CA NO GE SOUTH AMB 52 2020 2021 CERTAIN MISC REPAIRS TO DRAINS SEWAGE CLEANING PATHWAY AND FENCING IN SUB SECTOR II OF AGE BR II UNDER GE SOUTH AMBALA CANTT

Amount

Cleaning of under ground sewer lines of any type and size exceeding 100 mm dia and not exceeding 200 mm dia including manhole upto 2 m depth and removing sludge upto 200 mtr of any type of blockage of any kind of manhole or lines by means cleaning through manually by using bamboos, rodding, including desludging descaling & clear the chocking where ever flushing the entire stretch complete all as specified and directed.

Cleaning of brick/cement concrete open drains of any type and size exceeding and removing sludge to 50 mtr distance complete all as specified and directed.

Removing blockage from WC's, traps (P-trap/floor trap/nahani trap/gully trap etc) inside the buildings at any floor including cleaning and flushing the pipes upto first man hole as per complaints recieved day to day complete all as specified and directed. NOTE : - This item inculdes cleaning of each trap & pipes of toilet block/kitchen irrespective of length of pipes involved up to first man hole and altogether shall be taken as one job for payment purpose.

Cleaning of manholes/grease traps upto 1.5 metre depth and removal of sludge/silt etc (in foul conditions) to outside MOD land, including testing of manholes by filling with water complete all as specified and directed.

All as per item No 4.00 above but depth exc 1.50 m and not exc 2.50 metre complete all as specified and directed. NOTES for item No 1.00 to 5.00 above: - (i) Contractor shall provide 01 Safaiwala and 01 helper on daily routine basis on commencement of work and they should attend office of Engineer-in-Charge at 0900 hrs to note down the details of complaint for attending the same and shall report at 1600 hrs i.e. is after completion of complaints. (ii) Attendance register shall be maintained in the office Engineer-in-Charge by the JE (Civil) concerned for maintaining daily attendance duly signed by MES Executive. (iii) In case of failure for not providing sufficient manpower by the contractor, a penalty at the rate of Rs. 1000 per Safaiwala per day and Rs 600 per Helper per day shall be levied upon the contractor and recovery for the same shall be affected from contractor's dues. (iv) Particulars and details of Safaiwala & Helper alongwith supporting documents shall be submitted by the contractor to the Engineer-in-Charge immediately after handing over of site.

Demolition of brick work built in cement mortar incl all quoins, pillars arches etc complete all as specified and directed.

Material and labour for brick work, with sub class 'B' bricks, straight or curved on plan exc 6 m mean radius built in cement mortar 1:6 using old size bricks complete all as specified and directed.

All as per item No 7.00 above but except bricks, using old bricks retrived from dismantling from item No 6 here-in-before, including cleaning, removing mortar from the bricks complete all as specified and directed.

Material and labour for brick work with sub-class `B' bricks, straight or curved on plan to any radius in half brick thick walls built in cement mortar 1:4 as in drains including nescessary filling & jointing with cement mortar on other side of drain complete all as specified and directed.

All as per item No 9.00 above but except bricks, using old bricks retrived from dismantling from item No 9.00 here-in-before, including cleaning, removing mortar from the bricks complete all as specified and directed.

Material and labour for cement plaster 15mm thick on fair faces of brick work in cement mortar (1:4) and finished even and smooth without using extra cement complete all as specified and directed.

Material and labour for PCC 1:3:6, type C2 using 20 mm aggregate as in bed of drains complete all as specified and directed.

Material and labour for Cement concrete 1:2:4 , type B-1 using 20 mm graded mechanically crushed stone aggregate as in benching in manholes, coping plinth courses, bands stops etc including necessary form work complete all as specified.

Excavation in trenches, not exceeding 1.5 M wide and not exceeding 1.5 M depth for foundation, etc., and getting out in soft/ loose soil complete all as specified and directed.

Demolition by breaking up salt glazed stone ware drain pipes of any dia jointed in cement mortar and taking out from trenches and preparing the concrete bed wherever required for laying new pipe and removing the debris from site complete all as specified and directed.

Supply and laying salt glazed stone ware drain pipes 150 mm dia (internal) grade 'A' laid in trenches and jointed in cement mortar 1:1 including testing complete all as specified and directed.

Material and labour for plain cement concrete (1:3:6), type C-2, using 40 mm graded stone aggregates as in concrete bed to drain pipes of 150 mm bore laid to falls in trenches in any depth including packing under and haunching against the sides of pipes with concrete after the pipes are laid and tested complete all as specified and directed.

Demolition of cement concrete (reinforced) as in precast slabs of covers of manholes drains and removal the rubbish/demolished material outside defence land, complete all as specified and directed.

Material and labour for precast slab for covers of manholes in RCC (1:2:4) type B-1 using 20mm graded mechanically crushed stone aggregate as in including necessary form work and placing of manholes cover in position complete all as specified and directed. NOTE: - (a) The payment shall be made only after placing of cover on manholes/Arra drains. (b) Reinforcement shall be measured and paid seperately.

Material and labour for TMT bars of 10mm dia cut to length bent to shape required including cranking bending spirally, hooking ends and binding with mild steel wire not less than 0.9 mm dia(annealed) complete all as specified and directed.

Returning filling in including spreading levelling, watering and well remming in layers not exceeding 25cm thick complete all as specified and directed. (Surplus soil if any shall not be removed & left proud over the trench)

Cutting into existing manholes for connecting new drains, making good to pipe (Internal dia of pipe 150mm) and rendering, cutting out existing benching for and forming branch channel (1/2 round or 3/4 section) in cement concrete 1:2:4 type B-l smooth finished, and reforming benching as required complete all as specified and directed.

Supply only integral water proofing compound (for mixing in cement mortar or concrete) complete all as specified and directed.

Removing excavated soil not exceeding 50m and deposited where directed at a level not exceeding 1.5m above the starting point complete all as specified and directed.

Demolition cement Concrete (unreinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed.

Material and labour for plain cement concrete 1:2:4 type B-1 (using 20mm graded mechanically crushed stone aggregate) as in surface channels and drains, complete all as specified and directed.

Extra for forming fair finished drain or channel 30cm inner girth in cement concrete, using extra cement, including forms, moulds , mitred /stopped ends etc., complete all as specified and directed.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises complete all as specified and directed.

Supply and fixing for heavy duty tiles (coloured), good grip series, size 300 mm x 300 mm x 10 mm thick, pattern as approved by Engineer-in-Charge, set, jointed and pointed in neat cement slurry, laid over and including 20 mm thick (average thickness) cement mortor (1:4) bed, complete all as specified and directed.

Material and labour for roughening surfaces of old concrete floor by picking, sweeping clean and washing down with water to remove dust etc. and applying neat cement slurry @ 3.00 kg /sq.m, complete all as specified

Material and labour for 75mm thick plain cement concrete 1:4:8 type D-2 (using 40 mm graded mechanically crushed stone aggregate), as in sub base of floor and mass concrete, complete all as specified and directed.

Supply and fixing pressed precast concrete interlocking paver blocks with grey cement (as approved by GE) in any and shape, confirming to IS-15658-2006 of 60mm thickness, M-35 grade in path, hard standing, etc. laid over and including 50 mm thick screed or bedding layer of sand, complete all as specified and directed.

Material and Labour for plain cement concrete 1:2:4 type B-1 (using 20 mm graded mechanically crushed stone aggregate) as roof kerbs or mud stops and the like, rounded or chamfered on edges complete all as specified and directed.

Material and labour for glazed ceremic tiles in vertical surfaces 300 x 450 x 7 mm thick , set & jointed in neat cement slurry and pointed in coloured cement to match coloured tiles laid over and including 15 mm thick rendering in CM (1:4) complete all as specified and directed.

Supply & fixing for providing precast cement concrete louvers and jallies, 25mm thick (Measured solid) type B-0 1:2:4 using12.5mm graded mechanically crushed stone aggregates, set in cement mortar 1.4, including all mouldings complete all as specified and directed.

Taking down cement plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc. complete all as specified and directed.

Material and labour for 15mm thick rough cast plaster over and including 10mm thick base rendering in cement mortar (1:4) on brick or concrete surface of any description etc complete all as specified and directed.

Material and labour for preparing new plastered surfaces and applying two coats of cement base paint over a coat of primer on surfaces of walls complete all as specified and directed.

Material and labour for PCC in 1:3:6 type C-1 (using 20mm graded mechanically crushed stone aggregate) 50 mm thick as in plinth protection, path, laid in alternate bays etc.finished even and smooth without using extra cement and joints filled with bitumen and sand mixture applied hot complete all as specified and directed.

Dismantling posts or struts (Wood, Steel & RCC) embedded in any surfaces (natural, concrete, masonary etc.) and of any description, any section, taking out embedded portion & PCC bed and making good to disturbed ground surface, complete all as specified and directed .

Supply and fixing for galvanized 2 strand, steel barbed wire, 2.24 mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossing with & provision of galvanized mild steel wire, staples or steel pins etc (each line of wire to be measured), including dismantling of deterioted barbed wire fencing complete all as specified and directed.

Material and labour for plain cement concrete 1:3:6 type C-2 (using 40 mm graded mechanically crushed stone aggregate), as in foundation filling and mass concrete, complete all as specified and directed.

Material and labour for mild steel round bar Fe-410-W (Gde E-250) Quailty for securing chain link fencing and the like etc complete all as specified and as directed.

Supply and fixed mild steel, rolled sections (channel, angle or tee sections) fixed independently cut to ordinary length as in post or struts etc. including cutting tops to shape as required, drilling holes, notching for wire etc. including flat iron fillets with nuts and bolts for securing chain link fencing including all necessary drilling, bolting or riveting etc conforming to Fe-410(Gde 250), complete all as specified and directed.

Material and labour for mild steel work of flat iron as in securing chain link fencing and the like including necessary holes, etc grade Fe-410-S complete all as specified and as directed.

Material and labour for steel screw bolts, machine made, dia of neck 5 to 10 mm with hexagonal or square head one end and screwed the other or screwed both ends, each screwed end to be fitted with washer and one hexagonal or square nut exceeding 5 cm long, complete all as specified and directed.

Supply & fixing chain link fencing of 4mm dia mild steel galvanized wire and mesh size 100x100mm, including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified & directed.

Material and labour for applying two coats of synthetic enamel paint on steel surfaces over a coat of red oxide primer including preparation of new steel surfaces of any description not otherwise described over 10 cm width or girth, complete all as specified and as directed.

Material and labour for preparation of old plastered surfaces of walls and applying one coats of white wash on wall, complete all as specified and as directed.

Material and labour for one coat of cement base paint over old decorated plastered surface including preparation of surface complete all as specified and directed.

Supply and fixing framed work such as in ornamental gate of angle or other section, hung shutter,gates including pintle hinges, stops,hand-made sliding door bolts, grills, gratings, etc. with ends of shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders framed balusters; walk ways; railings; and similar work conforming to Fe-290.Gde-E-165, complete all as specified and directed.

S S Engineers & Contractor

Shubham Enterprises

PARVEEN KUMAR

Gupta Enterprises

peeyush construction and engineering co

Shiv Construction Co.