Immediate restoration of rain damages to LWSS Mohal near PWD workshop in Tehsil Bhuntar Distt. Kullu H.P

Excavation in foundation trenches etc. in all kinds of earth work such as spade work, pick work, jumper work saturated /un saturated soil blasting work and chiseling/wedging out of rocks where blasting work prohibited up to all depth and lifts including pumping and bailing out water where ever required stacking the excavated earth not more than 3mtrs.clear from the edge of excavation and then returning the stacked soil in 15cm.layers when required into the plinth sides of foundation etc. consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated material within all leads and lifts, useful material available from excavation to be properly stacked and handed over free of cost to the department complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Providing and laying cement concrete 1:4:8 ( 1cement:4 sand: 8 graded stone aggregate 40 mm nominal size )and curing complete excluding the cost of form in foundation and plinth complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Providing and laying cement concrete 1:1.5:3 (1cement:1.5 sand : 3graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and re-inforcement for reinforced concrete work complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Foundations, footings, bases of columns and the like and mass concrete.

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a rough finish including centering shuttering strutting and propping etc. height of propping and centering below supporting floor to ceiling not exceeding 4mtrs.and removal of the same for in situ reinforced concrete and plain concrete work complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

a)Vertical surfaces such as walls (any thickness)portions and the like including attached pilaster buttresses plinth and string course and the like

Providing and laying tor steel reinforcement for RCC work including bending, binding and placing in position complete up to floor two level including cost of binding wires and carriage of materials complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge.

Stones / Boulder Filling Behind the R/ Walls , Also under floor etc. in all lifts & Leads complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Providing and fixing fully automatic panel board made of 16 gauge MS Sheet powder coated including all component such as ICTP main switch, MCCB, ELCB, copper bus bar 3 phase indication lamp, multifunction meter showing all parameter such as current voltage, frequency, power factor, power etc capacitor L&T make 100 BHP including ON/OFF push button thermal overload relay including all accessories such as nuts, bolts and thimble mounted on angle frame complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Providing and fixing foundation bolts of size 18mm round made of tor steel 1m length for hoisting bas plate of the pumping machinery complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Providing and laying copper PVC insulated power cable of suitable size and capacity to motors and all other electrical equipments of make such as Seimens/ Havells including all other accessories such as thimble flexible pipe nuts and bolts cable etc complete work with in all leads and lifts as per the entire satisfaction & direction of the Engineer-in-charge

Motor side 35sqmm

Supply side 50sqmm