Renovation of Sewerage Treatment Plant building

Amount

Distempering with washable oil bound distemper (of approved manufacture) two coats on old distempered work.( HSR-16.60)

Distempering with washable oil bound distemper (of approved manufacture) two coats over one priming coat on new work. (HSR-16.58)

Scraping of White wash and colour wash (HSR 8.32 a)

Scraping of cement plaster (HSR-8.32c)

15 mm thick cement plaster 1:4 on the rough side of single or half brick wall (HSR-15.10)

providing ans applying two coats white cement based putty over plastered surface and grinding the surface smooth with sand paper to get an even and smooth finish including cost and carriage of all material, labour charges, scaffolding, sundries etc. complete (J.K./Birla make) (HSR - 16.81)

Applying pink primer or aluminium priming coat on wood work including preparation of surface, knotting and stopping etc. (HSR-16.2)

Painting two coats with synthetic enamel Paint in all shades on old wood-work or metallic or plastered or concrete surfaces to give an even shade including rubbing down old paint. (HSR 16.5)

Applying priming coat with cement primer in all shades on newly plastered or concrete exterior surface. (HSR 16.25)

Providing two coats of exterior acrylic emulsion paint. (HSR-16.79-b). 1st quality

Factory-manufactured wire gauze door and windows shutters of commercial hard wood such as hollock, champ, chikrassy and chaplash, etc, (non coniferous timber other teak, conforming to I.S. specification no. 1003, kiln seasoned) with 100 mm wide vertical styles, 150 mm wide locak rail 200 mm wide bottom rail and wire gauze of 140 G or 120 G designation including cost of iron hinges, screws, chock/cleats, stops nails etc., complete fixed in position (excluding the cost of any fitting other than specified above, but including labour for fixing the same in position)- (styles and rails of windows shutter shall be 75 mm wide) (ii) 35 mm thick (HSR-17.92ii)

Cost of Aluminnium fittings complete for doors and windows, such as tower bolts, handles, etc. and screws for these fittings (excluding sliding bolt) (a) for Single leaf shutter. (Powder coated fittings will be supplied by the deptt. Instead of Aluminium fittings). [HSR 17.72].

Providing and fixing helical door spring 150 mm (superior quality), including necessary screws, complete- b) Iron Air Blower (HSR-17.79 b)

Providing and fixing sliding bolt with nuts & screws etc complete. (b) Iron Air Blower [HSR 17.83 (b)].

Supplying and fixing rolling shutters, of approved make, M.S. laths, interlocked together through their entire length, and jointed together, t the end, by end locks mounted on specially designed pipe shaft, with brackets, side guides 27.5 cm long wire spring grade no. 2 and arrangement for inside and out-side locking with push and pull operation complete, including top cover 0.80 mm thick (payment is to be made for the exact size of opening where rolling shutter is to be fixed):- with 80 mm X 1.00 mm M.S. Laths (HSR-18.18 a)

Earth work in excavation in foundations, trenches etc. in all kinds of soil, not exceeding 2 meters depth including dressing of bottom and sides of trenches, stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonry in 15 cm layers with compaction, including disposal of all surplus soil as directed within a lead of 30 Mtrs. (HSR 6.6)

First class brick work laid in cement sand mortar 1:4 in foundation and plinth. (HSR-11.4)

Cement concrete 1 : 4 : 8 with brick ballast 20 mm nominal size in foundation and plinth. (HSR-10.37)

Conglomerate floor 50 mm thick cement concrete topping 1:2:4 (HSR-14.10)

Providing and fixing in position 15 mm i/d C.P brass bib Cocks of best quality (as required by Engineer-in-charge) Bid cock long body. HSR. 30.75 (a)

Providing & fixing in position C.P. brass stop cock (as approved by the engineer-in-charge). (a) 15 mm Stop cock. (ii) Concealed stop cock with flange. [HSR 30.76 (a) (ii)].

Providing and Fixing HDPE WATER STORAGE TANKS (1000 ltr. capcity) of Sintex, Diplast, O.K. Supreme make with covers/lids marked with IS:12701 on roof top of buildings including cost of hoisting and placing in position, making connections with inlet and outlet pipes, providing overflow and scour provisions with suitable plug on scour pipe including cost of nipples, washers flages for connections in tanks complete in all respects to the satisfaction to the Engineer-in-Charge. [HSR 30.119].

Providing and fixing in position automatic brass ball valves in tanks. (b) With Plastic Ball (ii) 20 mm internal diameter. [HSR 30.110 (b) (ii)].

providing and fixing PVC cisten set heaving 10 ltr. Capcity complete with flus band all other necessary fittings make:- Century/Jaquar Colour white (N.S items )

Providing and fixing fiber glass sheet shed 2mm thik having 1"x1" square pope (approx. 7 kg weight per 20' length ) 1'x1 1/2' diagonal and upto the height 12' including painting and c.c. cost in 1'x1' pits completed in all respect. (NS Items )

The Kamaspur Coop L and C Society ltd

DHARAMJEET

M/S KESHAV ENTERPRISES