Replacement of ACSR Conductor by 33 KV AAAC AL-59, 241 sqmm. Covered Conductor from Doon Institute to 33/11 KV Sub-Station, Veerbhadra of 33 KV Raiwala feeder under EDSD, Raiwala under EDD, Rishikesh.

Total amount of the "Rate Schedule" sheet

SCHEDULE OF QUANTITY AND RATE FOR REPLACEMENT OF ACSR CONDUCTOR BY 33 KV AAAC AL-59, 241 SQMM. COVERED CONDUCTOR FROM DOON INSTITUTE TO 33/11 KV SUB-STATION, VEERBHADRA OF 33 KV RAIWALA FEEDER UNDER EDSD, RAIWALA UNDER EDD, RISHIKESH AGAINST E-TENDER SPECIFICATION NO.82/EDCRDDUN/2025-26

Name of The Bidder's Firm:

Part [A] (Supply Portion)

PP & Clamp with N&B ST Pole SP-55

33 KV Tension Clamp with Bail & IPC

33 KV Cable Ties for Pin Insulator

33 KV IPC for Covered Conductor to Covered Conductor

33 KV IPC for Covered Conductor to Bare Conductor

33 KV Mid Span Jointing Kit

33 KV IPC with Aluminium Bail for earthing

33 KV AAAC Covered Conductor, AL 59, 241 sqmm.

Total - Part [A]

Part [B] (Labour Portion)

Cartage of ST pole from store centre to construction site with loading, unloading at both points and proper stacking. (0-20 Km.)

Cartage of other material (other than poles) by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends. (0-20 Km.)

Rs.Per Qtl.

Head load cartage of following Poles from road to site. Upto 0 to 1 Km.

Head load cartage of Small material. Rates are per Km/Quintal including loading and Unloading.

Upto 0 to 1 Km.

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESPO construction Manual.

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement: 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement, sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO construction Manual.

Chemical Earthing: Earthing of distribution transformer including digging of pit of size 2.5 Mtr depth and make hole of size 150 mm. Placing of earthing electrode (to be supplied by contractor as per drawing No. A) as drawing B, connecting the same with G.I. Strip (to be supplied by contractor ) of size 35x6 mm as per drawing C for a minimum lenght 6 m. treatment of soil with highly condctive substance as per IS 30343 complete in all respect, result of earthing resistance to be recroded in M.B. before and after installation of earthing. The earth resistance after earthing should be less than 1 Ohm.

Earthing with M.S. Earth rod of 2.5 meter long by hammering of M.S. Rod to proper depth and connecting the earth electrode with the help of G.I. wire as per construction manual.

Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESSPO sehedule and local approved drawing.

Excavation of earth for Stay pit of size 0.6x0.6x1/2 mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Fixing , tightening and nozzaling of Stay with pole and stay rod on required tension as per drawing / RESPO manual.

33 KV line

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cernent,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO Manual.

Fixing of PP & Clamp with N&B for ST Pole SP-55

Fixing of Anti Climbing Device

Fixing of 33 KV Disc Insulator

Fixing of 33 KV Pin Insulator

Looping and Chopping of Tree Branches

Removing Old Conductor by Opening Jumper

Erection of Danger Board Clamp for SP-55

Fixing of 33 KV Tension Clamp with IPC

Fixing of 33 KV Cable Ties

Fixing of 33 KV IPC for Covered Conductor to Covered Conductor

Fixing of 33 KV IPC for Covered Conductor to Bare Conductor

Fixing of 33 KV Mid Span Jointing Kit

Fixing of IPC with Aluminium Bail for Earthing

Laying Spreading, Stringing of 33 KV AAAC Covered Conductor

Painting of Pole

Total - Part [B]

TOTAL [Part-(A) + Part (B)]

Place

Please Enable Macros to View BoQ information