Restoration of Rain Damages of LWSS Rajiana at Ranital in Tehsil and Distt. Kangra H.P.

Excavation in foundations,trenches etc in earth work in all kind of soil, such as pick work, jumper work, blasting hard or soft rock by chiselling where the blasting work is prohibited slushy daldal and saturated soil including pumping or bailing out water with in all heights, stacking the excavated soil within all leads clear from the edge of excavation and then returning the stacked soil in 15cm (fifteen centimetres) layers, when required into plinths, of foundations etc consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth, as per the direction of Engineer-in-Charge with in all leads and lifts.

Providing and laying cement concrete 1:5:10 (1cement :5sand :10 graded stone aggregate 40mm nominal size) with 15 % plum and curing complete excluding cost of form work in retaining walls/Breast walls, the size of plums shall usually be 150mm. to 300mm as per H.P.P.W.D specification complete in all respect including all leads and lifts as per the direction and satisfection of Engineer-In-Charge.

Providing form work with steel plates 3.15 mm thick welded with angles iron in frame 30 x 30 x 5 mm so as to give a fair finish including centering shuttering struting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor two ceiling not exceeding 4 meters and removal of the same for in-situ- reinforced concrete and plain concrete in: Vertical surface such as wall (any thickness) partition and the like i/c attached pillasters, butresses plinth and string course including all leads and lifts.

Brick work using common burnt clay building bricks in foundation and plinth in CM 1:4 (1 Cement : 4 Sand) ic carriage of material (1st Class Bricks) complete in all respect with in all lead and lifts as per direction and to the entire satisfaction of Engineer-in-charge.

20mm cement plaster in single coat on rough side of brick\stone masonary for interior plastering up to floor two level including arrises, internal rounded angles, chamfers and\or rounded angles not exceeding 80mm in girth and finished even and smooth in C.M 1:6 (1 Cement :6 Sand) complete in all respect with in all lead and lifts as per direction and to the entire satisfaction of Engineer-in-charge.

Pointing on brick work with cement mortar 1:3(1 cement:3 sand) complete in all respect with in all lead and lifts as per direction and to the entire satisfaction of Engineer-in-charge.

20mm cement concrete topping 1:2 to 3 (1 cement : 2 to 3 stone aggregate of size) (4.75 mm and below, by volume) laid over and finished monolithic with base concrete complete in all respect with in all lead and lifts as per direction and to the entire satisfaction of Engineer-in-charge.

Providing steel work welded in built upto sections bruses and framed work including cutting, hosting fixing in position and applying a priming coat of red lead paint in gratings framed quard bars, ladders, railling brackets and similar works complete with in all leads and lifts as per the direction and satisfaction of Engineer-in-Charge.

Finishing wall with weather proof exterior grade emulsion of approved design on underground wall surfaces (two coats) give an even shade after throughly brushing the surface to remove all dirt, and remain of loose powered materials complete within all leads and lifts and to the entire satisfaction of Engineer-in-charge witnin all leads and lifts.

Applying priming coat over new steel & other metal surfaces after & including preparing the surface by thoroughly cleaning oil grease dirt and other foreign matter and scoured with wire brushes fine steel wool scrapers and sand paper complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts.

Painting two coats (excluding priming coat) on new steel surface with ready mixed paint brushing to give an even shadce i/c cleaning of all dirt, dust and other foreign matters sand papering and stopping and brushing enamelled paint other than white complete within all leads and lifts.

Fixing of fencing pannel of size 1.20 X 1.80 mtrs. of Jali 25 X 25 mm welded to M.S. Black Tube of 32 mm dia of 14 guage mm thick with M.S. flat 20mm X 3 mm welded all around the pipe panel two on both sides and providing hold fasts out of M.S. flat of 32 X 3 mm thickness having sonsisting of tee of size 15 X 15 cms tee acting as hold fasts including cutting welding complete in all respect including all leads and lifts as per the direction and to the entire satisfection of Engineer-In-Charge.