Annual Plan-Kozhikode Municipal Corporation project No. 1938/25 -Temporary arrangement at central market- Electrification-General Electrical Work

Amount

General electrical work

OD168819/2025-2026:Cutting the existing Concrete floor/road using machinery/manual including clearing the waste material from site etc. as requited for pole foundation

14.1:Excavation for foundation in soft soil including dressing of sides and ramming of bottoms, lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 metres.

OD168777/2025-2026: Steel reinforcement for RCC work including straightening, cutting, bending, tying, placing in position and binding all coponents upto plinth level

14.7:Providing and laying in position cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) in foundation of pump, DG set etc including form work etc as required.

14.12:Providing 15mm thick cement plaster of mix 1:4(1 cement: 4 fine sand) at all levels

OD168886/2025-2026:Conveyance , installation and commissioning of existing 7/8/9 mtr galvanized octagonal pole complete with new ring type bracket suitable for fixing lamps, cover plate, 20 mm dia 600mm long foundation bolts in the existing RCC foundation , painting with 2 coats of synthetic enamel paint over a coat of zinc chromate primer etc as required

90.15.4.8:Supply Conveyance, installation, testing and commissioning of 120W LED Flood light output greater than 105lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than 10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer)

5.4:Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

OD168894/2025-2026:Supply and providing 25 X 6 mm brass nut bolt for plate earthing test joint

OD168895/2025-2026:Providing and fixing 2X25X3 mm GI strip test joint for earthing system with necessary bolt and nut etc as required

OD168896/2025-2026:Providing and fixing 25mm X 3mm GI strip earth lead from the test joint to the earth plate

OD168891/2025-2026:Supply and providing 32A, 2 Way neutral links mounted o in the meter box including connection as per direction

OD168893/2025-2026:Supply and providing 32A HRC fuse base and holder including HRC fuse link in the eisting meter box and giving connection

OD172563/2025-2026:Supplying and fixing following way, single pole and neutral, Thermoplast, poly carbonate IP 65 MCB distribution board, 240 V, on surface/ recess, complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections, including earthing etc. as required. (But without MCBIRCCB/Isolator 12 way)

2.10.1:Supplying and fixing 5A to 32 A rating, 240/415 volts, 10 kA, ""C"" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required. Single pole

2.10.3:Supplying and fixing 5A to 32 A rating, 240/415 volts, 10 kA, ""C"" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required. Double pole

2.12.1:Supplying and fixing following rating, double pole, 240 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required.40 amps

2.14.1:Supplying and fixing following rating, double pole, (single phase and neutral),240 volts, residual current circuit breaker (RCCB), having a sensitivity current 30 milli amperes in the existing MCB DB complete with connections, testing and commissioning etc. as required. 25 amps

2.14.2:Supplying and fixing following rating, double pole, (single phase and neutral),240 volts, residual current circuit breaker (RCCB), having a sensitivity current 30 milli amperes in the existing MCB DB complete with connections, testing and commissioning etc. as required. 40 amps

OD168923/2025-2026:Supply and fixing Satellite Connector for stringing LT ABC cable

OD168924/2025-2026:Supply and providing Steel Strap for stringing LT ABC cable

OD168925/2025-2026:Supply and providing Buckel for stringing LT ABC cable

OD168926/2025-2026:Supply and fixing Dead End Clamp for stringing LT ABC cable

OD168927/2025-2026:Supply and fixing Suspension Clamp for stringing LT ABC cable

OD172578/2025-2026: Supply and fixing Piercing Connector for stringing LT ABC cable

OD168928/2025-2026:Supply, conveyance and stringing Single Phase LT ABC (Aerial Bundled Cable) 2 core 16 sq.mm confirm to IEC 60502 through existing pole.

90.6.10.1:Supply and fixing of following sizes of light gauge PVC conduit along with accessories in surface/ recess including cutting the wall and making good the same in case of recessed conduit as required20 mm

90.6.5.12:Supply and drawing the following sizes of multi-core PVC insulated & FRLS PVC sheathed 650/1100 V grade copper conductor round flexible cables conforming to IS 694 part I 1960 in the existing surface / recess conduit as required including giving necessary connections of the following sizes.3 core 2.50 sq mm

OD169916/2025-2026:Fabrication, supply, conveyance, installation testing and commissioning of floor orwall mounting, dust and vermin proof, cubicle type MV panel board comprising of the following components/ devices & complying to IS 8623.<br> Fabrication of fully partitioned, dust and vermin proof enclosure for panel assembly as per form 4 of IS 8 6 2 3 ( w i t h l a t e s t amendments) using CRCA sheet as per approved design and requirement, with front and rear access facility, bus bar chambers, hinged doors for all switch gear compartments, earthing the doors using 4 sq mm braided copper conductor, providing necessary cut-outs for mounting meters, relays, indication lamps, bus bar interconnection etc, detachable covers for bus bar chamber and cable alley, powder coating the assembly after subjecting to 7 tank process etc as required. CRCA sheet alone be used for the fabrication. Angles/ flats/ slotted angles etc shall Angles/ flats/ slotted angles etc shall not be used for the fabrication of panel assembly. The measurments will be taken the area of the complete sheets used for panel board including partitions, folding, shrouding etc.Supply and fabrication of MV panel board using 1.6mm CRCA sheet, powder coated (excluding base frame)

90.14.2.1:Supply and providing 2mm SMC sheet as shrouding for bus interconnection / terminations etc. including required nut & bolt etc.

90.14.3.2:Supply and providing heavy duty 'A' section neoprene gasket in the panel boardU' section rubber beeding suitable for 1.60/ 2.00 mm sheet

90.14.5:Supply and fabrication conveyance and installation of angle iron frame work for wall mounting panel board

90.16.1.4:Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required4.00 mm copper conductor ( 8 SWG)

90.16.1.3:Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required3.15 mm copper conductor ( 10 SWG)

90.16.5.4:Supply of superior quality copper earth socket for the following size of earth conductor including crimping etc. as required.4.00 mm (8 SWG)

90.16.5.3:Supply of superior quality copper earth socket for the following size of earth conductor including crimping etc. as required.3.15 mm (10 SWG)

90.16.2.1:Supply and laying of the following sizes of B class GI pipe laid 0.6 m below ground level including excavating trench of suitable size and refilling etc, as required.15.mm dia. G.I pipe ( medium class)

OD168938/2025-2026:Supply and providing suitable Iron Hook grouted on wall for binding the service wire

90.6.10.3:Supply and fixing of following sizes of light gauge PVC conduit along with accessories in surface/ recess including cutting the wall and making good the same in case of recessed conduit as required32 mm

90.3.18.4:Supply, fabrication, conveyance and fixing the following sizes of B class GI pipe bent to shape / cut and welded to shape and fixing the same to wall / parapet using clamps as noted along with each size, painting with 2 coats of synthetic enamel paint over a coat of zinc chromate primer, making good the damages, colour washing etc as required.50 mm dia with clamps made from 25 x 3 mm MS flat

OD172564/2025-2026:Providing and fixing following capacity Switch Disconnector Fuse 32 A, 2 Pole, Open Execution, DIN Type, 415 V AC the existing panel board with ISI marked 25 A HRC fuses including drilling holes in cubicle panel, making connections, etc| ( Make L&T SK95594 or equivalent) the existing panel board with ISI marked HRC fuses including drilling holes in cubicle panel, making connections, etc. as required.32 Amp TP & N

OD170069/2025-2026:Supply and providing shelter roof with metal sheet of .5 mm thk as shelter for the meter cubicle including nut/bolt/washer as required (Make -Tata or equivalent)

1.17.30:Supplying and drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface / recessed steel/ PVC conduit as required.3 x 6 sq. mm

OD172609/2025-2026:Supply and installation of 230 V AC 50 Hz 25A 2pole power contactor in the existing enclosure and giving connections as required (L&T MNX 25-2P 2 Pole Power Contactor 25 A CS90240 or equivalent)

OD172610/2025-2026:Supply and installation of Digital Tme Switch suitable for 240V AC DIN based in the existing enclosure and giving connections as required

OD172886/2025-2026:Providing support pole for weather proof service connection

OD172887/2025-2026:Charges for procurement, preparation and submission of application to KSEBL with sketch , test and completion report with necessary liaison work as required for single phase service connection

OD172891/2025-2026:OD111465/2023-2024 - Supply and fixing, installation o f t h e r m o p l a s t i c p o l y c a r b o n a t e / Polypropylene cable junction box IP66/67 in accordance with IEC60529 environment friendly, recyclable, UV resistant, halogen & silicon free, anti acid & anti corrosive, shockproof with 5 pole terminals suitable to terminate upto 4 sqmm. approx Dimensions: 104 x 104 x 70 mm Rated Insulation Voltage 690 V AC Rated Current32 A ( Brand Hensel Model Name/NumberDK

SAJITHLAL K (BID ID -2298991)

Bidder Name

SAJITHLAL K

SAFIYULLA K V