Construction of Computer Center & Toilet Block work of SMT. J. P. Shroff Arts College Valsad Ta. & Dist. Valsad

Name of work :- Construction of Computer Center & Toilet Block work of SMT. J. P. Shroff Arts College Valsad Ta.

Estimated Estimate Rate Total amount

Estimated Estimate Rate Total amount

Sr. according to

but may be Item of work Unit

No. In figures In Words estimated

1 22.100 Providing and laying controlled cement concrete 4538.34 #NAME? Cum.

M.200 and curing complete excluding the cost

of formwork and reinforcement for reinforced

concrete work in (C) Slabs, landing, shelves,

Balconies Lintels, Beams, Girders and

Cantilever upto floor two level.

2 198.19 Providing formwork of ordinary timber planking 264.60 #NAME? Sqm.

so as to give a rough finish including centering

shuttering strutting and propping etc. height of

propping and centering below supporting floor

to ceiling not exceeding 4 M. and removal of the

same for in situ reinforced concrete and plain

concrete work in. (B) Flat Surfaces such as

sofits of suspened floors slabs Landings and

the like. (1) Floors ets. upto 200 mm in

3 30.79 Brick work using common burnt clay building 4550.73 #NAME? Cum.

bricks having crushing strength not less than

kg./Sq.Cm. in foundation and plinth in Cement

Mortar 1:5. (1- Cement: 5-fine sand) (A)

4 260.42 Providing 15mm thick cement plaster in single 183.57 #NAME? Sqm.

coat on Rough (Similar)side of single or half

brick walls for interior plastering upto floor two

level and finished even and smooth in (i)

Cement mortar 1:3 (1-cement:3-sand)

5 264.50 20mm thick sand faced cement plaster on walls 312.56 #NAME? Sqm.

upto height 10 metres above ground level

consisting of 12mm thick backing coat of C.M.

1:3 (1-cement: 3-sand) and 8mm thick finishing

coat of C.M. 1:1 (1-cement: 1-sand) etc.

6 222.70 Wall painting (two coats) with plastic emulsion 157.61 #NAME? Sqm.

paint of approved brand and manufacture on

undecorated wall surface to give an even shade

including throughly brushing the surface free

from mortar droppings and other foreign matter

and sand papered smooth

7 264.50 Finishing wall with weather proof exterior 119.07 #NAME? Sqm.

emulsion paint on wall surface (two coats) to

give an required shape even shade after

thoroughly brushing the surface to remove all

dirt, and remains of loose powdered

materials.etc complete

8 28.427 Providing and fixing complete sliding shutter 2576.85 #NAME? Sqm.

solid PVC window 25mm thick factory made

glazed solid PVC window shutter consisting of

frame made out of M.S. tube of 19 gauge of

size 15 x 15mm for styles top, bottom rail. M.S.

frame shall have a coat of steel primer of

approved make and manufacture, M.S. frame

shall be covered with 4mm thick heat mouled

PVC 'C' channel of size 58mm x 25mm x 38 mm

out of which 8mm shall be bent at 90 degree

towards inner side on front face of the window

shutter forming stiles. For top rail and bottom

rails, MS. frame shall be covered with 4mm

thick, 58mm wide PVC sheet out of which 8mm

shall be bent at 90 degree towards inner side

un front face and 38mm wide PVC sheet shall

cover the M.S. frame at top and bottom rail on

back side of window shutter, 4mm thick 15mm

wide cross PVC sheet as gap insert for top and

bottom rail. PVC sheet beading of 8mm thick

(4mm x 2) to be stuck internally with solvent

cement adhesive in top and bottom rails. Glass

panel will be fitted externally in the clear space

available between stiles & rails and fixed

9 9.90 Providing and fixing 35mm thick factory made 2131.00 #NAME? Sqm.

moulded door shuter consisting of solid core

single leaf flush door of 30mm thickness, lipped

with 15mm (5mm x 3) thick x 30mm width on

one stiles and top rail and 10mm (5mm x 2)

thick x 30mm width on the other stiles and

bottom rails. The inner panel laminated with

2mm thick termite proof, water proof and fire

resistant moulded PVC sheet with 2,4,6 raised

panel design in different plain and/or prelim

colours on one side after routing the moulded

design on flush door and 2mm plain and/or

prelim PVC sheet on other side using rubber

adhesive on flush door and solvent cement

adhesive on the PVC liping etc. complete as per

direction of Engineer in charge. manufacture's

specification and drawing

10 40.46 Providing and laying marble stone slab flooring 2267.88 #NAME? Sqm.

over 20nm (average)base of cement mortar 1:6

(1-cement: 6 coarse sand) or L.M. 1:1.5(1-lime

putty: 1.5-coarse sand) laid and jointed with

gray cement slurry including rubbing and

polishing complete. (A) Marble slab 25mm thick

11 200.93 Providing and laying Vitrified tiles 8 to 10 mm 1109.27 #NAME? Sqm.

thick, 24"x 24" in flooring treads of steps and

landing laid on a bed of 12mm thick cement

mortar 1:3 (1-cement: 3-coarse sand) finishing

with flush pointing in white cement.

12 8.50 Providing and fixing in position Fe 500D TMT 72927.17 #NAME? MT

for R.C.C. bored piles as per detailed drawing,

including cutting, bending hooking tying and

welding complete and including forming the

cage and lowering it in pusition. (up to 10 ton)

13 268.28 Providing valleys 900mm overall in plain 1.6mm 1067.78 #NAME? Sqm.

thick G.I. sheet fixed with G.I. J or L Hooks,

Bolts and nuts glavanised iron J or I. Hooks

Bolts and nuts 8mm dia G.I. Limpet and

bitumen washers complete.

14 168.88 Pro. And fixing single layer water proof gypsum 600.94 #NAME? Sqm.

board 12.5 mm thick sections using water proof

board of size 1220 mm x 1830 mm x 8.0 mm

suspended by GI suspender channel of size

mm x 3 mm with intermediate channel og size

18 mm x 40 mm x 0.8 mm at 1220 mm center to

center ceiling section of size 40 mm x 35 mm x

0.55 mm at 457 mm c/c and perimeter channel

A of size 20 mm x 27 mm x 30 mm x 0.5 mm at

edges & drops incl.paper tap sand sofit cleat,

anchor fastener, scoch bolt connecting

cleat,joining compound top coat on ceiling

incl.making necy.opening for light fitting, diffuser

etc. comp. as per detail drawing as directed

15 1314.31 Providing and fixing M.S. grills of required 150.82 #NAME? Kg.

pattern to wooden frames of windows etc. with

M.S. flats at required spacings and frame

alround, square or round bars with round

headed bolts and nuts or by screws. (B)

ORNAMENTAL GRILL

16 1.00 Providing & Erecting of all electrical work 543250.00 #NAME? Job

including all addinatiol item required as directed

by Engineer in charged

17 1.00 Providing & Fixing Plumbing work of including 25000.00 #NAME? Job

all materials & labour work as directed by

Engineer in charged

18 1.00 Providing & Fixing Miscellaneous work of 87000.00 #NAME? Job

including all materials & labour work as directed

by Engineer in charged

SMT. J. P. Shroff Arts College

I/we am/are/ willing to carry out the work at ………………….% below / Above

……………………………………….percent below / Above

(should be written in figures and words)

Tendered amount mentioned above amount of my / our tender works out as under.

Tendered Amount Rs……………………… Tendered Amount Rs………………………

Deduct………. % below Rs……………………. Add…………% Above Rs………………….

Net Amount Rs………………………………. Net Amount Rs……………………………….

Net Amount in words in Rs……………………………………………………………………………………….

Special Note :-

Contractor Shall give only rebate in tendered amount mentioned above and contractor shall

state " NIL" Percentage, if no reduction is offered.

Note :- 1 All works shall be carried out as public works department Handbook and other

specification of Division or as directed.

Note :- 2 All the columns in schedule should be filled in ink or ballpen and the total of the

entries in last column should be struck by the contractor under his signature.

Note :- 3 Rate quated include clearance of site (Prior commencement of work and at its close)

in all respects and hold good for work under all conditions,site moisture, weather etc.

Note :- 4 To be continued on additional sheet,if found necessary.