Heightening, dismantling, diversion and erection of 11KV Overhead lines from 06 no. substation near Kuju new Siding to chatniya basti at Topa Project under Kuju Area.

Erection of pole following length in cement concrete 1;3:6 (1 cement 3 corse sand 6 graded stone 40mm nominal size) foundation including excavation and refilling etc as required above 10.00 metre and upto 12.00

Supply and erection of 11KV pin insulator complete with largest head GI pin, nuts,washer etc as required

Supplying and erection of 11KV disc insulator for 11KV overhead lines with galvainshed insulator

Supply of GI wire 8SWG (Galvanished iron fencing wire (for cradling)

Erection of GI wire no 8 SWG including binding etc as required

Supply of ACSR conductor of 7/3.35mm to7/4 diametere and above including binding etc as required (for erection 50mtr X 6SPN X 3 wire X 394kgP/Km x 1.05 =372.33 Kg)

Supply of channel iron 75mm X 40 MM X 6MM (7.14KG Permetre)pole top bracked/cross arm for single 11KV over head line conductor with 50 mm X 6MM flat iron clamp, bolts,nuts,and washers including drilling holes for insulator pins bolts and nuts etc and painting with primer and finish paint as required

Supply of channel iron 75mm X 40 MM X 6MM (7.14KG Permetre)pole top bracked/cross arm for single 11KV over head line conductor with 50 mm X 6MM flat iron clamp, bolts,nuts,and washers including drilling holes for insulator pins bolts and nuts etc and painting with primer and finish paint as required

Supplying and erection of bow stay sel complete (galvanised)with 19/20 men dia X 1.8 metres long stay rod, anchor plate ofsize 45 cm X 45 cm X 7.5 mm, thamble, stay clamps, turn buckle(20 mm X 60 cm), 7/4.00 mm dia G.1. stay wire and strain insulator etc in cement concrete 1:3:6 (1 cement 3 coarse sand: 6 graded stone aggregate 40 mm nominal size) foundationincluding excavation and refilling and also with 0.6 m long bracecf size 50 mm X 50 mm X 6 mm angle iron with 50 mm dia pullieyfured at one end of the brace as required

Supplying of two lengths of channel iron 75 mm X 40 mm X 6 mm(7.14 kg per mette) double pole cross arm for three wire 11KVover head line conductors complete with through bolts and nuts for clamping to the poles, 50 mm X 6 mm M.S. Bals welded onone side to the channel iron and with balls and nuts on the otherside for tying the cross arms together, including drilling holes forinsulator pins/ fittings, bolts, nuts and wachers etc (as per drawing)and painting with primer and finish paint as required