Rate Contract for SITC of Different Capacity UPS(Uninterrupted Power Supply) System in C. H. Nagri Muni. Eye Hospital & Other Hospital/College/Hostel Buildings of AMC-MET. (Within Limit of Amount Rs.10.00 Lacs)

(Technical Bid only) of Tender

Office, Mezzanine Floor, “B”-Block,

in Physical form Sardar Patel Bhavan, Danapith,

Ahmedabad-380001.

4 Tender Vol-I (Technical Bid on 15/05/2026, 04:05 pm onwards

only) Opening Date, Time and Online Opening:- At the Office of

Place Additional Chief Engineer(Electrical),

Light Department, 5th Floor, “C”-Block,

Sardar Patel Bhavan, Danapith,

Ahmedabad-380001.

Physical Opening:-At the Office of Tender

Officer, Central Record Office, Mezzanine

Floor, “B”-Block, Sardar Patel Bhavan,

Danapith, Ahmedabad - 380001 or at

the above said office.

MUNICIPAL COMMISSIONER

Ahmedabad Municipal Corporation

Sardar Patel Bhavan,Danapith

VOL.-II (FOR REFERANCE ONLY)

Rate Contract for SITC of Different Capacity UPS(Uninterrupted

Power Supply) System in C. H. Nagri Muni. Eye Hospital & Other

Hospital/College/Hostel Buildings of AMC-MET.

(Within Limit of Amount Rs.10.00 Lacs)

Item Description Unit Qty Unit (Without

PART (A) - SITC

Supplying and erecting approved

make online Un-interruptible

Power Supply system comprising

flat cum-boost charger with IGBT

base rectifier & Inverter & sealed

maintenance free SMF batteries.

The charger having operating

capacity for input 160-270V AC &

inverter having output 230V,50

1.01 Hz Ac with 0.8 load power factor Ea. 1

with battery, over/under voltage

output with over load & short

circuit protection equipment. The

system housed in CRC sheet duly

powder coated paint with following

power backup.with MS painted

batteries stand, 10% Overload

capacity for momentary load.

(A) 1 KVA with 1Hr Backup

Same as Above for -

(B) 2KVA with 1Hr Backup

Same as Above for -

(C) 3 KVA with 1Hr Backup

Same as Above for -

(D) 5 KVA with 1Hr Backup

Providing Batteries With Standard

. IEC61056-3 OR JIS C

Battery type - Maintenance Free

Or Minimum Maintenance Lead

Acid, Battery @ C20 Rating -12V,

Cut Off Voltage( at 25 deg C-

10.2V, Float Charging Voltage-

13.5 volts per module @ 27 deg C,

Voltage ripple allowable - <2% of

the RMS value, AH Efficiency-

Above 95%, Operating

Temperature range of Battery- -20

deg C to + 60 deg C, Date of

manufacturing - The date of

Manufacturing shall not be more

than 6 Months older than the date

Same as Above for –

Same as Above for –

Same as Above for –

Same as Above for –T

Same as Above for –

Same as Above for –

Same as Above for –

Same as Above for –

Same as Above for –

Point wiring for Light / Bell with

2-1.5 sq.mm & earth wire of

sq.mm (Green) both are of ISI

marked 1.1 KV grade FRLS PVC

insulated multi strand copper

wires up to 10 mtr length , in

below type of pipe erected with 6A

Modular type switch / bell push &

accessories and earth continuity

of following type, erected on PVC /

Metallic/Wooden box, single

mounting base frame covered

with textured/metallic/white front

plate modules erected on / in

wall / ceiling as per pipe erected,

with necessary Lamp

holder/ceiling rose /

H.D.Connector as directed.(e) in

existing pipe erected flushed on

wall/ceiling complete Cat. III

Point wiring for Individual Plug

with & earth wire of 1.5 sq.mm

(Green) both are of ISI marked

KV grade FRLS PVC insulated

multi strand copper wires up to

10 mtr length, in below type of

pipe erected complete with

Modular type switch & 5 pin Plug

erected on PVC / Metallic/Wooden

4.01 box covered with appropriate front Pt. 1

plate modules erected on / in wall

/ ceiling as per pipe erected with

following type of accessories.

[I] For 6A Plug and 6 a switch

with 2-1.5 sq.mm Cu. Wire from

nearby switchboard/mcb db

(e) in existing pipe erected flushed

on wall/ceiling complete Cat. III

Same as Above for -

[II] For 16A Plug and 16 amp

switch with 2-2.5 sq.mm Cu.

Wire from mcb db board.

(e) in existing pipe erected flushed

on wall/ceiling complete Cat. III

Point wiring for on board Looped

Plug with 6A Modular type switch

& 5 pin socket erected on PVC /

Metallic/Wooden box, single

5.00 mounting base frame covered with Pt. 1

textured / metallic/white front

plate modules erected on / in

wall / ceiling with following type

accessories Cat.III

Providing and erecting ISI mark

Medium class RIGID PVC PIPES of

following size complete to be

erected on/in wall or ceiling

erected with necessary PVC

fittings & Junction boxes fixed

with adhesive solution & Clamps

with following dia of pipes, in

approved manner as directed

6.02 Same as Above for -(b) 25 mm Mtr. 1

Same as Above for –

Same as Above for –

Supplying and laying UPVC cable

trunking system comprising

unplasticised polyvinyl, chloride

rigid material with ignition free

and flame proof confirming BS

7.01 with necessary end caps Internal Mtr. 1

and external bend, flat bends,

coupler, tee etc..All necessary

accessories and measuring of

following sizes

(1) 75 mm x 50 mm trunking

Same as Above for –

(2) 100 mm x 50 mm trunking

Same as Above for –

(3) 50 mm x 50 mm trunking

Same as Above for –

(4)100 mm x 50 mm trunking with

TWIN compartment With clip in

Providing and erecting Mains with

1.1 KV grade FRLS PVC insulated

ISI marked stranded Copper

conductor wire in following type of

pipe to be erected concealed in

/flushed on wall/ceiling, with

8.01 sq. mm copper conductor FRLS Mtr. 1

PVC insulated stranded wire of

green colour for earth continuity

of following size

(A) With medium class Rigid PVC

pipe and accessories

(a) 2 wire 1.5 sq. mm

Same as Above for –

(b) 2 wire 2.5 sq. mm

Same as Above for –

(c) 3 wire 1.5 sq. mm

Same as Above for –

(d) 3 wire 2.5 sq. mm

Same as Above for –

(e) 4 wire 1.5 sq. mm

Same as Above for –

(f) 4 wire 2.5 sq. mm

Providing and erecting Mains with

1.1 KV grade FRLS PVC insulated

ISI marked stranded Copper

conductor wire in following type of

9.01 pipe to be erected in / on wall / Mtr. 1

ceiling with 2.5 sq. mm copper

conductor FRLS PVC insulated

stranded wire of green colour for

earth continuity of following size

(E) in existing pipe

(a) 2 wire 4 sq. mm

Same as Above for –

(b) 2 wire 6 sq. mm

Providing and erecting Mains with

ISI marked, 1.5KV grade

electrolyte multi stranded,

annealed copper conductor with

heat resistant PVC insulated

conforms to IS 694, IEC -

erected in existing pipe of

following size (Specifically for

control panel, relays, power

switchgears, motor starters &

control wiring) with required size

of copper lugs, nuts and bolts if

(e) One wire 6.00 sq. mm

Same as Above for –

(f) One wire 10.00 sq. mm

Same as Above for –

(g) One wire 16.00 sq. mm

Providing and erecting

XLPE(IS:7098)(I)-88 ISI armoured

cable multistrand Copper

conductor for 1.1 KV. to be laid

on wall with necessary clamps or

in existing trench / pipe at road

crossing or floor of following size

(A) 3 1/2 core 25 Sq. mm (10 Sq.

Same as Above for –

11.02 (B) 3 1/2 core 35 Sq. mm (16 Sq. Mtr. 1

SITC of 14.2 mm dia 3 mtr long

Earth electrode of High tensile

steel electrode with 250 micron

copper bonding & 1 bag of Carbon

fill Based environment friendly

backfill tested as per IEC 62561-7

in NABL accredited Laboratory Per

and suitable stainless Steel double Set

sided clamp. Eco Friendly rust

proof heavy duty weather proof

Polyethylene Earth Pit Chamber

with following dimensions :254

mm dia (top), 330 mm dia

(bottom) & 260 mm (height).

providing and erecting Miniature

circuit breaker single pole 6A to

25A suitable to operate on 240 V

13.00 A.C. system and having breaking Ea. 1

capacity 10 KA to be erected in

existing box. confirming to IS

8828/1996 with ISI Mark Cat.III

Providing & erecting 240 V MCB

double pole switch for motor &

inductive load (C Curve) having

14.01 10 KA breaking capacity & Ea. 1

confirms to IS : 8828 in existing

box having following capacity

(A) 6 to 32 Amp. Cat.III

Same as Above for –

(B) 40 Amp. Cat.III

Providing & erecting 415 V MCB

Four Pole for Motor & Inductive

Load (C Curve) having 10KA

15.01 breaking capacity & confirms to IS Ea. 1

:8828 in existing box having

following capacity

(a) 6 to 32 Amp. Cat.III

Same as Above for –

(b)40 Amp. Cat.III

Same as Above for –

(c)63 Amp. Cat.III

Providing and erecting Sheet Steel

powder coated MCB distribution

board - flush / surface mounted

fitted with busbar, neutral link,

earth bar and DIN rail, Conforms

3 without MCB to house

16.01 appropriate nos. of MCBs.(The Ea. 1

DBs should be used of same

company of MCB to be used)

(A) single phase incoming and

horizontal single phase outgoing

(b) sheet steel double door (IP-43)

Same as Above for –

Same as Above for –

Same as Above for –

Providing and erecting Sheet Steel

powder coated MCB distribution

board - flush / surface mounted

fitted with busbar, neutral link,

earth bar and DIN rail, Conforms

3 without MCB to house

appropriate nos. of MCBs.(The

16.05 DBs should be used of same Ea. 1

company of MCB to be used)

(B) three phase incoming and

single phase horizontal type

outgoing Per phase isolation type

(b) sheet steel double door

Same as Above for –

Same as Above for –

Same as Above for –

Providing and erecting Approved

make Four pole moulded case

circuit breaker having breaking

capacity ICU of 25 KA. at

V,having normal current rating up

to 25 A to 100A. with Fixed

17.00 thermal & magnetic release Ea. 1

suitable to work on A.C. supply

c/s. with all internal connections,

spreader tinned copper &

complete erected in existing

G.M.S. housing. ICS=100% of ICU

Providing and erecting Approved

make Four pole moulded case

circuit breaker having breaking

capacity ICU of 35 KA. at 415 V.

having normal current rating

125A. with Fixed thermal &

18.00 magnetic release suitable to work Ea. 1

on A.C.supply 50 c/s. with all

internal connections, spreader

tinned copper & complete erected

in existing 16 G.M.S. housing.

ICS=100% of ICU only

Providing, erecting, fabricating the

M.S. structure as per requirement

on site incorporating proper size of

M.S. angles, square, round, flats,

bars, channels, sections complete

19.00 with cutting, welding, grinding & Kg. 1

finishing duly painted with one

coat of red oxide with erection on

site as per direction of engineer in

charge with necessary grouting,

cementing, plastering & finishing

TOTAL AMOUNT OF PART (A) IN Rs.

TOTAL AMOUNT OF PART (A) IN Rs.

PART (B) - BUYBACK RATE FOR

20.01 (A) 1 KVA with 1Hr Backup Ea. 1

20.02 (B) 2KVA with 1Hr Backup Ea. 1

20.03 (C) 3 KVA with 1Hr Backup Ea. 1

20.04 (D) 5 KVA with 1Hr Backup Ea. 1

20.05 [E] 6 KVA with 1Hr Backup Ea. 1

20.06 [G] 7.5 KVA with 1Hr Backup Ea. 1

20.07 [H} 10 KVA with 1Hr Backup Ea. 1

TOTAL AMOUNT OF PART (B) IN Rs.

TOTAL AMOUNT OF PART (B) IN Rs.

1 Amount of Part (A) in Rs.

2 Amount of Part (B) in Rs.

Total Estimted Amount(Without GST) PART

(A) - PART (B) in Rs.

4 GST @ 18% in Rs.

Total Estimted Amount(With GST) PART (A)

- PART (B) in Rs.

I/We am/are willing to carry out work at____________%above or

___________% Below the estimated cost mentioned above.

NOTE:-(1) The Quoted Rate shall be inclusive of all taxes.

Signature of the Tenderer Addl. Chief Engineer

Name: (Electrical)

Company’s seal: AMC