REPAIR TO CONCERTINA COILS AND REPAIR TO FOD TRAP IN TECH AREA AT AF STN PHALODI

Amount

Demolition of Brickwork or stone/boulder masonry, built in lime mortar including all quoins, arches, pillars,etc, but excluding ashlar facings, dressed stonework and precast concrete articles etc complete all as specified and as directed.

Demolition of cement concrete ( unreinforced ) in ground floors and pavings not exceeding 15 cm thick above or below ground level complete all as specified and directed.

M&L Precast cement concrete type C1 (1:3:6) using 20mm graded stone aggregate block masonry with solid blocks exc. 10 cm in width and setting in cement mortar (1:6) complete all as specified and directed.

M&L for preparation of old steel surfaces of any description or girth over 10 cm width or girth and applying one coat of synthetic enamel paint, complete all as specified and directed.

Dismantling wrought iron or mild steel work of anydescription by cutting or without damage of structure not otherwise provided complete all as specified and directed.

Dismantling concetina coil of any type or size complete all as specified and directed.

M&L for preparation of new steel surface of any description not otherwise described exc 10cm width or girth and applying two coats of synthetic enamels paints over a coat of red oxide primer complete all as specified & directed.

Dismantling fencing wire mesh any type complete all as specified and directed.

M&L for preparation (remove vegetation ) of old chain link fencing surface of any description and any size/ gauge and applying one coat of Aluminium paint ( 1st grade quality) complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed.

Labour only for Restraning resecuring inluding making good staples, galvanized 2 strands steel barbed wire 2.24mm dia at 75mm spacing and straining and fixed to any shape/type of standard posts, straining bolts, including screwing or tightning at crossing with and provision of galvanized mild steel wire staple or steel pins etc as directed (Note : Each line of wire to be measured separately) complete all as specified and directed.

Taking down cement or cement lime plaster, any description on brick or stone walls/Block masonary(one side only measured in case where both sides are plastered ), etc. incl raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for stone walling of random rubble, uncoursed, well bonded, bedded and solidly hearted built in cement mortar (1:6) complete all as specified and directed.

Extra over stone walling for hammer dressing to face stones with maximum depression on face from straight edge held against the dressed surface n exc 20mm for sand stone and dressing of face beds and joints, as specified of random rubble walling uncoursed or brought upto courses complete all as specified and directed.

M&L for rendering 10 mm thick in CM (1:4) on stone masonary surfaces or other than fair face of brick work including finished plastered surface even and smooth without using extra cement complete all as specified and directed.

M & L for Rolled sections as in main and cross beams, hip and jack rafters,purlins where connected to common rafters and running rails and guides for sliding doors, FOD traps fixed with angle cleats or welding section or other connecting plates Fe 410 -W (Gde?E- 250) quality A complete all as specified and directed.?

Supply only Chain link MS galvanisd fencing of any size or type complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

S&F mild steel screw bolts (Machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt exc 5cm but nexc 10cm long and diameter of neck in mm 11 to 15 complete all as specified and directed.

S&F in repair galvanized 2 strands steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixed to any shape/type of standard posts, straining bolts, including screwing or tightning at crossing with and provision of galvanized mild steel wire staple or steel pins etc as directed (Note : Each line of wire to be measured separately) complete all as specified and directed.

S&F of mild steel galvanized punched type concertina coil of loop dia 600 mm ( dia of coil with unstretched ) and fixed to angle iron with and including of 2.60 mm dia of GI wire complete all as specified and directed. (Note : one coil weighing approximately 7 to 8 Kg shall not be stretched more than 6 to 7 RM span)

Dismantling posts or struts (wood, steel or R.C.C.) any section, post embedded in Concrete, brick work, masonry, etc including taking out embedded portion and making good disturbed ground complete all as specified and directed.

S & F for posts and struts in fencing including cutting tops to shape as directed, drilling holes,notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc.,and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

M&L for cement concrete (1:2:4) type B0 using 12.50 mm graded stone aggregate as in lintels upto 1.5m clear span, cills, steps, seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railigs upto 60cm in height, copings, kneelers, apex stones, bed plates, kerbs, water troughs and the like including weathering, sligtly rounded or chamfered angles and throating, as directed including necessary form work complete all as specified and directed.

M&L for Mild steel round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for preperation of new steel surfaces of any description n.exc. 10 cm in width or girth and applying two coats of synthetic enamal paint over a coat of red oxide primer complete all as specified and as directed. Note: No Extra claim shall be made by the contractor for above items for site availability as pe user's ( site requirement ad stoppage of work due to any aircraft arrival in a day). The rates shall be deemed to be included in the items.

KRISHNA CONSTRUCTION COMPANY (BID ID -3307724)

M/S BHERA RAM & SONS (BID ID -3309219)

Beenu Co. Company (BID ID -3309332)