Constt Of Cremation Shed and allied at Shamshanghat o Wno 3 4 and 7

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (not exceeding 1.5 m in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, including dressing of sides and ramming of bottoms lift upto 1.5 m, including getting out excavated earth and disposal of surplus excavated earth as directed. All kinds of soil.

Providng and laying in position cement concrete of specified grade in excluding cost of centering, shuttering all work upto plinth level 1:5:10 (1 cement : 5 coarse sand : 10 graded crushed 40mm agg.) including all leads, lifts and carriages complete.

Providng and laying in position cement concrete of specified grade in excluding cost of centering, shuttering all work upto plinth level 1:3:6 (1 cement : 3 fine sand : 6 graded crushed 20mm agg.) including all leads, lifts and carriages complete. 70% PCC

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete Welded.

Providing and fixing precoated galvanized iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

Providing ridges or hips of width 60cm overall width plain G.S. sheets fixed with polymer coated J. or L hooks, bolts and nuts 8mm dia G.I. limpet and bitumen washers complete.0.50 mm thick with zinc coating not less than 275 gram/m2

Centering and shuttering including strutting, propping etc. and removal of form for:

Sand/Bajree for an avg. lead of 50 Kms

Add cost of sign Board