Estimate for Special repair from rd 76340 to RD 85900 of NH 352A in M.C Sonipat

Amount

P & F cat eyes glow stards of size 100*20 mm made of heavy duty . Shall suppport a load 13635kg tested as per direction by engineer in charge

Providing and applying primer coat with bitumen emulsion (S.S grade –II) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.60kg/sqm using mechanical means as per MoRTH&H specification for road and bridge (5th revision ) of 2013 as per drawing and design directed by the engineer completer in all respects as per clause no. 502

Providing and laying 50mm thick compacted dense graded bituminous macadam (DBM) in one layer with drum type /100-120 TPH batch type hot mix plant and with a hydrostatic paver finisher with sensor to the required grade, level and alignment, rolling with specification for road and bridge work (5th edition)2013 using minimum 4.50% to bitumen grade VG-30 as bindet content

P & L 30mm thick Bituminous Concrete(B.C) with 100-200 TPH batch type hot mix plant producing an average output of 75 tone’s per hour using crushed aggregates of specified grading, premixed with bituminous binder VG-30 minimum @ 5.40 per cent of mix and filler, transporting the hot mix to work site, laying with hydrostatic paver finisher with sensor control to the required grade, level and alignment rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause no. 509 complete in all respects (as per MoRTH specification clauses no. 509.

Providing and laying 25 mm thick mastic asphalt wearing course with paving grade bitumen meeting the requirement given in table 500-29 , prepared by using mastic cooker and laid to required level and slope after cleaning the surface, including providing antiskid surface with bitumen percolated fine grained hard stone chipping of 13.2 mm nominal size at the rate of 0.005cum per 10 sqm and at an approximate spacing of 10 cm c/c in both direction, pressed into surface when the temperature of surface is not less than 1000c, protruding 1 mm to 4 mm over mastic surface , all complete as per clauses 515

Providing and marking center line /Zebra crossing with hot applied thermo-plastic road marking paint complete in all respect such as furnishing all labour, material tools, equipment including all incident cost necessary for carrying out the work at site conforming to the technical specification clauses 803.4 of MoRTH specification for road and bridge work (4th edition) of 2001/ latest edition as directed by the Engineer-in-charge

Scarifying of existing 30 mm thick bituminous surface as per Morth

Providing and laying tack coat with bitumen 80/100 grade VG-10 grade pressure distributor at the rate of 30 kg per sqm on the prepared bitumen/granular surface cleaned with mechanical broom including cost of bitumen as per clause no. 503 (5th edition) 2013 of MoRTH specification (N.S)

-S/E OF MARK DOUBLE WALLED CORRUGATED (DWC) HDPE PIPE LAID IMTR BELOW GROUND LEVEL HDPE PIPE 90/75 OUTER DIA/INNER DIA

S S Construction Co