LAYING OF PAVER BLOCK AT JEYPORE AFS WITH WBM AS PER DETAILED SCOPE OF WORK

BILL OF QUANTITY/PRICE BID FORMAT

(Below mentioned to be filled & uploaded)

Price Bid calculation for Paver block laying job at Jeypore AFS

Description Unit Rate/Unit Amount

Supplying & laying CC paver blocks 80mm thick using minimum M 300 Sq.

35 grade laid on 50mm avg thickness of coarse sand bedding M

Supplying and spreading stone aggregate of required size to

achieve the required thickness as mentioned below, followed by

supplying and spreading 12 mm down stone aggregate to fill

voids, re-rolling the same with 8 - 10 ton roller, followed by

supplying and spreading binding material of plasticity index

upto 6% such as murrum or quarry dust or approved quality

earth, consolidating the same with optimum water moisture till

the surface is evenly and densely consolidate to achieve. NOTE :

Please note that each layer of stone aggregate has to be

consolidated with 8 - 10 ton roller. During the murrum filling,

watering should be done per each run of the roller and

minimum 5 such runs have to be undertaken on subgrade.

During each such run if any void is observed after watering the

same shall be filled using 1:1mix of 12 mm metal & murrum.

The spreading of binding material, sprinkling of water, sweeping

with a broom and rolling shall continue until the slurry that is

formed well after filling the voids formed ahead of the wheels of

the moving roller and any undulations in the surface developed

due to rolling shall be made good. The rates should be

inclusive of all cost of equipment, material, labour etc.

mm thick compacted WBM using stone aggregate of size 63- 300 Sq.

90 mm. Area to be covered is 300 Sq. M. M

Supplying and spreading stone aggregate of required size to

achieve the required thickness as mentioned below, followed by

supplying and spreading 12 mm down stone aggregate to fill

voids, re-rolling the same with 8 - 10 ton roller, followed by

supplying and spreading binding material of plasticity index upto

6% such as murrum or quarry dust or approved quality earth,

consolidating the same with optimum water moisture till the

surface is evenly and densely consolidate to achieve. NOTE :

Please note that each layer of stone aggregate has to be

consolidated with 8 - 10 ton roller. During the murrum filling,

watering should be done per each run of the roller and minimum

5 such runs have to be undertaken on subgrade. During each such

run if any void is observed after watering the same shall be filled Cubic

using 1:1mix of 12 mm metal & murrum. The spreading of Meter

binding material, sprinkling of water, sweeping with a broom and

rolling shall continue until the slurry that is formed well after

filling the voids formed ahead of the wheels of the moving roller

and any undulations in the surface developed due to rolling shall

be made good. The rates should be inclusive of all cost of

equipment, material, labour etc. Compaction to achieve the

required compacted thickness WBM using stone aggregate of

size 45-63 mm. Volume required is 30 Cubic meter.

Surface dressing of the ground including removing vegetation and in-

equalites not exceeding 150mm deep and disposal of rubbish; lead

upto100m, including ramming and levelling the surface as per the 300 Sq.

directions of Engineer-in-Charge M

Total amount in words:

Note: This price bid should be filled up, signed and scanned and to be uploaded on the

https://bpcltenders.eproc.in site along with the other documents.

Signature of the tenderer with stamp Date: