Rough machining of bodies

Select, Excess (+), Less (-)

Tender Inviting Authority: Paramananda Patra, Engineer/ Valves/Sub-Contracting, BHEL, Trichy

Name of Work: Rough machining of Body

Contract No: ENVFH4882

Name of the Bidder/ Bidding Firm / Company : Vendor Code:

Sl. No. Material Description Material Code Quantity Units Estimated Rate in Rs. P Addition / Deduction Addition / Deduction Values Currency Convertion against each Item Quoted Currency in INR / Other Currency Rate In Figure (INR- Indian Rupee) / Unit GST (If applicable in Percentage) GST Amount in Rs. P SCOPE HSN / SAC Code

10 BODY S/F-H118 935032516000 100 Nos Excess(+) Full Conversion INR SCOPE : MACHINING "BEFORE HARD FACING" AS PER DRAWING EXCEPT PASSAGE HOLE DRILLING AND SEAT WELD PREPARATION. PUNCH 1"-C3500SPL-CV-SW-F92, GROUP NO H118, MELT NO, VENDOR CODE. NOTE : PUNCHING MUST BE DONE ONE AND HALF INCH BELOW FROM THE FLATFACE.

20 BODY S/F-HL15 935023054000 50 Nos Excess(+) Full Conversion INR SCOPE : MACHINING "BEFORE HARD FACING" AS PER DRAWING EXCEPT PASSAGE HOLE DRILLING AND SEAT WELD PREPARATION. PUNCH 1" C3500SPL,CV,GROUP NO HL15,MELT NO ON ONE SIDE AND MATL SPEC F91,VENDOR CODE,GC NO ON OTHER SIDE. NOTE : PUNCHING MUST BE DONE ONE AND HALF INCH BELOW FROM THE FLATFACE.

30 BODY S/F-HG14 932027114000 30 Nos Excess(+) Full Conversion INR SCOPE : MACHINING "BEFORE HARD FACING" AS PER DRAWING EXCEPT PASSAGE HOLE DRILLING, SEAT WELD PREPARATION AND TOP MACHINING. TOP FLAT TO BE MAINTAINED WITH 1.5mm HEIGHT ALLOWANCE. PUNCH BODY SIZE 1" C1500,CV,GROUP NO HG14,MELT NO ON ONE SIDE AND MATL SPEC F91,VENDOR CODE,GC NO ON OTHER SIDE. NOTE:PUNCHING MUST BE DONE ONE AND HALF INCH BELOW FROM THE FLAT FACE.

40 BODY S/F-M980 935032716000 5 Nos Excess(+) Full Conversion INR SCOPE: MACHINING "BEFORE HARD FACING" AS PER DRAWING INCLUDING PASSAGE HOLE DRILLING AND SEAT WELD PREPARATION. PUNCHING MUST BE DONE TWO AND HALF INCH BELOW FROM THE FLATFACE. PUNCH 1-1/2-C3750SPL, GROUP NO M980, MELT NO ON ONE SIDE AND MATL SPEC F91,VENDOR CODE,GC NO ON OTHER SIDE.PUNCH FLOW DIRECTION ARROW MARK AS PER DRAWING.DEBURR AND CLEAN.

Total in Figures

Quoted Rate in Figures Select %

Please Enable Macros to View BoQ information