REPAIR TO BOUNDARY WALL, FENCING GATE AT DEESA AIRFIELD UNDER GE (AF) BARODA

Amount

Demolition of brickwork or stone/boulder masonry built in cement mortar incl all quoins, arches pillars etc but excluding ashlar facings complete all as specified and directed

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed

Taking down cement plaster on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water, etc complete all as specified and directed

Demolition of cement Concrete (unreinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed

Demolition of cement Concrete (unreinforced in ground floors and pavings n exc 15 cm thickness (below or above ground level) complete all as specified and directed

Dismantling fencing wire mesh, any type complete all as specified and directed

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed

M&L for PCC 1:4:8 mix type D2 (using 40mm graded stone aggregate) in foundation, filling and mass concrete complete all as specified and directed

M&L, for reinforced cement concrete (Nominal mix) type A1 1:1/2:3 mix (20mm graded aggregates) for Foundations, including rafts, footings, plinth beam, Columns, pillars, piers, post and struts and mass concrete complete all as specified and directed.

Formwork to sides of concrete foundations,footings, base of columns, raft and raft beams, side and soffits of foundations ,plinth beams and similar work vertical or to batter complete all as specified and directed.

Formwork to side of pillars, posts struts, piers, columns and stanchions complete all as specified and directed.

M&L for 10mm dia and over, TMT bars, cut to length, bent to shape required including cranking, bending spirally for hoping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Description all as per item Ser No 12.00 above but 5mm dia and over upto and including 10mm dia as in stirrups complete all as specified and directed

M&L for old size Brickwork with fly ash bricks straight or curved on plan exc 6 m mean radius in CM 1:6 complete all as specified and directed

M&L for Brickwork (Except bricks) straight or curved on plan exc 6 m mean radius in CM 1:6 complete all as specified and directed

M&L for Pre-cast cement concrete block using cement concrete type C-1 1:3:6 mix (20mm graded aggregate) masonry with solid blocks, exc. 10 cm in width and setting in mortar 1:6 complete all as specified and directed

M&L for PCC, 1:2:4 mix, type B1 (20mm graded agg) in coping and similar work, incl necessary form work complete all as specified and directed.

M&L for rendering 15mm thick cement plaster in CM 1:4 using integral waterproofing compound @ 3% by weight of cement on fair faces of brick or concrete surfaces finished even & smooth without using extra cement complete all as specified and directed. Note:-Supply only of W P C shall be measured and paid separately.

Preparation of newly plastered surfaces of walls priming plastered and other surfaces with alkali-resistant priming paint and applying two coats of cement base paint (colour as approved by GE) complete all as specified and directed.

M&L for prepration on the existing surfaces on wall/concrete surfaces throughly, washing rubbing down in the water, cleaning upto the entire satisfaction of the Engineer-in-Charge and apply one coat of cement base paint colour as approved by GE complete all as specified and directed.

Forming embankments including raising (or lowering) earth, spreading in layers n exc. 30 cm thick; watering, ramming/rolling and finishing to required size, shape, etc. n,exc. 1.5 m high from base complete all as specified and directed.

M&L for hardcore of broken stone or boulder of gauge n exc 63mm, deposited, spread and levelled in layers n exc 15cm thick, watered and rammed to a true surface complete all as specified and directed.

M&L for 100 mm thick cement concrete 1:3:6 type C-2 using 20mm graded stone aggregate as in sub base complete all as specified and directed.

M&L Forming Construction joint 10mm deep x 10mm wide filled with sealing compound complete all as specified and directed.

M&L for 75 mm thick using cement concrete type C2 1:3:6 mix (40 mm graded aggregate) as in plinth protection complete all as specified and directed

Supply only Chain link MS galvanisd fencing, any size or type complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.

S&F, angle iron (Fe-310) as in posts, struts in fencing including cutting top to shape required, drilling holes, notching for wire etc complete all as speciified and directed

S&F Mild Steel flat iron including necessary drilling hole bolting or reveting etc and similar work complete conforming to Fe -290 Gde E - 165 complete all as speciified and directed

S&F in repair Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc complete all as specified and directed

S&F 600mm dia Galvanised concertina wire coil 2.50mm dia fixing to any type of standard rails/angles straining bolts, including, securing or tying at crossings with and including provision of galvanised wire (0.9mm dia) complete all as specified and directed

M&L for MS round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed

M&L for Mild Steel framed work as in doors or gates of angle or other section with gusset plates, rails, braces,etc. complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete con- forming to Fe.290 Gde-E-165 complete all as specified and directed.

M&L for preparation of new surfaces of steel or iron over 10cm width or girth and applying two coats of synthetic enamel paint over and including a coat of red oxide zinc chrome primer complete all as specified and directed

Preparation of old painted steel and iron surfaces of any description over 10 CM width or girth and applying one coat of synthetic enamel paint including cleaning window glasses, joinery, electric fittings, wiring etc of drops and splashes and cleaning premises clean and tidy complete all as specified and directed.

Gayatri Associates

OM SREE MAHADEV TRADERS

boon construction company

Devi Engineeing