Construction of ROB in lieu of L.C. No.37 at Km.42/7-8 Madhi-Lotarva Station on Udhana-Jalgaon Section (Madhi-Valad road) (Providing Compound Wall).

Name of Work :- Construction of ROB in lieu of L.C. No. 37 at Km. 42/7-8 Madhi-Lotarva Station on

Udhana-Jalgaon Section (Madhi-Valad road) (Providing Compound Wall).

Bill of Quantities

(A) Percentage Rate Tender (Up to INR 50 Cr. )

Items Description of Item (with brief specification and reference to Quantity Unit Rate In Amount

No. book of specifications) figures

1 Excavation for foundation upto 1.50 mt depth including sorting out 28.60 Cumt 122.94

and stacking of useful materials and disposing the excavated stuff

all lead and lift. (A) Loose or soft soil.

2 Boring holes 2.5 m deep in ordinary soil (for cast in situ piles) and 35.00 Nos 954.03

getting out the soil and disposal of the surplus excavated soil as

directed within a lead of 50 Meter for following diameter of pipes. (iii)

3 Providing and laying controlled cement concrete M.150 and curing 5.20 Cumt 3958.25

complete including the cost of formwork But excluding the cost of

reinforcement for reinforced concrete work in (A) Foundations and

4 Providing and laying controlled cement concrete M-200 for R.C.C. 4.70 Cumt 4610.16

bored piles of all diameter including ramming,vibrating and finishing

5 Providing and laying controlled cement concrete M-200 and curing 3.80 Cumt 8926.38

complete including the cost of form work but excluding the cost of

reinforcement for reinforced concrete work in Columns, pillars posts

and struts Ground Floor.

6 Filling available excavated Earth (Excluding Rock) in trench plinth 19.60 Cumt 136.92

side of foundation in layer not excluding 20 cm in depth consolidation

each deposited layer by ramming and watering etc. complete.

7 Providing and laying controlled cement concrete M-250 and curing 4.60 Cumt 6399.36

complete including the cost of form work but excluding the cost of

reinforcement for reinforced concrete work in Ground & Plinth

8 Brick work using common burnt clay building bricks crushing strength 36.80 Cumt 4503.04

not less than 35 kg/sq.cm. in foundation and plinth in cement mortar

1:6 (1 cement : 6 fine sand) (B) Conventional For Groud Floor.

9 Providing and laying controlled cement concrete M-200 for RCC work 4.30 Cumt 5902.44

and curing complete including the cost of form work but excluding the

cost of reinforcement for reinforced concrete work in coping on Ground

10 Providing TMT Bar FE 500D reinforcement for R.C.C. work including 2328.00 Kgs. 77.29

bending, binding and placing in position complete up to All floor

11 20 mm Thick sand faced Gutka cement plaster on walls for all height 416.30 Sqmt 315.69

above ground level consisting of 12 mm Thick backing coat of c.m. 1:3

(1 cement : 3 sand) and 8 mm Thick finishing coat of c.m. 1:1 (1

cement : 1 sand) with 1x1cm Groves at juction of structure member etc.

complete. all height.

12 Wall Painting (Two coats) with weather proof acraylic emulsion (Apex 416.30 Sqmt 120.26

or equivalent type) paint of approved brand and manufacture and of

required shade on exterior wall surface to give an even shade over and

including primery coat with Alkaly resistance primer of approved brand

after thoroughly brushing surface to remove all dust and remains of

loose powdered material etc. comp. for all height.

Items Description of Item (with brief specification and reference to Quantity Unit Rate In Amount

No. book of specifications) figures

13 Constructing, Providing and Fabricating cattle trap using channel 9.00 Sqmt 5124.74

section frame of size ISMC series 100m x 50 mm (Weight

kg/Rmt) and ISMC I Section 100 mm x 75mm (Weight 11.50 kg/Rmt)

1mt C/C Intermediate Support for welding G.I. Pipe at 12 cm of size

50mm dia Heavy duty in a frame made of channel section of 100mm x

50mm all round including fixing the urit on prepared chamber of

masonary wall using MS hold fast embeded in masnary wall top as

directed by Engineer in charge as per drawing by necessary

arrangement etc. complete.

14 Providing and fixing decorative entrance gate made out of cast iron and 360.00 Kgs. 181.80

various mild steel tabular section combination, the Ornamental

entrance gate should be fixed at compound wall including pattern and

die making, cutting, welding, grinding, fabrication, fixing in position at

compound wall with necessary pedestal, bearing block and other

locking arrangement. The entrance gate should be painted with two

coats of priming coat of paint and two coat of oil paint etc complete. As

per detail design and instruction of architect.

15 Providing and fixing concertina coil fencing with punched tape 95.00 Rmt 305.02

concertina coil 600 mm dia 10 mt openable length having 50 no rounds

per 6 mt length, upto 3mt height of wall with angle iron (50mm x50mm

x5mm) requird shaped As per Directed Engeenier in charge. placed

2.4mt or 3.00mt apart and with 4 horizontal R.B.T. reinforced barbed

wire (3 mm), stud tied with G.I. staples and G.I. clips to retain

horizontal, including necessary bolts or G.I.barbed wire tied to angle

iron, all complete as per direction of Engineer-in-charge, with

reinforced barbed tape (R.B.T.) / Spring core (2.5 mm thick) and

weight 43.478 gm/meter at compound wall for ESR M4/ intakewell.

(Rupees Eight Lakhs Thirty-eight Thousand Two Hundred Fifty-five and Paise Seventy-four Only.)

I/We am /are willing to carry out the work at…………% above/below percent (should be written in figures and words) at the

estimated rates mentioned above amount of my/your tender works out as under.

*Estimated Amount *Estimated Amount

put to Tender Rs. 838255.74 put to Tender Rs.

Deduction …………….. % below………………… Add ………… % above Rs. …………….

1 The Contractor shall be exhibit board as per government circular No.BDG/3277/1657 N dated 26/01/1997 S (M.GUJ)

with detailed specification and details of work and amount Involved at site without any payment as directed by

Engineer-In-Charge.

2 All work shall be carried out as per public work department hand book and other specifications of Division or as

3 All columns in the Schedule should be filled in ink & the total of the entries in the last column should be struck by

Contractor under his sign.

4 Rates quoted include clearance of site (Prior commencement of work and its close) in all respects and hold good for

work under all condition, site, moisture/ weather etc.

Items Description of Item (with brief specification and reference to Quantity Unit Rate In Amount

No. book of specifications) figures

5 The Boards stating the detailed specification & detailes of Work shal be provided by the contractor as per Government

Resolution T.No.1890-240- Dtd.18/11/1990 and directed by contractor at his own cost immediately on recommanding

the work order.

6 Testing of Material Shall be done as per the statement attached with specification,The material IS Tested in GERI by

Executive Engineer Surat and Bill for the testing charges shall be paid by Executive Engineer,1% of the Amount put to

7 1% of the Construction Cost Shall be deducted from the bill Amount of the contract as per the Buildig and other

Construction works walfare cess at 1996(Labour and Employment Department Letter No CWA-2004-1831-M(3)Dated

9/12/2005 notification Of Labour & Employment department dt.03/01/2005 & Labou & Employment Department Letter

8 In Case of RCC items Where there is a change in Grade of Mix or Change as per Actual Mix design the cost of

difference of Cement Difference shall be deducted from the rate of original item at the rate of star rate mentioned in the

9 Contractor are advised to visit site before loading tender rate.

10 Necessary wiring point and drainage point are installed at Site however any modification in electrical installation and

drainage & water supply connection and minor correction to perform experienced in Lab shall be done by contractor at

his risk and cost.

11 The Rates are inclusive of all the taxes (Excluding GST),Transport Charges,Octroi duty and storage Charges up to date.

12 The materials Covered for wiring should be got approved from the Engineer Incharge of the work.

13 GST and Income tax TDS will be deducted at a source while making payments of bills.

14 GST will be paid extra as per Govt. amendment.

15 The Materials on the work shall have to be used and carried out as specified in technical note.

I/We hereby Declare that I/we have Visited the site and fully Exquisite myself/ourselves with the local situation

regarding materials,Labour and other factors pertaininfg to work before submitting tender.

I/We hereby Declare that I/we have carefully Studied the condition of Contracts,Detailed Specification and other tender

Document of this work and agree to execute the same accordingly.

Signature of Bidder Deputy Executive Engineer

Bardoli (R&B) Sub. Division,

Executive Engineer

Surat (R&B) Division No.2,