SPL REPAIR TO AC SHEET ROOFING AND OTHER RELATED WKS AT MGR MT SEC AND ADMIN BLOCK AT AF STN MANDORE AND PROVN OF CCD PATTERN PAINTING OF BOUNDARY WALL INSIDE AND OUTSIDE AND CERTAIN PLACES AT AF STN MANDORE UNDER AGE BR 1 GE AF NO 2 JODHPUR

Amount

Dismantling of Asbestos cement (corrugated, semi corrugated, etc.) sheets in roof coverings as specified and directed by engineer-in-charge.

S&F Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm of an colour having tensile strength of 550Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified and directed by engineer-in-charge.

Dismantling structural steel work including doors, gates but excluding framed truss etc. as specified and directed by engineer-in-charge.

Dismantling timber scantlings in fillets post rafter purlines etc 40 sqcm and over framed , in any position as specified and directed by engineer-in-charge.

Excavating in post holes (or similar holes) in soft/disintergated rock each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance n exc 50m and making good surface as specified and directed by engineer-in-charge..

S&F Pre-painted galvalume aluminium zinc coating GI based plane steel sheet 0.50 mm of an colour having tensile strength of 550Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified and directed by engineer-in-charge..

M&L fo PCC 1:2:4 type B2 (using 40mm graded aggragate) in foundations, filling and mass-concrete complete all as specified and directed by engineer-in-charge.

M&L Steel work in tubular trusses posts including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to IS 1161-1979 grade St.-240 as specified and directed by engineer-in-charge.

M & L applying two coats of synthetic enamel paint over a coat of red oxide on steel surfaces of any description and girth including preparation of new steel surfaces complete as specified and directed by engineer-in-charge.

Dismantling wrought iron or mild steel work of any description not otherwise provided for as specified and directed by engineer-in-charge.

Fixing only Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, new rollers etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete with all necessary fitting and fixtures as specified and directed by engineer-in-charge.

Preparing old surfaces plastered or unplastered surface of wall by complete removal of existing treatment by steel wire brushing /metal sheet including washing rubbing down and stopping of distempered and painted surface and applying two coat of exterior emulsion paint in different tint/shade (Comouflage pattern) over one coat of alkali resistant primer as per manufacture's instructions all as specified and directed by engineer-in-charge. NOTE- The CCD pattern should get approved from accepting officer before application of paint and rates shall be quoted accordingly .

psj build solutions and company

Tirupati electricals works and services

Balveer Singh Sankhla And Co