Loading
Loading…
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹8.3 LAccepted-AOC KADAPAKKADA P O KOLLAM 691008 VENDOR KOLLAM | KOLLAM | KERALA | 691008 | L1 | Accepted-AOC L1 | |
| 2 | L2₹8.8 L+₹46,456.63 (5.59%)Rejected-AOC | L2 | Rejected-AOC L2, Higher rate, hence rejected | |
| 3 | L3₹8.8 L+₹48,628.34 (5.85%)Rejected-Finance | L3 | Rejected-Finance L3 | |
| 4 | L4₹8.9 L+₹60,046.58 (7.23%)Rejected-Finance ASHAYIL CHENGARA PATHANAMTHITTA | KOTTAYAM | KERALA | 686001 | L4 | Rejected-Finance L4 | |
| 5 | L5₹8.9 L+₹60,135.31 (7.24%)Rejected-Finance | L5 | Rejected-Finance L5 |
| Sl No | Description | Qty | Unit | Binoj V.Thomas L3 | Sajeevkumar K P L5 | GEORGE V MATHEW L2 | SUNIL KUMAR S L6 | CRAFT BUILDERS LIMITED LIABILITY PARTNERSHIP L1 | RAJESH A BHASKAR L4 |
|---|---|---|---|---|---|---|---|---|---|
| 1.00Renovation of school Building | |||||||||
| 1.00 | 2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-in-charge.All kinds of soil | 0.36 | cum | 257 ₹92.52 | 223 ₹80.28 | 350 ₹126 | 257 ₹92.52 | 200 ₹72 Lowest | 265 ₹95.4 |
| 1.00 | 50.6.1.1:Solid block masonry using pre cast solid blocks ( factory made) of size 40x20x20cm or nearest available size confirming to IS 2185 part 1 of 1979 for foundation and plinth with thickness 20 cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete | 0.51 | cum | 6,408 ₹3,268.08 | 5,639 ₹2,875.89 | 7,000 ₹3,570 | 6,400 ₹3,264 | 5,200 ₹2,652 Lowest | 6,100 ₹3,111 |
| 1.00 | 4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III)derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) | 1.33 | cum | 9,235 ₹12,245.61 | 8,500 ₹11,271 | 8,500 ₹11,271 | 9,235 ₹12,245.61 | 7,500 ₹9,945 Lowest | 8,000 ₹10,608 |
| 1.00 | 11.41.2:Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS : 15622, of approved make, in all colours and shades, laid on 20 mm thick cement mortar 1:4(1 cement : 4 coarse sand), including grouting the joints with white cement and matching pigments etc., complete.Size of Tile 600 x 600 mm. | 229.69 | sqm | 1,500 ₹3,44,532 | 1,562 ₹3,58,772.66 | 1,620 ₹3,72,094.56 | 1,450 ₹3,33,047.6 | 1,700 ₹3,90,469.6 | 1,400 ₹3,21,563.2 Lowest |
| 1.00 | 10.25.2:Item Shifted to Sub head 14 as item 14.73
Item Shifted to head 14 as item 14.74
Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works | 580.8 | kg | 120 ₹69,696 Lowest | 156 ₹90,604.8 | 160 ₹92,928 | 178 ₹1,03,382.4 | 140 ₹81,312 | 187 ₹1,08,609.6 |
| 1.01 | 50.10.2:Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete | 25.35 | kg | 187 ₹4,740.45 | 164 ₹4,157.4 | 180 ₹4,563 | 187 ₹4,740.45 | 150 ₹3,802.5 Lowest | 184 ₹4,664.4 |
| 1.01 | 12.50:Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. | 10.79 | sqm | 842 ₹9,085.18 | 740 ₹7,984.6 | 740 ₹7,984.6 | 842 ₹9,085.18 | 700 ₹7,553 Lowest | 730 ₹7,876.7 |
| 1.01 | 13.98.1:Wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade:One or more coats on old work | 916.32 | sqm | 100 ₹91,632 | 99.44 ₹91,118.86 | 130 ₹1,19,121.6 | 110 ₹1,00,795.2 | 90 ₹82,468.8 Lowest | 100 ₹91,632 |
| 1.01 | 13.99.1:Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade :One or more coats on old work | 109.64 | sqm | 108 ₹11,841.55 | 95 ₹10,416.18 | 150 ₹16,446.6 | 108 ₹11,841.55 | 80 ₹8,771.52 Lowest | 94 ₹10,306.54 |
Tender Value
₹10.1 L
EMD Value
₹25,362
Closing Date
14 Oct 2025, 4:00 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Asst.Exe. Engineer,LID_EW Division
LID_EW Division,Jilla panchayath, Pathanamthitta
Annual Plan-JP PTA - 2025-26- Pro. No. 818/26- -Nedumpuram Govt H S kettida punarudharanam-General Civil Work
2025_LSGD_803528_19
07/2025-26/AEE/LID_EW/PTA
Open Tender
Civil Works - Buildings
Item Rate
210 days
LID_EW Division, Jilla panchayath
Please refer Tender documents.
7 documents required · 7 mandatory
₹2,760
₹25,362
Yes
17 Nov 2025
4 Oct 2025
17 Oct 2025
4 Oct 2025
14 Oct 2025
4 Oct 2025
stage.html
html • 0.05 MB
tech_eval.pdf
fin_eval.pdf
aoc.pdf
finance_1338184.pdf
boq_comp_chart.xlsx
xlsx
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.04 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .