SITC of Audio System for Auditorium at Regional Training Centre (Harish Chand Mathur Rajasthan Rajya Lok Prashasan Sansthan) at Jodhpur

Amount

Supply of 1 x 15" flyable two way loudspeaker. The speaker cabinet must have HF Transducer of 2" diaphragm compression driver, frequency range (-10dB) of 50 Hz-18 kHz; Frequency Response (-3 dB): 55 Hz-13 kHz, Axial Sensitivity > = 97 dB (1W/1m), delivering Max. Calculated SPL >= 130dB with continuous passive power handling <=500W. The speaker should have a nominal impedance of 8 ohm. The speaker cabinet should have Coverage 60º x 40º or better. Speaker must have 6 or more suspension points for permanent installation. Makes EAW/d&b/EV

SITC of High quality subwoofer with minimum 1x18” LF, Frequency Range (-10 dB): 35 Hz - 300 Hz +/-10Hz is acceptable on both ends of the audio spectrum, Sensitivity: >=96dB, Max SPL: >=132dB , Continuous Power: <=500W, Nominal Impedance: 8 Ohms, with 15mmPlywood/birch plywood paint finish only Makes : EAW/d&b/EV

Supply of 8" two-way permanent installed loudspeaker. The loudspeaker should have frequency range of 50Hz-20kHz (-10dB),having an axial sensitivity≥93 dB SPL or more delivering a max spl of 122dB or more. The loudspeaker should have a nominal impedance of 8 ohms and should have power handling pk ≥800W .The loudspeaker should have a horizontal coverage angle ≥85degree and vertical coverage angle ≥45 degree and should have rotatable horn. Makes : EAW/d&b/EV

Supply of 2 channel class AB power amplifier with inbuilt DSP (Crossover, Eq, Delay, Limiting) Stable Max Midband Output Power >= 2 x 850 @ Ω; Frequency Response, ref. 1 KHz: 10Hz - 21 KHz (±1dB), THD:<0.05%, Max input level >= +21 dBu, input impedence:20 kΩ, Signal to Noise ratio > = 104 dB, Crosstalk < -80 dB with built in protection such as Audio limiters, high temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn on delay. Makes : EAW/Camco/EV/Powersoft/Bittner

Supply of Dual Channel Class H power amplifier with inbuilt DSP, Max Midband Output Power >=950W @ 8 Ω; >=1800W @ 4 Ω & >=3200W @ 2 Ω,Max Bridged Output Power>=6000W @ 4 ohms, Frequency Response, ref. 1 KHz: 10Hz - 21 KHz (±1dB), THD:<0.05%, Max input level >= +21 dBu, input impedence:20 kΩ, Signal to Noise ratio > = 109 dB, Crosstalk < -80 dB with built in protection such as Audio Limiters, output delay per channel,31 band GEQ per channel, PEQ per channel, Makes : EAW/Camco/EV/Powersoft/Bittner

Supply of 16 channel Compact Mixing System (12 x Mic/Line + 4 x Mic/Stereo-Line), Auxiliaries (MON, FX, AUX) : 2 Pre, 2 Post, 2 Pre/Post switchable, Frequency Response, -3 dB, ref. 1 kHz : 15 Hz to 65 kHz, Crosstalk, 1 kHz Channel to Channel < -80 dB, THD at 1 kHz < 0.005%, CMRR MIC input 1 kHz > 80 dB, Dual stereo 24/48-bit multi effects processors, 100 Factory + 20 User, Tap-Delay, Digital Audio Interface Channels : 4 In / 4 Out, AD/DA Conversion, Sampling Rate : 24-bit, 44.1 / 48 / 88.2 / 96 kHz Makes: AVID,Dynacord,SSI

SITC of Handheld Wireless Mic with Cardiod polar pattern for transmitter, Dynamic microphone with Neodymium magnet , Receiver frequency response 80Hz-18kHz,Receiver RF sensitivity < 1.0 µV, Receiver Image rejection>55dB,Receiver Dynamic range >95dB and receiver having 32 channels possible, Receiver S/N ratio >100dB A, distortion <1 %, Transmitter sensitivity - 3.2 mV/Pa, modulation:+/-40kHz Makes : Audio Technical/Beyerdynamic/EV

SITC of compact 2-way powered loudspeaker System for Stage monitors with inbuilt Class D 1000watts amplifier, minimum 12” LF, HF - 1" exit , Frequency Range (-10 dB): 55 Hz - 20 kHz +/-10Hz is acceptable on both ends of the audio spectrum , Max SPL: >=126dB , Nominal Dispersion: 90 x 60 degrees. Makes : EAW/d&b&EV

Supply, Installation, Testing & Commissioning of UHF Antena Spliiter Provides antennas and power for 4 diversity receivers, Internal switching power supply, Green LED On Indicator on front panel, Can be cascaded with more splitters to supply more receivers, Frequency range- 780 - 900 MHz,3rd Order Intercept: Greater than 18 dBm, Net Gain: Greater than 2 dB, Noise Figure : Less than 3 dB, Output Isolation: Greater than 20 dB, Connectors - Antennas: Standard TNC, Antenna Input Power: Optional 12 V DC, Power Requirements100 - 240VAC 50/60 Hz etc. all complete. Makes: Audio technica /Beyerdynamic/EV

Supply, Installation, Testing & Commissioning of UHF transmitting and receiving omnidirectional antenna with interal or external booster amplifer, oem cables for connecting antenna to antenna splitter. Compatible with the Antenna Distribution complete with mounting kit etc. all complete. Makes: Audio Technica/Beyerdynamic/EV

50' 50 ohm low loss coaxial cable, TNC M connector. Makes: Clearone /EV / Audio technica /

UHF Antenna amplifier, 3 or 10db gain, Makes: Clearone/EV/Audio technica

Supply of 2 Core x 4 Sqmm Cable for Speakers with related conduits/fittings/termination etc Makes : Finolex/Sirrco/Klotz

Supply of 2 Core x 2.5 Sqmm Cable for Speakers with related conduits/fittings/termination etc Makes : Finolex/Sirrco/Klotz

Supply of 2 Core Shielded Cable for connecting Microphones with related conduits/fittings/termination, etc. Makes : Finolex/Sirrco/Klotz/Deepcab

Supply & Fixing of XLR Male & Female Connector Makes : Neutrik/Bestnet/MX

Supply & Fixing of RCA to phono patch cords Makes : Neutrik/Bestnet/MX

Supply & Fixing of RCA to RCA patch cords Makes : Neutrik/Bestnet/MX

Supply & Fixing of Phono connectors (1/4 inch) Makes : Neutrik/Bestnet/MX

M/S Vipranshu Enterprises

Techno Solutions

Malani Enterprises