REPAIRING OF CULVERT WITH GUARD WALL

Earthwork in excavation for foundation of structures as per drawing and technical specification including setting out, removing, spreading or stacking of spoils within a lead of 150 m. as directed and including trimming the sides of the trenches, leveling, dressing and ramming the bottom, complete as per direction of the Engineer-in-Charge.In all sorts of soil excluding marshy soil & rocks (soft or hard) by manual means. Depth up to 3 m. : With pumping out water including shoring as required.

Earth in filling in foundation trenches and at the back of abutments with good earth (sandy soil) in layers not exceeding 15 cm. including watering and ramming layer by layer complete with earth obtained by fresh excavation from land arranged by Department beyond 150 m. but within 300 m. including all lifts. Earth to be approved by the Engineer-in-charge

Providing and laying Design Mix M-15 concrete for Plain / Reinforced Cement Concrete in any part of foundation of bridge /culvert with graded stone chips of appropriate nominal sizes , including screening and cleaning of coarse aggregates, fine aggregate (sand) conforming to proper grading zone , both of approved quality and cement , as necessary , cost of curing with water ,including cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in charge , cost of quality control, sampling , testing etc all complete but excluding cost of formwork and reinforcement works. PCC Grade M-15 With 37.5 mm size well graded shingles using concrete mixer, height upto 5m

Hire and labour charges for Shuttering with or without staging upto 4.0 m height using approved stout props with wooden planks/ply wood/steel sheet plate with required bracing for any kind of plain or reinforced concrete works in all sorts of minor structure including culvert, box culvert, cross-drain etc. The rate is inclusive of fitting, fixing and striking out after completion of work as per specification and direction b) Where staging is not required

Providing weep holes in Brick masonry / Plain / Reinforced concrete abutment, wing wall / return wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1V:20H towards drawing face. Complete as per drawing and Technical specifications.

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] c) 10 mm thick plaster

Providing & fixing Concrete Sign Board as per IRC specification of size 900 x 750 x 37 mm. thick made with RCC 1:1½:3 with pakur variety stone chips reinforced with double layer IRC febric (75 x 75 mm. mesh) and fixed with necessary nuts & bolts on two RC precast posts 100 mm. x 150 mm. of height 2.65 m. of which top 750 mm. is of section 100 x 13 mm. and 1.90 metre above GL & 0.75 metre below GL including digging hole, repacking the same with cement concrete 1:3:6 with jhama khoa or with local stone chips etc. omplete including painting two coats on both faces lettering sign marks etc. as per direction of the Engineer-in-Charge. (The rate is inclusive of cost of reinforcement, Concrete, shuttering, nuts & bolts, washer etc. complete.)