Beautification of roundabout at Delhi Gate Chowk, Delhi.

S.I.T.C of Steel Pole, 4mtr. height are made of Galvanised steel tubes having bottom part of the pole (1000mmx114mmx4mm) and upper part is (3000mm x 75mm x 3mm) made out of mild steel galvanised tubes. The bottom and middle part of the poles are fitted with cast alum. embellishments and are fitted and sealed by gurb screws as shown in the drawing. The Poles has a service window at the bottom containing 25amp connector terminal and MCB of the desired rating. The Poles are primer coated and painted with polyurethane paint of the desired colour etc as required. (As per Annexure- D Page No. 48)

S.I.T.C of Steel Pole, 3mtr. height are made of Galvanised steel tubes having bottom part of the pole (1000mmx114mmx4mm) and upper part is (2000mm x 75mm x 3mm) made out of mild steel galvanised tubes. The bottom and middle part of the poles are fitted with cast alum. embellishments and are fitted and sealed by gurb screws as shown in the drawing. The Poles has a service window at the bottom containing 25amp connector terminal and MCB of the desired rating. The Poles are primer coated and painted with polyurethane paint of the desired colour etc as required. (As per Annexure- E Page No. 49)

S.I.T.C of 40Watt LED Post Top decorative fitting with Die Cast Aluminium housing, 3 nos. die cast aluminium arms, die cast aluminium base and top. A PMMA diffuser is provided for glare glare free lighting duly painted and primer coated with PU paint. Total system Lumens of the fixtures are minimum 4000 lumens having Luminous efficacy ≥ 100 Lum/Watt, CCT 2700-3000K, CRI ≥ 80 and having inbuilt Surge protection ≥ 4KV. The Lamp compartment of the fixtures are IP-66 etc as required. (As per Annexure- F Page No. 50)

S.I.T.C of 25Watt LED Post Top decorative fitting with Die Cast Aluminium housing, 3 nos. die cast aluminium arms, die cast aluminium base and top. A PMMA diffuser is provided for glare glare free lighting duly painted and primer coated with PU paint. Total system Lumens of the fixtures are minimum 2500 lumens having and Luminous efficacy ≥ 100 Lum/Watt, CCT 4000K, CRI ≥ 80 and having inbuilt Surge protection ≥ 4KV. The Lamp compartment of the fixtures are IP-66 etc as required. (As per Annexure- G Page No. 51)

Fabrication, supplying and installation of outdoor type, sloping roof cubical feeder pillar of surface area not less than 1 sq meter with minimum depth of 45 cm made out of CRCA M.S. Sheet of 2 mm thick (14 SWG) duly compartmentalized having 4 strip bus bar of 400 Ampers capacity double door with double locking arrangement (one sliding lock in front and one godown lock each at front and rear for protection) dust proof vermin process, duly fixed on M.S. angle iron frame work of size 50 mm X 50 mm X 6 mm (NS) 90 cm long legs, out of which 45 cm duly painted with one coat of red oxide & two coats of superior quality enamel paint in approved shade and colour etc. complete with testing, earth studs, earth strips etc. as required.

250 A,36KA,FPMCCB

Digital type volt meter (0-500 volts) with selector switch

Digital type Ammeter (0-250 Amp) with selector switch

Indicating light LED type with 2 A Ampers SP MCB (3 Nos)