REPAIR TO DRAIN FENCING BOUNDARY WALL REPAIR TO HARDSTANDING AND MISC BR WORKS UNDER GE EAST BAREILLY

Amount

Demolition of brick work or stone/ boulder masonry, built in cement mortar or cement lime mortar including all quoins, arches, pillars etc but excluding ashlar facing dressed stone work and precast concrete articles complete all as specified and directed by Engineer-in-Charge.

Dismantling of old barbed wire fencing complete all as specified and directed by Engineer-in-Charge

Dismantling of posts or struts(wood/ steel or RCC) any section including taking out embedded portion and making good disturbed natural ground complete all as specified and directed by Engineer-in-Charge

Demolition of cement concrete (un reinforced) of any description in any position not otherwise specifically provided for etc complete all as specified and directed by Engineer-in-Charge

Dismantling chain link fencing of any description complete all as specified and directed by Engineer-in-Charge

Dismantling structural steel work including doors, gates but excluding framed truss etc.complete all as specified and directed by Engineer-in-Charge

Dismantling of 300 mm dia reinforced concrete drain pipes, jointed in cement mortar and taking out of trenches, if required complete all as specified and directed by Engineer-in-Charge

Demolition of cement concrete (un-reinforced) in ground floors and pavings not exceeding 15 cm thickness below or above ground level complete all as specified and directed by Engineer-in-Charge.

Taking down cement plaster including racking out joints, hacking for key & scrubbing down with water etc complete all as specified and directed by Engineer - in - Charge.

Dismantling, floor, hearth or wall tiling including cement mortar bedding (but not backing) and rubbish off the premises complete all as specified and directed by Engineer-in-Charge

M&L PCC (1:4:8) type D2 (using 40mm graded crushed stone aggregate) as in foundation filling,mass concrete etc complete all as specified and directed by Engineer-in-Charge.

M&L for brick work with fly ash bricks old size bricks in cement mortar, straight or curved on plan exc. 6 m mean radius, built in CM (1:6) complete all as specified and directed by Engineer-in-Charge

M&L 15mm thick rendering in CM 1:6 on fair faces of brick work and finished the surface even and smooth (without using extra cement) complete all as specified and directed by Engineer-in-Charge

M&L rendering 15 mm thick in CM 1:4 on brick masonary or concrete surfaces of wall or on other than fair faces of brick masonry and finished the surface even and smooth without using extra cement complete all as specified and directed by Engineer-in-Charge.

M&L plain cement concrete 1:2:4 Type B-1 ( using 20 mm graded crushed stone aggregate) as in surface channels and drains complete all as specified and directed by Engineer-in-Charge.

M&L Plain Cement Concrete (1:2:4) Type B-1 ( using 20 mm graded crushed stone aggregate) as in copings on brick wall surfaces including weathering, slightly rounded or chamferred angles and throating complete all as specified and directed by Engineer-in-Charge.

M&L for cement concrete type (1:1.5:3) type-A-1 ( ( using 20 mm graded crushed stone aggregate) as in floor , concrete surfaces & finished the surface even and fair ,laid in bays n.exc 2 m in length & joints filled with bitumen mastic (1:3) complete all as specified and directed.

M& L 75 mm thick PCC 1:4:8 type D-2 (using 40mm graded crushed stone aggregate) as in sub base of floor / pavings complete all as specified and directed by Engineer-in-Charge.

M&L Sand filling under floors or in foundation including watering and consolidation complete all as specified and directed by Engineer-in-Charge.

M&L for Machine pressed cement concrete factory made coloured glazed interlocking paver block any shape and size confirming to IS 15658 -2006 of 60mm thickness, M-35 Grade, machine pressed of pattern and colour as approved by GE complete all as specified and directed.

M&L for Machine pressed cement concrete factory made coloured glazed interlocking paver block any shape and size confirming to IS 15658 -2006 of 80 mm thickness, M-40 Grade, machine pressed of pattern and colour as approved by GE complete all as specified and directed.

M&L for Machine pressed cement concrete factory made coloured glazed interlocking paver block any shape and size confirming to IS 15658 -2006 of 100 mm thickness, M-50 Grade, machine pressed of pattern and colour as approved by GE complete all as specified and directed.

M&L for PCC (1:2:4) type B1 (using 20mm graded crushed stone aggregate) for machine pressesd precast cement concrete kerb stone including weathering, slightly rounded or chemferred angles and throating , as directed edges complete including excavavtion for kerb stone as directed.

M & L 25 mm thick PCC 1:2:4 type B0, (using 12.5mm graded crushed stone aggregate) as in floors to receive surface of tile complete all as specified and directed.

M&L screed bed or bedding layer of mortar, 20 mm thick, in cement mortar 1:6, for laying floor finishes/tiles complete all as specified and directed.

M&L for coloured chequered cement concrete tiles of size 20cm x 20cm x 25 mm thick With mixture of grey and white cement in equal proportions and no pigment set & jointed in neat cement slurry & pointed in coloured cement to match the shade of tiles complete all as specified and directed.

S& F in repair 2 mm thick aluminium sheets on posts of M S pipe iron frame using stainless stel nuts , bolts washers etc and 6 mm dia alumnium rivets front face of aluminium sheet shall be covered with white diamond grade micro prismatic type IX ASTMD 4956-01 standared retro reflective sheeting , bilingual (both language English and Hindi ) letter material as well as unit signia monogram as per given size by overlay colour film pasted over white prismatic sheeting and back side of board shall be painted with epoxy colour of shade (Nos of letters/colour /layout design / font size in sign board as approved by GE) complete incl existing dismantled board complete all as specified and directed by Engineer-in-Charge.

S&F in repair MS steel work in tubular trusses for sign board posts including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S 1161-1979 grade St.-240, complete all as specified and directed by Engineer-in-Charge.

M&L for cement concrete (1:4:8) type D-2 (using 40mm graded crushed stone aggregate) as in fencing post complete all as specified and directed by Engineer-in-Charge. .(NOTE:- Deduction for the portion of fencing post/strut embeded in concrete shall be made)

S&F Mild Steel Posts and struts in fencing (size of angle 65x65x6) mm including cutting tops to shapes as directed including driling holes for bolting of MS flat iron in horizontal, vertical & diagonal faces of each pannel to be intertwined with Chain link fencing , and fixed to posts with MS nut bolts and washers ,wind ties for sign board posts and struts, and similar work confirming to Fe 290 Gde E-165 complete all as specified and directed by Engineer-in-Charge.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire but weight of mesh not exc 4.0 kg/sqm complete all as specified and directed

Supply only chain link MS Galvanized Chain Link Fencing any size or type complete all as specified and directed by Engineer-in-Charge.

M&L PCC 1:2:4 type B-2 (using 40 mm graded crushed stone aggregrate) as in foundation filling and mass concrete as in embedded 15 cm below and 200 mm above GL for fixing chain link fencing complete all as specified and directed by Engineer-in-Charge. ( NOTE:- Form work shall be measured and paid seperately )

Formwork to sides of Rough finished surfaces of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified and directed by Engineer-in-Charge.

Mild steel screw bots (machine made ) with hexagonal or square heads at one end and screwed the other each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt exc 10 cm but not exc 15 cm and 15mm dia complete all as specified and directed by Engineer-in-Charge.

S&F 450 mm dia reinforced concrete pipes, class NP3, laid and jointed with collars complete all as specified and directed by Engineer-in-Charge.

S&F Galvanised 2 strand steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts including securing of typing at crossings with provision of galvanised mild steel wire staple or steel pin as directed (each line of wire to be measured) complete all as specified and directed by Engineer-in-Charge.

S&F mild steel grills framed work as such as grills, gratings etc., with ends of bars shouldered and/or riveted, or forget into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways, m s railings framework of water tanks and and similar work con- forming to Fe.290.Gde-E-165 complete all as specified and directed.

S & F 1.25 mm thick Mild steel, plain black sheet in steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40mm lap joints with riveted or welded seams, including bending or turning up, mitred angles etc as required complete including cutting out of existing sheet if required complete all as specified and directed.

S&F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doo0rs etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and fastening and fixing complete FE 290 Gde E-165 complete all as specified and directed.

S&F Welded steel wire fabric weight n exc 4 kg/sqm supplied and fixed complete to wood or steel members complete all as specified and directed.

M&L for Reinforced cement concrete 1:2:4 type B-1 (using 20 mm graded crushed stone aggregrate) as in drain cover slabs ( exc 150 mm and not exc 200 mm thick) supported on wall with cast in situ including form work (width of drain n exc 3.0 mtr) complete all as specified and directed (NOTE:- Reinforcement shall be measured & paid under respective items of this schedule) .

M&L for Reinforced cement concrete 1:2:4 type B-1 (using 20 mm graded crushed stone aggregrate) as in Slabs supported on walls,beams and columns in floors,roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed (NOTE:- Reinforcement shall be measured & paid under respective items of this schedule) .

M&L Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200m thick (Horizontal or sloping) complete all as specified complete all as specified and directed..

M&L form work to edges of concrete flats, treads, breaks in floors window cill, concrete railing opening in concrete wall , floor and roof n.exc 20cm wide and sides of RCC/ PCC bands in walls, horizontal or sloping and similar work exc 10 cm but n.exc 20cm wide for rough finished surfaces of concrete, complete all as specified and directed.

Supply and fixing Mild steel TMT bars 10mm dia and over, cut to length, bent to shaperequired, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for preparing newly plastered surfaces of walls and applying two coats of cement base paint over a coat white wash complete all as specified and directed.

Preparation of new steel surfaces exc 10 cm width or girth and applying two coats of syntetic enamel paint over one coat of red oxide of zinc chrome primer complete all as specified & directed .

UTTRAKHAND BUILDERS

M/S ABHISHEK ENTERPRISES

MOHINDER SINGH AND SONS

M/S SAJJAD HUSSAIN CONTRACTOR

M/S Gupta Builders

dm enterprises