PROVN OF RCC AND STONE RETAINING WALL AT VARIOUS LOCATIONS AT PALAMPUR MIL STN

Amount

Earth work in excavation (All kind of soil) by mechanical means (Hydraulic excavator) means over areas (exceeding 30 cm in depth and upto 1.5 m depth, 1.5 m in width as well as 10 sqm on plan) including getting out soil , as directed by Engineer-in-charge

Earth work in excavation (All kind of soil) by mechanical means (Hydraulic excavator) means over areas (exceeding 1.5m in depth and upto 3 m depth, 1.5 m in width as well as 10 sqm on plan) including getting out soil , as directed by Engineer-in-charge

Hand packing (any thickness) of broken stone or boulders at back of walls over arches etc. and raising (or lowering) to the required level, complete all as specified.

Supply only 40mm graded crushed stone aggregate (For weep holes), complete all as specified.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25cm, complete all as specified and directed.

Removing excavated materials/ soils, to a distance not exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point , complete all as specified and directed.

Plain cement concrete 1:3:6 ( nominal mix )type C-2 using 40mm graded crushed stone aggregate as in foundations, filling, mass concrete a, complete all as specified & directed.

RCC M-25, design mix, using 20mm graded crushed stone aggregate as in foundations including rafts, footings, foundation beams, plinth beams, bases for columns etc., complete all as specified & directed.

RCC M-25, design mix, using 20mm graded crushed stone aggregate as in walls, retaining walls, basement walls , columns ballast wall and the like any thickness above top of footing., complete all as specified & directed.

Precast cement concrete bond stone 1:3:6 type C-1 (using 20mm graded crushed stone agrregate) set in CM 1:4, including necessary form work, complete all as specified and directed

PCC 1:2:4, nominal mix, type B-1, using 20mm graded crushed stone aggregate as in lintels upto 1.5m clear span, cills, steps, seismic and other similar bands, plinth courses, coping, bed plates and the like including weathering, slightly rounded or chamfered angles and throating including necessary form work, complete all as specified.

Use & waste of form work to sides of concrete foundations,sides of concrete drain, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter for rough finished surface of flat concrete complete all as specified and directed.

Use & waste of form work to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter for rough finished surfaces of flat concrete, complete all as specified & directed.

PVC 110mm dia pipe, (in short length) , fixed in retaining wall as weep hole complete all as specified & directed.

Walling of random rubble stone masonry, uncoarsed, well bonded, bedded and soilidly hearted built in CM 1:6, complete all as specified and directed.B44

Extra over stone walling of granite, trap or basalt stone for hammer dressing to face stones and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought upto courses with maximum depression on face from straight edge held against the dressed surface n exc 20 mm, complete all as specified & directed..

Wire netting of stainless steel wire 0.91mm dia of mesh size 12mm fixed with tinned tacks of stainless steel wire staples complete all as specified and directed.

TMT bars 10mm dia & over, cut to length, bent to shape required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, conforming to grade Fe-500, complete all as specified& directed.

TMT bars 6 to 8mm dia, cut to length, bent to shape required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, conforming to grade Fe-500, complete all as specified& directed.

Raised pointing to random or polygonal rubble uncoursed or brought upto courses in cement mortar 1:4 complete all as specified.

M/s Surindera Traders (BID ID -3159730)

m/S Varun Gupta (BID ID -3162794)

MM Constructions (BID ID -3161394)

M/S THAKUR ENTERPRISES (BID ID -3168216)

BHARDWAJ BUILDERS (BID ID -3162590)

M/s R S Construction (BID ID -3166791)

SHELTERA CONSTRUCTION (BID ID -3168188)