, laid in trenches,on pole complete all as specified and directed by Engr-in-charge.

Supply, laying, jointing, testing and commissioning 50 Sqmm 3.5 Core cable XLPE insulated , armoured heavy duty electric cable with aluminium conductor, 1100 volts grade, laid in trenches,on pole complete all as specified and directed by Engr-in-charge.

Excavation in trenches in any type of soil not exceeding 1.5 mtr wide and not exceeding 1.5 metre in depth for taking out of unserviceable under ground cable complete all as specified and directed by Engr-in-charge.

Returning, filling in, any type of soil and spreading, in layers not exceeding 25 cm thick complete all as specified and directed by Engr-in-charge.

Removal of surplus soil (any type of soil obtained from excavation) to a distance not exceeding 50 metre and depositing where directed at a level not exc 1.5m above the starting point complete all as specified and directed by Engr-in-charge.

Supplying and laying bricks common burnt clay building bricks sub class 'B' complete all as specified and directed by Engr-in-charge.

M & L for sand cushioning in trenches and well ramming in layers for cable cushioning with fine dry sand and complete all as specified and directed by Engr-in-charge.Notes-:(i) Excavation and earth work to be measured and paid for separately. (ii)Thickness of 18cms after punning shall be considered for payment.

Supply and fixing of GI tubing galvanised light grade of size 50 mm bore with all fittng and fixed complete to wall, floor and ceilling or laid in trenches (for protection UG cables) complete all as specified and directed by Engineer-in-Charge.

M& L for earthing complete with & including galvanized MS earth plate of size 600 x 600 x 6 mm thick, buried vertically in ground to a depth not less than 2.25 metre below ground level, with top edge of earth plate not less than 1.5 below ground level connected to galvanized earth wire soldered and riveted or connected to earth plate by means of nuts, bolts , check nuts & washers, of galvanized iron or steel all as Shown in electrical plate No. 3 of MES SSR Part- I (2009) and connected to panel board, all as specified and testing on completion including provn of earth wire 32x6 mmm dia duly protected with and including 15 mm bore medium grade GI pipe upto 7.5 (maximum) metre from electrode to earth point including provn of the earth plate surrounded with adequate quantity of charcoal dust mixed with salt to a packed thickness of not less than 15 cm in alternate layers of charcoal and salt on all sides of earth plate and GI light grade watering pipe of 20mm dia bore with funnel with wire mesh including all necessary excavation & earth work in any type of soil, returning filling in, removal of surplus soil to a distance 50 metre, PCC 1:3:6 type C-1 as in earth chamber, 50 mm thick RCC cover using cementconcrete 1:2:4 type B-0 reinforced with & including 8 mm dia mild steel TMT bar @ 100 mm c/c Both way with suitable handle for lifting arrangement & including form work and MS frame using MS angle of size 40mm x 40mm x 6mm complete all as specified & directed. NOTES:- (i) On testing, after completion of Job, if desired earth resistance is not obtained, the earthing shall be redone by the contractor without any extra cost to the department.

Supply, laying, jointing, testing and commissioning 16 Sqmm 4 core cable XLPE insulated , armoured heavy duty electric cable with aluminium conductor, 1100 volts grade, laid in trenches,on pole complete all as specified and directed

Supply, laying, jointing, testing and commissioning 35 Sqmm 3.5 core cable XLPE insulated , armoured heavy duty electric cable with aluminium conductor, 1100 volts grade, laid in trenches,on pole complete all as specified and directed

Supply and fix Steel tubular pole swaged poles type 410SP-31(9 metre long) Swan neck type complete with CI base plate and finial and single swan neck,including foundation and coping complete all as specified.

M & L for PCC (1:4:8) tpe D-2 using 40mm graded stone aggregate as in foundation for electric poles struts, PCC blocks including necessary form work for fair finished surfaces complete all as specified .

M & L for P.C.C (1:2:4) type B-1 using 20 mm graded stone aggregate as in coping of poles including necessary form of work finished even and smooth without using extra cement complete all as specified and directed.

M & L for P.C.C (1:3:6) type C-2 using 20 mm graded stone aggregate as in coping including necessary form work or in any situation all as specified and directed.

S&F GI tubing 40 mm bore 'light grade', galvanized, with all fittings jointed and laid in trenches/fix on wall floor for cable protection complete all as specified and as directed by Engr-in-Charge.

Supply and fixing LED street light fitting 100watt , IP 65, made up of pressure die cast aluminium housing with potted Isolated driver and high power LED and individual lenses, operating range -90V to 340V AC complete all as specified and directed.

Supply and fixing in security light bracket made of 40mm bore GI light grade pipe 1.5 metre long bend to shape including fixing on pole with suitable size of flat iron clamps, nut, bolt etc. complete all as specified and directed.

S& F polycarbonate thermoplastic outdoor junction box for steet lights with flap cover operate with IEC 61439-3 which should be shock proof, protection class-II, earthed , IP 65 weather proof , corrision free , acid and chemical resistant , impact resistant, , ultra voilet resustant made of halogen & silicone free recyclable mtrl, internally embedded gasket with provision for cable entry through integrated flanges top and bottom,The gasket should be internally embedded made of polycarbonate incl with fixing arrangement ( clamps, nuts and Bolts etc.) complete all as specified.

M & L Sub main wiring complete with 2 runs of 2.5 Sqmm single core PVC insulated FRLS cable 1100 volts grade multistranded copper conductor cable with 1 run of 2.5 Sqmm single core PVC insulated FRLS cable 1100 volts grade, multistranded copper conductor cable as earth continuity conductor, drawn through and including 25 mm or higher dia non metallic rigid PVC conduit and conduit accessories concealed/ surface in wall/Ceiling etc all as specified and as directed.

M& L for earthing complete with & including galvanized MS earth plate of size 600 x 600 x 6 mm thick, buried vertically in ground to a depth not less than 2.25 metre below ground level, with lop edge of earth plate not less than 1.5 below ground level connected to galvanized earth wire soldered and riveted or connected to earth plate by means of nuts, bolts , check nuts & washers, of galvanized iron or steel all as Shown in electrical plate No. 3 of MES SSR Part- I (2009) and connected to panel board, all as specified and testing on completion including provn of earth wire 4 mmm dia duly protected with and including 15 mm bore medium grade GI pipe upto 7.5 (maximum) metre from electrode to earth point including provn of the earth plate surrounded with adequate quantity of charcoal dust mixed with salt to a packed thickness of not less than 15 cm in alternate layers of charcoal and salt on all sides of earth plate and GI light grade watering pipe of 20mm dia bore with funnel with wire mesh including all necessary excavation & earth work in any type of soil, returning filling in, removal of surplus soil to a distance 50 metre, PCC 1:3:6 type C-1 as in earth chamber, 50 mm thick RCC cover using cementconcrete 1:2:4 type B-0 reinforced with & including 8 mm dia mild steel TMT bar @ 100 mm c/c Both way with suitable handle for lifting arrangement & including form work and MS frame using MS angle of size 40mm x 40mm x 6mm complete all as specified & directed. NOTES:- (i) On testing, after completion of Job, if desired earth resistance is not obtained, the earthing shall be redone by the contractor without any extra cost to the department.

Boring of holes under road, pavement, hard standing by trenchless technique and necessary T&P for passing of LT/HT cables. complete all as specified and directed.

JASSI TRADERS