Restoration of rain damages to LWSS Noun Tanihar in Tehsil Dharampur Distt. Mandi HP (SH. Repair of Pump House) under PDNA

15mm thick cement plaster in single coat on rough side of brick /stone /concrete walls for interior plastering upto floor two level I/c arrises, internal rounded angles, chambers and/or rounded angles not exceeding 80mm in girth and finished even and smooth in cement mortar1:6 (1 cement :6 sand)

15mm thick cement plaster in single coat on Fair side of brick /stone /concrete walls for interior plastering upto floor two level I/c arrises, internal rounded angles, chambers and/or rounded angles not exceeding 80mm in girth and finished even and smooth in Inc.m.1:3.

Pointing on existing stone masonry in cement mortar 1:3 ,including raking out old joints to required depth,cleaning,washing and wetting the jonts ,filling with cement mortar and finishing complete within all leads and lifts as per the directions of Engineer-in-charge.

Applying Birla white wall care putty over plaster surface after throughly brushing the surface free from mortar drops, dust, loose material & other foreign matter as per direction and to the entire satisfaciton of Engineer-in-charge upto all lead and lift.

Finishing wall with water proofing cement paint of approved brand and manufacture and of required shade on undecorated wall surfaces (two coats) to give an even shade after thoroughly brushing the surface to remove all dirt and remains of loose powdered materials in all respect as per direction and to the entire satisfaction of Engineer-in-Charge.

Applying priming coat on new concrete/masonry/asbestos cement/plastered surfaces after and including preparing the surface by thoroughly cleaning oil,grease,dirt and other foreign matter and sand papering as required with readymixed prime as per direction and to the entire satisfaction of Engineer-in-charge upto all lead and lifts.

Wall painting (two coats) with acrylic emulsion paint of approved brand and manufacture for interior grade on undecorated concrete/stone/plastered wall surfaces to give an even shade including t horoughly brushing the surface free from mortar dropping and other foreign matter and sand papered smooth including applying of putty a required for metling

Wiring for light point/fan point/exhaust fan /Call bell point with 1.5 sq mm PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface casing caping and earthing the light point with 1.5 Sq.mm HRFRLS/PVC pipe insulated single core copper conductor cable as required. Group 'C'.

Providing, installation, testing and commissioning of ceiling fan with regulator, including wiring the down rods of standard length (up to 30 cm) with 16/0.20mm twin twisted flexible, cotton braided, copper cable, including providing and fixing phenolic laminated sheet cover on the fan box and earthing etc.as required : Ceiling Fan 1400 mm sweep, Category-A.

Providing, fixing & commissioning of LED street light including 75 watt LED bulb and weather proof boGEC/Philips/Bajaj/Crompton/Grofton make can be adjusted with 32mm dia pipe bend one meter of suitable angle including fixing bolts & nuts, clamps & making hook to GI pipe etc. GI pipe shall be issued by the department free of cost complete in all leads and lifts as per direction and to the entire satisfaction of Engineer in Charge.