GENERAL Old Mavoor road at Kovoor Restoration Urgent restortation works to the Old Mavoor road (Between KM 0/ 000 and 0/430 ) at Kovoor Due to the Cutting made by KWA for laying water supply lines Under Amruth Project General Civil Work

Amount

Reformation works

3.6:Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m

OD37164/2021-2022:Filling with granular material in the areas where the soil is of slushy in nature to achieve adequate bearing capacity and as a drainage layer laid in line and level compacted with plate vibrator etc complete as per Technical Specification and as directed by the Engineer in charge. (Derived from 13.9.A)

4.1.B.1:Construction of granular sub-base by providing graded material, spreading in uniform layers with a motor grader on a prepared surface, mixing by mix in-place method with rotavator at OMC, and compacting with a vibratory roller to achieve the desired density, complete as per clause 401. Grading-V - For sub-base cum drainage layer - Mix in Place Method

4.12:Providing, laying, spreading and compacting graded stone aggregate to Wet Mix Macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.

5.1.a:Providing and applying primer coat with bitumen emulsion ( SS) on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.70 - 1.0 kg/sqm using mechanical means.

5.2.a:Providing and applying tack coat with bitumen emulsion( RS) using emulsion pressure distributor at the rate of 0.20 - 0.30 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.

5.8.d:Providing and laying surface dressing as wearing course in single coat using crushed stone aggregates of specified size on a layer of bituminous binder (VG - 30) laid on prepared surface and rolling with 8-10 tonne smooth wheeled steel roller. Grading IV - (6 mm nominal chipping size)

5.7.2:Providing, laying and rolling of close-graded premix surfacing material of 20 mm thickness composed of 13.2 mm to 0.09 mm (Type-B) aggregates using viscosity grade bitumen ( VG - 30) to the required line, grade, and level to serve as wearing course on a previously prepared base, including mixing in a suitable HMP of appropriate capacity not less than 75 tonnes/hour., laying and rolling with a Smooth wheeled roller 8-10 tonne capacity, and finishing to the required level and grade.

mammoo

ASHIK VISWANATH

DASAN P

Bidder Name

ANJANA CONSTRUCTIONS

mammoo

DASAN P

ASHIK VISWANATH