Carring Out Revival of Twin Tube Hydraulic Piezometers to be Installed in Mukteshwer Dam in the Terminal well at Ch 0 to 260 mt. (IInd Attempt)

BILL OF QUANTITIES

Name of Work :- Carring Out Revival of Twin Tube Hydraulic Piezometers to be

Installed in Mukteshwer Dam in the Terminal well at Ch 0 to

mt. (IInd Attempt)

(A) Percentage Rate Tender (Up to INR 50 Cr. )

Item Description of Item (with brief specification Quantity Unit Rate In Amount

No and reference to book of specifications) figures

1 Flushing of twin tube piezometers by triple x pump by

applying water solvent(water solvent is prepared by

using copper sulphate & aerol in required proportion by 32.00 Nos 7900.00

direct & reverse flushing methods to all piezometers at

site of work & as directed by eng in charge etc complete

2 Providing & fixing of Twin Tube Gauge (including

calibration certificate), 100mm bourdon type compound

Hydrostatic gauge (including calibration). Units: 0 – 64.00 Nos 6453.00

60mt, Resolution: ±0.5%

as per direction of engineer- in-charge etc complete

3 Providing & fixing of Outlet Valve and Inlet valve

6mm Brass Plug Valve with necessary fittings like Brass

nipple, Brass half-union, Brass coupling nut, Brass 64.00 Nos 4720.00

compression ferrule etc. are to be replaced. as per

direction of engineer- in-charge etc. complete

4 Providing & fixing of Master gauge (with calibration

certificate) 200mm bourdon type compound Hydrostatic

gauge (including calibration). Mt. per head, 0 – 100mt. 1.00 Nos 25005.00

units, Resolution : ±0.2% as per direction of engineer- in-

5 Providing and fixing of trpilex flushing Pump with self

pressure controlling uit and two outlets or more outlets.

6 Supply & fixing of Panel board for fixing with Twin Tube

Hyfraulic Piezometer Pipes , Valves & gauges including 7.00 Nos 12120.00

7 Providing & fixing of high pressure nylon pipes for

8 Addistional AMC for 2 Years including flushing and data

Rupees Fifteen Lakh Fifty Four Thousand Three Hundred Twenty One Only

I/We am/are willing to carry out the work at… ...................... % above/below percent(Should

be written in figures and words) of the estimated rate mentioned above. Amount of my /our

tender works out as under.

Estimated amount put to tender Estimated amount put to tender

Deduct………% below Add………% Above

In words In words

(B) For Item Rate Tender (For above INR 50 Cr.):

Item Description of Item Quantity Unit Rate Amount

No (with brief specification

and reference to book of In In

specifications) figures Words

(A) Total Tendered Amount

(B) Rebate on above tendered amount (if any) % (in figure) ………………………………

(C)Net Tendered Amount (A-B) (in figure) ………………………………

1. The Contractor shall exhibit a board with brief details of work as directed by the Engineer-In-Charge

for which no extra payment shall be made.

2. The labour cess will be deducted as per prevailing rules i.e. 1% of the work done.

3. GST and Income tax TDS will be deducted at a source while making payments of bills

4. In all R.C.C. Items in Rate Analysis Standard Cement Consumption has been taken as per Govt. G.R. NO.:

MIS102010/17/K1 Dated:30/07/2018 as stated in S.O.R. therefore in R.C.C. items where there is a change

as per actual mix design the cost of difference of cement consumption have been deducted from the rate of

original item at the rate of input rate mentioned in all the tender.

Deputy Executive Engineer Sr. Divisional Accounts Officer Executive Engineer

Mkt. H.W. Sub Dn. No-1 Sipu Project Division Sipu Project Division

Mukteshwar Palanpur Palanpur