MINI MAST LIGHT SYSTEM RE TENDER

Amount

Supply Erection and commissioning of 100W *4 LED Flood light MINI MAST SYSTEM.

Supply installation testing and commissioning of Octogaonal Pole made of hot dip galvanised GI sheet 70mm top diameter. 130mm bottom diameter thickness 3mm base plate dimensions of 200x200x16mm suitable for windspeed as per IS 875 Part III fixed head frame including round arm luminary carriage suitable to install 4/6 nos luminaries in symmetrical arrangement including connector foundation bolt 4 nos existing RCC foundation and junction box etc, complete 8 Meters.90.15.1.1(24 Nos), Supply Conveyance, installation, testing and commissioning of 100W LED Flood light output greater than 105lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than 10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer) [90.15.4.7] (96 Nos), Fabrication of fully partitioned, dust and vermin proof enclosure for panel assembly as per form 4 of IS 8623 (with latest amendments) using CRCA sheet as per approved design and requirement, with front and rear access facility, bus bar chambers, hinged doors for all switch gear compartments, earthing the doors using 4 sq mm braided copper conductor, providing necessary cut-outs for mounting meters, relays, indication lamps, bus bar interconnection etc, detachable covers for bus bar chamber and cable alley, powder coating the assembly after subjecting to 7 tank process etc as required. CRCA sheet alone be used for the fabrication. Angles/ flats/ slotted angles etc shall not be used for the fabrication of panel assembly. The measurments will be taken the area of the complete sheets used for panel board including partitions, folding, shrouding etc.Supply and fabrication of MV panel board using 1.6mm CRCA sheet, powder coated (excluding base frame) 90.14.1.2 (36 Nos), Supply and providing heavy duty 'A' section neoprene gasket in the panel boardA' section neoprene beeding suitable for 1.60/ 2.00 mm sheet. 90.14.3.1 (120 nos), Supply and fabrication conveyance and installation of angle iron frame work for wall mounting panel board. 90.14.5 (150 Nos), Excavation for foundation in soft soil including dressing of sides and ramming of bottoms, lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 metres. 14.1 (36 Nos), Form work for reinforced cement concrete in slabs including wooden planks,joists,bamboo posts and labour for taking down after completion of work.(Hire and labour charges only) 14.10(17.28 meter), Steel reinforcement for RCC Work including straightening, cutting, bending, placing in position and binding all complete. od117945/2019_2020 (840 nos), Supply & laying of one number PVC insulated and PVC sheathed armoured aluminium power cable of 1.1KV grade of the following sizes in the existing RCC/ HUME / STONE WARE/ GI/ DWC pipe as required. 2 core 6 sq mm. 90.12.5.2 (150 Nos), Supply & laying of DWC pipe in ordinary soil 0.75m below ground level including excavation 50/38 mm or nearest size. 90.12.10.2 (150 Nos), Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed/XLPE aluminium conductor cable of 1.1 KV grade as required. 2X 6 sq. mm (19mm) 9.1.1 (48 nos), Supply and drawing the following sizes of multi-core PVC insulated & FRLS PVC sheathed 650/1100 V grade copper conductor round flexible cables conforming to IS 694 part I 1960 in the existing surface / recess conduit as required including giving necessary connections of the following sizes.3 core 1.50 sq mm. 90.6.5.11 (768 Nos), Supply and providing Nylon stay wire for supporting weather proof service wire including binding the WP wire using Alu.wire as required. od567929/2019_2020 (360 Nos), Carrying out control wiring for panel with normal meters and indication lamps for interconnecting the control devices/ equipments including providing suitable size insulated sockets at the termination points or soldered properly, providing numbering ferrules for the proper identification of the wiring, keeping the wiring firm by suitable tie/ tie mounts/ PVC duct etc as required.-2.50 sq mm single run with required sockets. od117939/2019_2020 (60 Nos), Carrying out control wiring for panel 4.00 sq mm single run with required sockets. od117941/2019_2020 (60 Nos), Supplying and fixing 32A 2Pole AC1 Power contractor in 1the existing MCB DB/enclosure complete with connections, testing and commissioning etc. as required. od117959/ 2019_2020 (24 Nos), Supplying and fixing 24Hours Timer for operating ON -OFF function in 1the existing MCB DB/enclosure complete with connections, testing and commissioning etc. as required. L &T make/equivalent.od118364/2019_ 2020 (24 Nos), Supplying and fixing following rating, double pole, (single phase and neutral), 240 volts, residualcurrent circuit breaker (RCCB), having a sensitivity current upto 300 milliamperes in the existing MCB DB complete with connections, testing and commissioning etc. as required.25 amps. 2.14.1 (24 Nos), Supplying and fixing following rating, double pole, 240 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required.40 amps. 2.12.1 (24 Nos), Supplying and fixing 5 amps to 32 amps rating, 240/415 volts, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required.Single pole. 2.10.1 (96 Nos), upplying and fixing following rating, double pole, 240 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required.40 amps. 2.12.1 (24 Nos), Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories,test joint and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2 metre long etc. with charcoal/ coke as required. od117953/ 2019_2020 (24 Nos), Supply and providing earth lead from the test joint to the earth electrode using 25 x 3 mm GI strip of conductors/ strips including cutting, drilling necessary holes (in case of strip) and fixing firmly with plate test joint etc as required. od117955/2019_2020(86.4 meter),Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required. 2.65 mm copper conductor (12 SWG) 90.16.1.2(24 Nos) , Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required. 3.15 mm copper conductor(10SWG) 90.16.1.3 (171 Nos), Supply and laying of the following sizes of B class GI pipe laid 0.6 m below ground level including excavating trench of suitable size and refilling etc, as required.15.mm dia. G.I pipe ( medium class) 90.16.2.1(120 Nos), Supply and fixing Danger notice board of size, 125 x 75 mm. od117957/2019_2020 (24 Nos), Supplying and fixing 32, HRC Fuse base with HRC Fuse link with connections, in existing meter board. od117967/2019_2020 (24 Nos), Supply and fixing of 32 A, 2 Way neutral links mounted on DMC/SMC base. od117969/2019_2020(24 Nos), Supply, conveyance and erection of the following sizes of 'B' class GI pipe in single section for post top lantern of all types on concrete base (excluding charges for concrete base and excavation) and painting with 2 coats of synthetic enamel paint over a coat of zinc chromate primer etc. as required.40 mm dia GI pipe. 90.3.17.2 (72Nos),

KERALA STATE INDUSTRIAL ENTERPRISES LIMITED

Ammini Energy Systems Pvt Ltd

USHA ELECTRONICS SYSTEMS

Krishna Associates

ADVAITH ASSOCIATES

POWERLINE AGENCIES

AIRMECH AIRCONDITIONING ENGINEERS