Repairing of TATA Vehicles

Amount

PART A- Complete repair, maintenances & fitness from RTO office of vehicles no DL-1L AD 7233, DL-1L AD 7106 , DL-1L AD 7577 and DL-1L AD 7513 of Mahindra CNG 3000 Liter capacity tanker:- Complete cabin shall be minor repair by setting of front bumper,All door lock,door handle, front grill, cabin foundation and bracket etc. Replace & setting all door rubber channel of door glass, front and rear windows glass repairing and writing slogan as per requirement of department.

Complete service of engine BS-IV CNG Engine by cleaning and setting of all required parts. Replacement of Air filter,HT Wire Set, Fuel filter, primer filter,four no.spark plug and cleaning radiator assembly complete of radiator.

Complete dismantling and cleaning of CNG Cylinder (03Nos) with setting of pipe,Switches,Indicator meter,CNG filling knob and all required Hydro testing certificate.Engine shall be tested on full load up to sufficient pollution level.

All electric system with replacement of wiring parts,lights,sensor Assy.relay and fuse box etc. And servicing of self starter assy.with replacement of required parts.

Repair of O/H of brake system and Hub Greasing of all for wheel and replacing Oil seal and Chuck nut etc.as per requirement.

Complete vehicle shall be put to the transport Department for getting pollution and fitness certficate for the year 2022-23 & provide speed governor certificate from registered authority by transport department.

Complete opening of CNG high pressure regulatory sys and replace with new one and complete setting of four cylinder inline overhead valve four stroke water cooled CNG operated engine with replace of spark plug, H T wire set, and setting of engine speed at idle speed and full load condition with the help of software on laptop including labour charges.

Complete opening of CNG refilling knob and replace of one-way valve and cleaning of cylinder main filling valve. Replace of protective cover knob with new one. After opening of CNG regulator valve and remove by replace of leakage valve seal with new one and refitted in vehicle by checking any type of leakage from the CNG regulatory sys including labour charges. Complete checking of accelerator sys and replace of acc wire and setting of engines at idle and full load condition on the laptop by proper software, including charges

Complete opening of supply of CNG into the engine by throttle sys and check the wear and tear in the throttle. It shall be repair and making of sheet on lath job work and setting of proper supply of CNG inside the combustion chamber for making of power stroke. Accelerator wire shall be replaced and setting with idle and full load condition. Complete opening of injector assay and clean it with proper method and tested the proper pressure at operating temperature inside the combustion chamber. Replace of filter cartridge and o ring including labour charges

All electric system with replacement of wiring parts,lights,sensor Assy.relay and fuse box etc. and servicing of self starter assy.with replacement of required parts (Electrical control module 80 pole).

Complete O/H of front & rear suspension system by opening and dismantling the spring plates and re tensioning as per require. Replace U-Bolt,Clomp,Centre bolt,Shackle pin etc. as required.