Provn of Store shed near Kitchener Line Kote at GRRC Lansdowne under GE Lansdowne

Amount

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth in soft/disintegrated rock and getting out complete all as specified and directed.

M&L PCC 1:4:8 type D-2 (using 40mm graded stone aggregates) foundation fillings and mass concrete complete all as specified and directed.

M&L for RCC 1:2 :4 type B-1 (Nominal Mix) (using 20 mm graded stone aggregate) as in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified & directed

M&L for RCC 1:2 :4 type B-1 (Nominal Mix) (using 20 mm graded stone aggregate) as in Columns, pillars, piers, posts and struts complete all as specified and directed

M&L for RCC 1:2 :4 type B-1(using 20 mm graded stone aggregate) as in Beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed.

M&L for RCC 1:2 :4 type B-1(using 20 mm graded stone aggregate) as in landings, cover slabs (for man holes etc.) chullah hoods, chajjas, water troughs, mangers, shelves and similar articles with plain faces complete all as specified and directed.

M&L Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

All as per item No 7 above but 6 to 8 mm dia .

All as per item No 7 above but 5 mm dia and over upto and including 10mm dia as in stirrups spacers and binders etc.

Formwork to flat, rough finished surfaces of concrete, sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified and directed

Formwork to flat, rough finished surfaces of concrete, sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including sup- ports, overhangs, etc. also splays between floors and beams, etc complete all as specified and directed

Formwork to flat, rough finished surfaces of concrete, sides of pillars, posts, struts, piers, columns and stanchions shape as square, rectangular or polygon complete all as specified and directed.

Formwork to rough finished surfaces of concrete,chullah hoods, chajjas, troughs and similar items including edges comlplete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in soft/loose soil complete all as specified and directed.

Removing excavated materials n exc 50 mtrs and deposited where directed at a level n exc 50 mtr where directed n exc 1.50 m above the starting point complete all as specified and directed.

M&L Brick work with sub class B brick, straight or curved on plan exc 6 mtrs mean radius and built in cement mortar 1:6 complete all as specified and directed.

M&L 40mm thick DPC in cement concrete 1:2:4 type B-0 mixing with liquid water proofing admixture as per manufacturer instructiions including necessary form work (WPA shall be measured & paid seperateley)

Supply only water proofing compound complete all as specified and directed.

Filling of earth under floors, spreading, levelling in layers n exc 25cm and well raming including watering all as specified and directed.

M&L Broken bricks hardcore of gauge 63mm deposited spread and levelled in layers n exc 15 cm thick watered and rammed to a true surface complete all as specified

M&L 75mm thick PCC 1:4:8 type D2 using 40mm graded agg as in sub base of floor etc complete all as specified and directed.

M&L 40 mm thick PCC 1:2:4 type B1 using 20 mm graded agg as in sub base of floor etc complete all as specified and directed.

M & L for 38 mm width Glass dividing strips, 3 mm thick and ditto

M&L 75mm thick PCC 1:3:6 type C-1 as in plinth protection, path etc finished the surface even & fair complete all as specified

Forming Contraction (Dummy) joints 65mm deep x 10mm wide, filled with sealing compound Grade 'B'.

Material & labour for rendering 10 mm thick on other than fair faces of brick work or concrete surfaces in CM (1:6) complete all as specified and directed.

Material & labour 5 mm thick rendering in CM 1:4 on concrete surfaces in ceiling complete all as specified

M/L 15mm thick rendering in CM 1:4 on fair faces of brick or concrete surfaces complete all as specified & directed.

M&L preparing of old plastered or un plastered surface of walls and applying two coats of white wash complete all as specified and directed.

Preparation of newly plaster surface of ceiling and applying three coats of white wash complete all as specified.

Preparation of newly plaster surface of wall and applying two coats of cement base paint complete all as specified.

Supply & fix steel ventilators with top hung shutter including hinges ,steel peg stay,complete all as specified and directed.

Supply & fix Steel windows with side hung shutters including projecting type hinges with steel handle, and steel peg stay, complete with glazing bars, dovetailed or welded complete all as specified and directed.

Supply & fix Steel door including projecting type hinges, steel handle, complete, with glazing bars, dovetailed or welded

Supply & fix Framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165 complete all as specified & directed.

Supply and fixing of sheet glass ordinary quality and glazing with oil putty or beads in square n exc 0.50 Sqm in each pane thickness of glass 3mm.

S & F for Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.11611979 grade St.-240

S & F for Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment Fe-410W(GdeE-250) qualityB

S & F Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm of an colour having tensile strength of 550Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all as specified and directed.

S & F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified

Material & labour for preparation of new or old previously untreated steel surface of any description over 10cm width or girth and applying two coat of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

Surface excavation not exceeding 30 cm deep and averaging 15 cm deep and getting out in soft and disintegrated rock complete all as specified and directed by Engineer-in-Charge.

Removing excavated materials not exc 50m and depositing where directed at a level n exc 1.5 m above the starting point complete all as specified and directed by Engineer-in-Charge.

M&L for 100 mm thick PCC Type B-2,1:2:4 (40 mm graded aggregate) in sub-floors, sub-bases, foors and pavings etc complete all as specified and directed.

M&L 15 mm thick in cement mortar 1:6 screed bed or bedding layer of mortar for laying floor finishes as directed.

Chequered cement concrete tiles 20cm x 20cm x 25mm thick, set, jointed and pointed in neat cement slurry in floors with gray cement pigments

M&L for point wiring concealed type upto wall height and open with conduit after wall height with 1.5sq mm PVC insulated unsheathed single core multithreaded copper conductor cable 1100 volts grade incl 1.5sq mm PVC insulated unsheathed copper conductor cable as earth continuity conductor drown through in and incl PVC rigid conduit not less than 20mm dia with its accessories with provn of CI/pressed steel terminal switch box and white bakelite plastic laminated top sheet cover and fixed with brass screws cup washer for fixing switches/socket/regulators etc for the following (Make of Cable : Finolex/RR Cable/Havells & Make for Conduit : AKG/PRESTOPLAST/PRECISION ): -

One light/fan/bell point controlled by one No piano type switch 5 AMPS single pole one way

One 3 pin 5 Amps socket outlet on same board controlled by one, one way 5 Amps piano switch.

One socket outlet 5/3 pin 5 Amps controlled by one switch on independent board.

Material and labour for power point wiring for one 15 Amp switch socket combined outlet point on Independent Board with 2.5 Sqmm PVC insulated unsheathed,stranded copper conductor cable single core 1100V grade with in and including rigid PVC conduit 20mm or higher size medium grade in concealed manner with all PVC conduit accessories with provision of CI/pressed steel terminal switch box & white bakelite plastic laminated top sheet cover fixing with brass screws and cup washers and 1.5Sqmm PVC insulated unsheathed stranded copper single core 1100V grade as earth wire & wire connected with the main earth point all as specified & directed. (Make of Cable : Finolex/RR Cable/Havells & Make for Conduit : AKG/PRESTOPLAST): -

S&F Switch Piano Flush button single pole one way 5 Amp

S&F socket outlet flush type 3/5 pin 5/6 Amps 230V AC all as specified and directed.

S&F switch piano flush single pole one way 15/16 Amps all as specified and directed.

S&F socket outlet flush type 5/6 pin 15 Amps 230V AC all as specified and directed.

Supply & fixing lamp holder (Angular/Straight ), insulated body, with back plate for batten fitting complete all as specified & directed

M&L ceiling rose 3 terminal / PVC/ polycarbonate, isolated body.

S&F MCB DB SPN 8 way ,240 volts, double door with 200 Amp rated copper busbar in sheet steel enclosure. Make : Legrand/Schneider/Hagar

Supply & fixing MCB , SP, AC, 240 volts of 06 to 40 Amps capacity 10KA, 'B' series and making connections with suitable size of copper lugs complete all as specified & directed. Make : Legrand/Schneider/Hagar

Supply & fixing MCB SPN 40 Amps, 240 volts ,10KA, 'B' series and making connections with suitable size of copper lugs complete all as specified & directed. Make : Legrand/Schneider/Hagar

Dummy Plates for MCB DB's

S&F 1100 volt grade heavy duty cable PVC insulated aluminium conductor, served with inner seathing of PVC tape and overall PVC seathed in service of PVC seathed in service connections sus-pended by insulating hangers not more than 1 metre apart including 4 mm suspension wire. one twin core cable flat or circular of size 10 sq mm 2 core multistranded.

S&F suspended LED Tube light fitiing 20 Watt with all accessories including its connection with 2 core seathed copper conductor cable of size 0.5 Sqmm with complete with all accessories all as specified & directed Make ; Philips/ Havells / Wipro.

S&F in replacement energy saving and environmental friendly long life LED street light 25 Watt (Bldg security light) made up of pressure die cast aluminium housing with mild power LED as lighting source and PC cover having TOP Opening seperate driver compartment with IP65 protection and impact resistance of IK07 fixed on wall with GI pipe of suitable dia and all fixing accessories including connecting up with twin core twisted flexible copper conductor cable with suitable size of 230V , 50 HZ all as specifified & directed. Make: Havells Endura Pearl 25W MP/Philips/Wipro

S & F Lumeno LED Bulb 10 Watt (cool day light) having colour temp 6500 K and lumen output 950 suitable for "B-22 type to fix on batten holder Make ; Philips/ Havells / Wipro.

Earthing complete with galvanized earth plate electrode 600x 600 x 6mm thick buried directly in ground (earth pit not less than 2.25mtr deep below ground level) with top edge of the plate not less than 1.5mtr below ground level connected to galvenised earth lead wire of 4 mm dia by means of nuts, bolts, washes of galvanized iron or steel all as shown in electrical plate No 5 and testing on completion including adequate charcoal dust comman salt necessary excavation & earth work PCC(1:3:6) type C-1 pit with precast RCC Cover slab 40 mm thick in PCC(1:2:4) type B-0 reinforced with 6 mm dia MS bars @ 100 mm c/c both ways with funnel wire mesh and 20 mm dia GI pipe medium grade as watering pipe complete all as spfd and as directed. connected to earthing list point all as specified and as directed.

Supply & fixing House service bracket (hook type complete with 3.0m long G. I. pipe 40mm dia Med. Grade, two nos 90⁰ bends. M.S. hook and stay guy complete all as specified & directed

S D Constructions

PIONEER REFRIGERATION AND ELECTRICALS