PROVN OF SHED AND DRAINAGE LINE IN MES BLDG NO S AND T-04 OF 122 INF BN (TA) MADRAS AT WEST HILL STN CALICUT UNDER GE (ARMY) TRIVANDRUM

Earth work in excavation by mechanical means (Hydraulic excavator) over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) in all kind of soil including getting out soil and disposal of excavated earth lead upto 50 m and lift upto 1.5m, complete all as specified and directed.

Earth work in excavation in ordinary rock by mechanical means (Hydraulic excavator) over areas in all kind of soil (exceeding 1.5 m and not exceeding 3.00 m in depth, 1.5 m in width as well as 10 sqm on plan), including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead upto 50 m and lift upto 1.5m complete all as specified and directed.

M&L Plain cement concrete (1:4:8) type D-2 using 40 mm graded stone aggregate for footing in foundations, filling and mass concrete complete all as specified and directed.

M&L Reinforced cement concrete (design mix) M-30 using 20 mm graded stone aggregates as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and directed.

M&L use and waste of timber as in formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter, for flat rough finished surfaces of concrete complete all as specified and directed.

M&L for reinforced cement concrete (Design Mix) M-30 (20 mm graded aggregate) Columns, pillars, piers, posts and struts complete all as specified and directed

M&L for use and waste of Formwork to sides of pillars, posts, struts, piers, columns and stanchions in square, rectangular and polygonal shape to rough finished surfaces of concrete complete all as specified and directed.

S&F steel TMT bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed

S&F steel TMT bars 5mm dia and over up to and including 10 mm dia, cut to length, bent to shape required, including cranking, bending spirally for hooping in stirrups, spacers and binders, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in soil obtained from excavation here-in-before complete all as specified and directed.