Construction of C.C. Road at Naranpar Naghuna Road Km. 3/050 to 3/750 of Jamnagar Taluka under Suvidhapath Yojna Package No. JAM/SP/2025-26/P-01.

Name of Work:- Construction of C.C. Road at Naranpar Naghuna Road Km. 3/050 to 3/750 of

Jamnagar Taluka under Suvidhapath Yojna Package No. JAM/SP/2025-26/P-01.

Taluka : Jamnagar Dist: Jamnagar.

BILL OF QUANTITIES

Sr. No. Description of Item (With brief Quantity Unit Rs. In Amount

specification and reference to book of figure

specifications)

1 Constructing of granular sub-base Gr-l by 429.00 Cum. 681.75

providing course graded B.T. machine

crushed material satisfying MOST

specification of grading I including spreading

in uniform layer with motor grader on

prepared surface, mixing by mix in place

method with rotavator at OMC and

compacting with vibratory roller to achieve

the desired density etc. complete.

2 Demolition including stacking of serviceable 801.00 Cum. 1108.12

materials and disposal of unserviceable

materials with all lead and lift. (i)R.C.C. work

3 Providing and filling in foundation with 382.00 Cum. 3362.24

ordinary cement concrete M-100 mix and

providing necessary vertical pin headers

including formwork vibrating ramming and

curing complete.

4 Construction of un-reinforced, dowel jointed, 572.00 Cum. 5578.23

plain cement concrete pavement over a

prepared sub base with concrete grade M30,

coarse and fine aggregate conforming to IS

383, maximum size of coarse aggregate not

exceeding 25 mm, mixed in a batching and

mixing plant as per approved mix design,

transported to site, laid with a fixed form or

slip form paver, spread, compacted and

finished in a continuous operation including

provision of contraction, expansion,

construction and longitudinal joints, joint

filler, separation membrane, sealant primer,

joint sealant, debonding strip, dowel bar, tie

rod, admixtures as approved, curing

compound, finishing to lines and grades as

5 Providing and fixing pre-cast Rubble 958.00 Sqm. 707.55

Dye/Steel inter locking concrete block 60mm

thick with grade concrete M30 pneumatic

compressed/Vibrated by mechanically and as

per approved design confirming to IS 1568:

2006 including 35 mm sand layer for levelling

and filling the joint with sand in proper line

and level as per guideline of IRC : SP 63-2018

1 of 4 DTP of CC Road Naranpar P-01 03-26.xls

Sr. No. Description of Item (With brief Quantity Unit Rs. In Amount

specification and reference to book of figure

specifications)

6 Providing and fixing pre-cast concrete kerb 1040.00 Rmt. 410.41

stone of grey cement based concrete block

30cm length,30cm height and 15cm thick of

M200 grade concert as per approved design

and including excavation for fixing in proper

line and level, filling the joint with 1:3 (1

cement : 3 fine sand) etc complete.

7 Supplying ,fixing & joining reinforced 30.00 Rmt. 969.60

concrete heavy duty non pressure pipe

carrying Indian railway standard with collars

for culverts caring heavy traffic as per Indian

railway standard specification including

setting and joining the pipe in cement mortar

watering or laying (to level and slope) of

I.S.class NP-3 300mm dia internal.

8 Supplying & Fixing R.C.C. Benches of RCC 10.00 No. 3535.00

1:2:4 finished with chaina mosaic tiles chips

and etc complete.

9 Village name Sign :-Providing and fixing sign 1.00 No. 6397.43

boards made out of 2mm aluminium sheet /

4mm ACP (Aluminum composite Panel); size

90x60 cms. rectangular as per design of IRC-

67-2012. Pre treated with phospheting

process & acid etching; coated with one coat

of epoxy primer and two coats of best quality

epoxy paint ; reflectorised with High Intensity

Prismatic Grade retro refiectivesheeting of

Type-4 as per ASTM D-4956 and latest

M.O.S.T.Specifications; 3.3mtr long stand

post of Iron Angle 75 x 75 x 6mm / 65NB

Circular MS Pipe as required and frame

fabricated from suitable size iron angle of 35 x

35 x 3mm; painted with bestquality epoxy

coatings in black and white bends. the details

of symbol or inscription / numerals for each

board shall be as per the instruction of

engineer in charge. The fixing at site shall be

in 1:2:4 CC blockof size 45 x 45 x 60 Cms. for

each leg including excavation, curing

etc.complete under the supervision of

engineer in charge. A warranty for 7 years for

the Retro reflective sheeting from original

manufacturer & a certified copy of 3 year

outdoor exposure test report from third party

test lab for the product offered shall be

submitted by contractor. (B) Class-B Type-4

Retro Reflective sheeting

10 Providing fixing logo board of Suvidhapath as 2.00 No. 2268.40

per standard design of National Rural Road

Development Agency diamond size 600 x

mm , 1.50mm thick plate board size 900 x

250mm , 1.50mm thick MS, plate and

meter deep length single angle 75 x 75 x 6 mm

size incl fitting & painting lettering with

luminous colour as per drawing including

fixing in C.C- 1:3:6 etc. complete.

2 of 4 DTP of CC Road Naranpar P-01 03-26.xls

Sr. No. Description of Item (With brief Quantity Unit Rs. In Amount

specification and reference to book of figure

specifications)

11 Road marking with hot applied thermoplastic 189.00 Sqm. 367.72

paints with reflectorising glass beads on

bitumin surface providing and laying a hot

applied thermoplastic compound 2.5 mm

thick including reflectorising glass beads @

250gms per sqm area. thickness Of 2.5mm is

excluding Of surface applied Wass beds as

per IRC:35-2015. The finished surface to be

level, uniform and free from streaks and

holes. zebra patta /bump patta lane/center

line/ edge line/cut patta. The white color

marking should provide luminance coefficient

on cement road shall be min 130 mcd/m2/lux

and Asphalt road shall be min 100 mcd/m2/Iux

during the service life during the day time.

The marking should meet the performance

criteria for night time reflectivity, wet

reflectivity and skid resistance as mentioned

in the section-15 of IRC 35-2015.

12 Cat Eye / Road Stud / RPM: Supplying Raised 174.00 No. 217.40

Pavement Markers made of polycarbonate

and ABS moulded body and reflective panels

with Micro prismatic lens (NO Glass lens)

capable of providing total internal reflection

of the light entering the lens face and shall

support a load of 13635 kgs. tested in

accordance to ASTM D 4280 Type H and

complying to Specifications of Category A of

MORTH Circular No RW/NH/33023/10-97 - DO

Ill Dt 11.06. 1997. height, width and length

shall not exceed 20 mm, 130 mm and 130 mm

and with minimum reflective area of 13 Sqcm

on each side and the slope to the base Shall

be 35 +/-5 degree. The body of the marker

Should having finger grip for easy and

accurate placement and application with

epoxy bituminous Adhesive as recommended

by the manufacturer of the marker. The colour

of the marker should be as per the IRC 35-

2015 and as directed by Engineer-in-Charge.

Amount of my tender work out as under

I / We am/are willing to carry out the work at ………………………………………….. % above / below Percent

[should be written in figures and words] of the estimated rates mantioned above. Amount of my/our tender

works out as under

Estimated Amount Put to tender: Estimated Amount Put to tender:

Deduct % below Add % above

Net Rs. Net Rs.

In words : In words :

Signature of Contractor

Deputy Executive Engineer Executive Engineer

Panchayat (R & B) Sub Division Panchayat (R & B) Division

Jamnagar Jamnagar.

3 of 4 DTP of CC Road Naranpar P-01 03-26.xls

Sr. No. Description of Item (With brief Quantity Unit Rs. In Amount

specification and reference to book of figure

specifications)

1 All work shall be carried out as per Public Works Department Handbook and other

specifications of Division or as directed.

2 All the columns is Schedule should be filled in ink and the total of the entries in the last

column should be struck by the contractor under his signature.

3 Rates quoted include clearance of site (prior commencement of work and at its close )

in all respects and hold good for work under all conditions, site, moisture, weather etc.

4 The contractor shall exhibit the board at site of work with the details of works, Tender

amount and specification as per Govt. Circular No. BBG / 3277 / 1657 / N, Dt.26-4-78

and as per G.R.No. TNC -1090-24-C, Dt.18-11-91, as directed by Engineer-in-charge of

the works, exhibit board at site of work, for which contractor is not entitiled for any

5 Contractor shall even " NIL " percentage, if no deduction is offered.

6 One percent of work done amount of this work shall be recovered from the contractor

payment as " Labour Cess " in terms of the Guajarat Govt. gazette extra ordinary dt.

12/12/2004 implementation of building and other construction works.(Regulation of

employment & condition of service act

7 Testing of materials shall be as per statement attched for quality control. The material

shall be tested in GERI bill for the testing charge shall be paid by the Department and

% (One percent) of amount put to tender after deduction of cost of material as per

scheule-A shall be recovered from the contractor's running Bill as per GR of R.& B.

Dept. No.TNC / 1085 / 4 / C Dt. 20-12-91 & modified R.& B. Dept. Circular No.SSR /

Signature of Contractor :

Deputy Executive Engineer Executive Engineer

Panchayat (R & B) Sub Division Panchayat ( R & B ) Division,

Jamnagar Jamnagar

4 of 4 DTP of CC Road Naranpar P-01 03-26.xls