Loading…
India Infra Updates on WhatsApp
Join the Tenderkart WhatsApp channel for India Tender Updates
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | 1₹8.2 LAccepted-AOC | 1 | Accepted-AOC L1 | |
| 2 | 2₹9.8 L+₹38,425.70 (4.10%)Rejected-Finance GOVT ELECTRICAL CONTRACTOR C VILLAGE HAT PO BAJAURA TEHSIL BHUNTAR DISTRICT KULLU HP 175125 | KULLU | HIMACHAL PRADESH | 175125 | 2 | Rejected-Finance 2 |
Tender Value
₹7.7 L
EMD Value
₹15,490
Closing Date
22 Feb 2024, 11:00 amClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Executive Engineer
Jal Shakti Division Bilaspur
Improvement of LWSS Jungle Sungle Harizan Basti village Jungle Sungle and Nichla in Tehsil Sadar District Bilaspur (SH Construction of storage tank at Node A, 41KL litr capacity and Node-B-RCC storage tank 17 KL litr capacity and laying jointing of G
2024_HPIPH_85740_1
BLP-BLP-00736 NIT No. 27568-667 dated 12/02/2024
Open Tender
Civil Works
Item Rate
90 days
Sub Division Bilaspur Section Store
Please refer Tender documents.
8 documents required · 8 mandatory
₹400
EE JSV Bilaspur
₹15,490
Yes
23 Apr 2024
13 Feb 2024
22 Feb 2024
13 Feb 2024
22 Feb 2024
13 Feb 2024
Amount
Excavation in foundation and trenches etc. in earth work in all lead and lifts in all kinds of soil such as pick work, jumper work, blasting work in soft/hard rock chiseling/wedging out of rock) where blasting is prohibited saturated soil including bailing/pumping out of water stacking the excavated soil in 15cm layers, when required into plinths, sides of foundation etc. consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as directed with in all leads and lifts and to the entire satisfaction of the Engineer-in-charge.
Providing and laying cement concrete 1:3:6 (1cement: 3sand: 6 graded stone agg. 20mm nominal size) excluding the cost ofcentering & shuttering in foundation and plinth in all leads and lifts.
Providing and laying cement concrete 1:1.5:3 (1cement: 1.5 sand:3 graded stone aggregate 20mm nominal size) and curing complete excluding the cost of form work and reinforcement for reinforced concrete work in :-
Foundation footings base of columns and the like and mass concrete and to the entire satisfaction of the Engineer-in-charge.
Wall any thickness but not less than 0.1mtr thickness attached pilasters, buttresses, plinth and string courses etc. from top of foundation level up to floor two level and to the entire satisfaction of the Engineer-in-charge.
Lintle beams, girders bressumers and contilevers upto any floor level and to the entire satisfaction of the Engineer-in-charge.
Arches (dome etc) upto any spain and to the entire satisfaction of the Engineer-in-charge.
Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a fair finish including centering shuttering, strutting and propping etc. with wooden battens and ballies, height of propping and centering below supporting floor two ceiling not exceeding 4 mtr and removal of the same for in-situ reinforced concrete and plain concrete working:-
Vertical surfaces such as walls (any thickness) partitions and the like including attached pilasters buttresses, plinth and string courses and the like and to the entire satisfaction of the Engineer-in-charge.
IN beams,cantilevers,girders and lintles sides and soffits of beam haunching cantilevers, bressumers and lintel not exceeding 1.00 mtr in depth in all height from floor and to the entire satisfaction of the Engineer-in-charge.
Providing form work ordinary timber plankings so as to give a rough finish including centring, shutteirng structting and propping etc. height of proping and centring below supporting floor two ceiling not exceeding 4 mtr and removal of the same for insitu-reinforced concrete and plain conctete workin:-
In slopes or battering surfaces including foldere plates where inclination to horizontal plane exceeds 30 degree where shuttering may be provided both on under side if required only the area of under side shall be measured for pavement arches etc.(Arches exceeding 6.00 mtr span).
Providing laying of tor steel reinforcement for RCC work including bending binding and placing in position complete in all depths and heights and to the entire satisfaction of the Engineer-in-charge.
Providing and fixing cast iron manhole cover 500mm internal diameter including frame weight 116kg (The weigh tof rame 58kg and cover weight 58kg) and to the entire satisfaction of the Engineer-in-charge.
Providing and fixing MS angle iron 65mmx65mmx5mm thick ladder for manhole to bottom of tankand ground level totop of rood (dome) upto manhole within all leads and lifts and to the entire satisfaction of the Engineer-in-charge.
Providing and fixing MS mosquito proofing ventilators 300mm cia x300mm dia 300mm height in all leads and lifts and to the entire satisfaction of the Engineer-in-charge.
Providing jointing and fixing of GI pipe (Medium class) welded with MS flange table-5 including cost of nuts, bolts, ferrado make gaskets 4mm thick complete in all respect.
Inlet piope 80mmdia, outlet pipe 80mm dia, Over flow pipe 80mm dia and Scour pipe 80mm dia (6 Rmt each).
Manufactguring and fixing of G.I pipe bend different dia (Medium class) of different degrees including welding of Msflange including welding of MS flange tbale-5 both the ends of bend including the cost of nuts and bolts but excluding the pipes within allleads and lifts
Inlet pipe 80mm doa 90 degree=4 Nos, Outlet pipe 80mm dia 90 degree=4Nos,Over flor poipe 80mm dia 90degree=2Nos and Scour pipe 80mm dia 90degree=2Nos.
Providing and fixing CI sluice valve of Leader / Kartar/Bir make of following dia (with hand wheel) as per IS: 780-1984 class-1 upto 300mm dia i/c brass spindle and as per 2906-1984 class-II for dia> 300mm) complete with bolts, nuts, rubber insertion etc. (the tail piece if required shall be measured and paid for separately).
Outlet pipe 80mm dia and Scour pipe 80mm dia
Finishing wall with water proofing cement paint of approved brand and manufacture and of required shade on undecorated wallsuraces ( two coats) to give an even shade after thoroughly brushing the surface to remove all dirt, dust and remained of loose powdered materials within all leads and lifts and to the entire satisfaction of the Engineer-in-charge.
Laying, Jointing and testing galvanized mild steel tube screwed and socketed in trenches of 25mm dia including tube fittings such as bends, tees, reducers, unions etc. complete and to the entire satisfaction of the Engineer-in-charge (earth work in trenches to be measured and paid for separately).
Providing and fixing full gun metal ball vlave gun metal ball vlave of Standard / ISI make (Standard) with wheel of 25mm dia meters complete with in all leads and lifts and to the entire satisfaction of the Engineer-in-carge.
VINOD KUMAR
stage.html
html • 0.04 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.04 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .