Construction of New Judicial Court Complex at Khanna Distt Ludhiana (Electrical Services)

Cost of 4 no's Passenger Lift's FOR JUGDES IN MAIN JCC BUILDING:- Type and Capacity : Approximately 884 Kg( Wide) , 13 Passengers Lift without Machine Room Speed: 1.0 Meter per second Type of drive: AC Variable Voltage Variable Frequency with 16-Bit Microprocessor. Motor: Permanent Magnet Gearless Machine to be hoisted on the top of guide rail within the elevator hoist way Travel: Approximately 9 Meter (Ground to Second Floor) Serving: 3 Floors 3 Stops 3 Openings 3 Levels (All on the same side) Hoist way : 1875mm (Deep) x 2550mm (Wide) Clear dimensions Headroom Height (HR): 5000mm beyond finished floor level of last landing Pit Depth : 1600mm below the finish floor level of first landing Car Size Area: Minimum 2.06 square meter & Maximum 2.20 square meter Car Enclosure : Constructed out of stainless steel finish panel in Scratch Resistance/ Vandal proof Car Entrance: Center Opening Automatic Doors with vision panel of Stainless steel finish panel in Scratch Resistance/ Vandal proof with a clear opening of 800/900mm (wide) x 2000mm (high) fire retardant door upto 2 hours.

Hoist way Entrance: Center opening Automatic Door's with vision panel (Upto 40% area should be visible by glass) of Stainless steel finish panel in Scratch Resistance/ Vandal proof with provision of emergency key opening at landings with a clear opening of 800/900mm (wide) x 2000mm (high) Door operation : Automatic DC Door operation with adjustable door opening and closing timings Control: Simplex full selective collective control with and without attentdent Operation: Automatic Power Supply: 415 Volts, 3- phase, 50Hz Alternating Current Flooring: Floor Skid - Resistant as per standard Fan: Blower Fan in Car for ventilation with Auto cut off Lighting: LED for Car Lighting Indicators: LED Dot matrix / Digital 3 segement direction and position indicators in the car and at all landings Hand Rail: Stainless Steel round Hand rail not less than 600mm long at 900mm above floor level (Side LH,Side RH & Rear) Call Button Height: Call button (Outside the lift) placed at a height between 800mm-1meter from the floor level Control Panel Height: Control panel placed at a height between 800mm-1meter from the floor level

Other Features : 1. Battery operated emergency light with rechargeable battery 2. Battery operated emergency alarm with rechargeable battery 3. Adjustable Guide shoes 4. Micro movement LED based buttons 5. Door Open and Close buttons 6. Emergency Intercom provided inside the elevator 7. Emergency Intercom usable without the voice communication 8. Load weighing device with overload bypass feature and Overload function with Audio Visual Indication 9. Steel items, door frames sill angle's, fascia plates, spring buffers 10. Automatic phase reversal device and Phase Failure protection 11. Call registration 12. Audio & Video System installted in the lift indicating arrival at a floor 13. Manual break lever 14. Additional car gate lock

15. Automatic break testing infrared safety curten 16. Braille Buttons (Inside and outside) with Braille instructions for the communication system 17. Kick plate/Skirting 18. Lift anoucement system to announce floor level's in english language only and indication of door for entrance / exit is either Open or Close. 19. Car Operating Panel 20. Car plateform constructed out of cold rolled grain oreinted formed sheets of steel 21. Phase two device fire man drive 22. Fire Man switch at main lobby 23. Car false ceiling in stainless steel 24. Pit ladder 25. Anti Nuisance car call protection 26. Door Nudging 27. Automated Resuce Device to bring the elevator to the nearest landing in case of power failure. 28.The use of visually and acoustically reflective wall surfaces should be minimized within the lift car as visual reflections can cause discomfort and affect the visual acuity of people with impaiments. 29. The Floor of the lift car should be slip resistant and have similar frictional qualitites to the floor of the lift landing to decrease the risk of stumbling 30. The Provision of a mirror on the wall of the lift car opposite the lift door is a postive aid to navigation for wheelchair users, Its allows the wheelcahir user to see if anyone is behind them and also to see the Floor indicatior panel. The mirror should not extend below 900mm from the lift door to avoid confusing people with impaired sight. 31.The emergency communication system should be coupled with and induction loop system installed all around the lift. Telephone units. where provided, should have an inbulit inductive coupler to aiist person using hearing aids. passenger lift to be provided, which allows easy maneuverability of wheelchair user.

FOR PASSENGER IN MAIN JCC BUILDING :- Type and Capacity : Approximately 884 Kg( Wide) , 13 Passengers Lift without Machine Room Speed: 1.0 Meter per second Type of drive: AC Variable Voltage Variable Frequency with 16-Bit Microprocessor. Motor: Permanent Magnet Gearless Machine to be hoisted on the top of guide rail within the elevator hoist way Travel: Approximately 12 Meter (basement+Ground to Second Floor) Serving: 4 Floors 4 Stops 4 Openings 4 Levels (All on the same side) Hoist way : 1875mm (Deep) x 2550mm (Wide) Clear dimensions Headroom Height (HR): 5000mm beyond finished floor level of last landing Pit Depth : 1600mm below the finish floor level of first landing Car Size Area: Minimum 2.06 square meter & Maximum 2.20 square meter Car Enclosure : Constructed out of stainless steel finish panel in Scratch Resistance/ Vandal proof Car Entrance: Center Opening Automatic Doors with vision panel of Stainless steel finish panel in Scratch Resistance/ Vandal proof with a clear opening of 800/900mm (wide) x 2000mm (high) fire retardant door upto 2 hours

Hoist way Entrance: Center opening Automatic Door's with vision panel (Upto 40% area should be visible by glass) of Stainless steel finish panel in Scratch Resistance/ Vandal proof with provision of emergency key opening at landings with a clear opening of 800/900mm (wide) x 2000mm (high) Door operation : Automatic DC Door operation with adjustable door opening and closing timings Control: Simplex full selective collective control with and without attentdent Operation: Automatic Power Supply: 415 Volts, 3- phase, 50Hz Alternating Current Flooring: Floor Skid - Resistant as per standard Fan: Blower Fan in Car for ventilation with Auto cut off Lighting: LED for Car Lighting Indicators: LED Dot matrix / Digital 3 segement direction and position indicators in the car and at all landings Hand Rail: Stainless Steel round Hand rail not less than 600mm long at 900mm above floor level (Side LH,Side RH & Rear) Call Button Height: Call button (Outside the lift) placed at a height between 800mm-1meter from the floor level Control Panel Height: Control panel placed at a height between 800mm-1meter from the floor level

Other Features : 1. Battery operated emergency light with rechargeable battery 2. Battery operated emergency alarm with rechargeable battery 3. Adjustable Guide shoes 4. Micro movement LED based buttons 5. Door Open and Close buttons 6. Emergency Intercom provided inside the elevator 7. Emergency Intercom usable without the voice communication 8. Load weighing device with overload bypass feature and Overload function with Audio Visual Indication 9. Steel items, door frames sill angle's, fascia plates, spring buffers 10. Automatic phase reversal device and Phase Failure protection 11. Call registration 12. Audio & Video System installted in the lift indicating arrival at a floor 13. Manual break lever 14. Additional car gate lock

15. Automatic break testing infrared safety curten 16. Braille Buttons (Inside and outside) with Braille instructions for the communication system 17. Kick plate/Skirting 18. Lift anoucement system to announce floor level's in english language only and indication of door for entrance / exit is either Open or Close. 19. Car Operating Panel 20. Car plateform constructed out of cold rolled grain oreinted formed sheets of steel 21. Phase two device fire man drive 22. Fire Man switch at main lobby 23. Car false ceiling in stainless steel 24. Pit ladder 25. Anti Nuisance car call protection 26. Door Nudging 27. Automated Resuce Device to bring the elevator to the nearest landing in case of power failure. 28.The use of visually and acoustically reflective wall surfaces should be minimized within the lift car as visual reflections can cause discomfort and affect the visual acuity of people with impaiments. 29. The Floor of the lift car should be slip resistant and have similar frictional qualitites to the floor of the lift landing to decrease the risk of stumbling 30. The Provision of a mirror on the wall of the lift car opposite the lift door is a postive aid to navigation for wheelchair users, Its allows the wheelcahir user to see if anyone is behind them and also to see the Floor indicatior panel. The mirror should not extend below 900mm from the lift door to avoid confusing people with impaired sight. 31.The emergency communication system should be coupled with and induction loop system installed all around the lift. Telephone units. where provided, should have an inbulit inductive coupler to aiist person using hearing aids. 13 passenger lift to be provided, which allows easy maneuverability of wheelchair user.

FOR MULTILEVEL PARKING:- Type and Capacity : Approximately 884 Kg( Deep) , 13 Passengers Lift without Machine Room Speed: 1.0 Meter per second Type of drive: AC Variable Voltage Variable Frequency with 16-Bit Microprocessor. Motor: Permanent Magnet Gearless Machine to be hoisted on the top of guide rail within the elevator hoist way Travel: Approximately 9 Meter (Ground to Second Floor) Serving: 3 Floors 3 Stops 3 Openings 3 Levels (All on the same side) Hoist way : 2667mm (Wide) x 2184mm (Deep) Clear dimensions Headroom Height (HR): 5000mm beyond finished floor level of last landing Pit Depth : 1600mm below the finish floor level of first landing Car Size Area: Minimum 2.06 square meter & Maximum 2.20 square meter Car Enclosure : Constructed out of stainless steel finish panel in Scratch Resistance/ Vandal proof Car Entrance: Center Opening Automatic Doors with vision panel of Stainless steel finish panel in Scratch Resistance/ Vandal proof with a clear opening of 800/900mm (wide) x 2000mm (high) fire retardant door upto 2 hours

Hoist way Entrance: Center opening Automatic Door's with vision panel (Upto 40% area should be visible by glass) of Stainless steel finish panel in Scratch Resistance/ Vandal proof with provision of emergency key opening at landings with a clear opening of 800/900mm (wide) x 2000mm (high) Door operation : Automatic DC Door operation with adjustable door opening and closing timings Control: Simplex full selective collective control with and without attentdent Operation: Automatic Power Supply: 415 Volts, 3- phase, 50Hz Alternating Current Flooring: Floor Skid - Resistant as per standard Fan: Blower Fan in Car for ventilation with Auto cut off Lighting: LED for Car Lighting Indicators: LED Dot matrix / Digital 3 segement direction and position indicators in the car and at all landings Hand Rail: Stainless Steel round Hand rail not less than 600mm long at 900mm above floor level (Side LH,Side RH & Rear) Call Button Height: Call button (Outside the lift) placed at a height between 800mm-1meter from the floor level Control Panel Height: Control panel placed at a height between 800mm-1meter from the floor level