Tiruchirappalli District Thiruverumbur Block Construction of passenger shelter in Kumbakudi Anna nagar Phase II Near OFT Road

Construction of Passenger Shelter in Kumbakudi Anna Nagar Phase II Near OFT Road in Kumbakudi Panchayat. Earth work excavation and deposition on bank with initial lead and lift in all clauses of soil asper SS 20 B for foundation.

Sand filling with good M-Sand sand including cost and conveyance of all material to site and all labour charges etc. complete.

Cement concrete 1:4:8 mix using 40 mm ISS HBG metal including cost and conveyance of all materials to site and all labour charges. etc., complete.

Brick work in cm 1:5 mix using country bricks of size (23*11*7cm) ncluding cost and conveyance of all materials to site and cement which will be suppliedby dept including watering curing and other labour charges etc.,

Supply fabricatioin of steel for RCC works including cost and conveyance of steel to site including labour charges for tying rods and placing the girls in position premeasurement asper steel schedule.

Supplying and erecting centering for sides Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X '3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification.

R.C.C 1:11/2:3 mix using 20 mm ISS HBG Metal Including cost and conveyance of all materials to site but excluding cost of steel and fabrication charges etc., buit excluding cost for Roof slab

Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty should be got approved by the Executive Engineer before use on work. (Based on SoR 2023-24)

Plastering in CM 1:5- 12 mm thick incluiding cost and conveyance of materials and labour charges etc. complete.

Paving the Floor with best quality Vitrified tiles of size 600 X 600 X 8mm of approved colour, shade and quality laid in cement mortar 1:3 ( one cement and three crushed stone M.Sand ) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification. (The make and brand of the tiles should be got approved by Executive Engineer before use on works)