IBP New Roaster and Old Roaster Area Rain Water Flooding Rectification

Demolishing RCC

Demolishing R.C.C. work manually / by mechanical means including stacking of steel bars and disposal of unserviceable material with in 50 metres lead as per direction of Engineer -in-Charge.

Earthwork Excation

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5m, as directed by Engineer-in-charge.All kinds of soil

Red earth filling works

Supplying and filling in plinth with red earth under floors, basement etc including watering, ramming with plate compactor, consolidating and dressing complete.

Bailing out Water

Bailing out water using pump above 5 HP and Up to 10 HP-Bailing out water with engine and pump set above 5HP and up to 10HP, including conveyance to site and erection,cost of fuel, lubrication oil and other stores, pay of staff etc complete

Soling

Soling with rough stone of size 200 mm, well packed and filling voids with stone chips and required profile with hammer dressed stones having no side less than 15cm, with minimum depth of 20 cm including preparing the bedding surface etc. all complete

PCC for drainage widening and Retention pit

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (1 Cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded. (Cement shall be supplied by KMML) stone aggregate 40 mm nominal size derived from natural sources)

RCC works

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering finishing and reinforcement- All work up to plinth level 1:1.5:3 (1 cement: 1.5 coarse sand: 3 grade stone aggregate 20 mm nominal size. Required cement shall be supplied by KMML

Steel reinforcement for RCC work

Supply of Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. Thermo - Mechanically Treated bars of grade Fe-500D or more (Note: TMT Steel reinforcement bars of approved make shall be supplied by the contractor).

Centering and shuttering work upto plinth level

Centering and shuttering including strutting, etc. and removal of form for: Foundations, footings, bases of columns, etc for mass concrete

Centering and Shuttering above plinth level

Centering and shuttering including strutting, etc. and removal of form for: Walls (any thickness) including attached pilasters, butteresses, plinth and string courses etc.

Providing black sheet below Concrete works

Providing, laying and fixing polythene sheets of 400 gauge, each sheets overlapped by10 cm etc complete as per the instructions of engineer-in-charge

VDF Floor concreting

Providing and laying R.C.C pavement of mix M-25 with site batched design mix cement concrete which shall be laid and finished with screed board vibrator, vacuum dewatering process and finally finished by floating brooming with wire brush etc. complete as per specifications and directions of Engineer-in-charge ( The panel shuttering work shall be paid for separately). The cement shall be supplied by KMML

Area Sectioning

Sectioning - Area grading/ Sectioning not exceeding 30 cm in depth but exceeding 1.5m in width as well as 10 sqm on plan including disposal of excavated earth up to 50 m and lift up to 1.5 m, disposed soil to be levelled and neatly dressed; All Kinds of soil