GENERAL-Kerala Judicial Academy-Replacement of CT-PT unit-Urgent requirement to carry out the work of replacing the existing two CTs of class 0.2 S in the HT installation for smart metering as directed by the KSEB.-HT-Electrical-Work

OD295403/2025-2026:Dismantling of existing outdoor type CT PT unit as required.

OD319841/2025-2026:Supply installation testing and commissioning of suitable size 3 Nos Current transformer Rating 15/5A, Accuracy class 0.2S, 10VA IL 12/28/75 kV as per IS 2705 and one Number PTs (, Rating 11kv/110 volt, Accuracy class 0.2, 20VA, IL 12/28/75 kV as per IS 2705(or suggested by KSEB) including giving necessary connections and Hole punching, bending, drilling etc as per the direction of Engineer In charge.

OD298448/2025-2026:Supply installation testing and commissioning of test terminal block.

OD299452/2025-2026:Dismantling of old DO fuse and installation of new polymeric DO fuse

OD298454/2025-2026:Supply installation testing and commissioning of 20A HRC Fuse Base with HRC Fuse link as required.

OD297010/2025-2026:LS provision forapproximate KSEB statutory fees.(Actual amount will be remitted on production of original documents)

OD296952/2025-2026:Conveyance of CT-PT unit to TMR,Angamaly Division and delivery of tested CT to site. (Excluding statutory fees)

90.14.1.1:Fabrication, supply, conveyance, installation testing and commissioning of floor or wall mounting, dust and vermin proof, cubicle type MV panel board comprising of the following components/ devices & complying to IS 8623. Fabrication of fully partitioned, dust and vermin proof enclosure for panel assembly as per form 4 of IS 8623 (with latest amendments) using CRCA sheet as per approved design and requirement, with front and rear access facility, bus bar chambers, hinged doors for all switch gear compartments, earthing the doors using 4 sq mm braided copper conductor, providing necessary cut-outs for mounting meters, relays, indication lamps, bus bar interconnection etc, detachable covers for bus bar chamber and cable alley, powder coating the assembly after subjecting to 7 tank process etc as required. CRCA sheet alone be used for the fabrication. Angles/ flats/ slotted angles etc shall not be used for the fabrication of panel assembly. The measurments will be taken the area of the complete sheets used for panel board including partitions, folding, shrouding etc.Supply and fabrication of MV panel board using 2.00mm CRCA sheet, powder coated (excluding base frame)

90.14.5:Supply and fabrication conveyance and installation of angle iron frame work for wall mounting panel board