supplying installation testing and commissioning of VT pump sets with allied equipment work and commissioning of horizontal casing CF pump sets with allied equipment work at Pojenga and Adjoing villages Rural Piped Water Supply scheme Gumla

Mechanical & Electrical Work at Intake well

Supply, installation, testing and commissioning of vertical turbine pump sets with allied equipment as Under Vertical Turbine Pump [ Make : Kirloskar/ jyoti/Worthington/ Mather & Platt] as per IS. 1710/1972, SIS of VT pump set capable of discharging 790 LPM against the total head of 40 M coupled with squirrel cage induction motor, having 20% more BHP than that of pump, operating on 1500 rpm, 415V, 50Hz, [Make; Kirloskar/ BHEL/ ABB/ Jyoti/ Crompton greaves] all complete suitable discharge head, base plate & accessories such as suitable MS Column pipe flange type 60 ft spider bearing , line shaft rubber cut less bush spider with strainer ,motorised sluice valve ratio PN - 1.6 NR valve , pressure gauge including cost of construction PCC foundation with cement sand , stone chips foundation bolt nut, spring washer , plaster punning of foundation and making delivery pipe with piping works required for the job and etc all complete job , testing of pump set on full load at site.(cost of Pump, Motor etc) (Contractor will again have to check the Design of pump & motor and get it approved by the Deppt.) Discharging - 790 LPM and Head - 40M (1W + 1S) 15HP

Power wiring with required 10Sq mm 3.5 core 1.1 KV grade unarmored Copper cables XLPE/PVC insulated unarmored cable from Power distribution Panel (MCP) to motors, including laying on wall or on floor as where required jointing and making proper terminations, etc. all complete.

Providing / erecting Servo controlled Automatic voltage stabilizer (Output 415+/-1%) Input 220 to 460 volt 3 phase 50 HZ, with copper would transformer Air cooled of 30 KVA etc all complete with change over switch and all accessories including earthling etc. all complete as per site requirement.

(Mechanical & Electrical Part at WTP)

Supply, installation, testing and commissioning of horizontal casing centrifugal pump sets with allied equipment. Horizontal Split Casing end suction Centrifugal Pump [make: Kirloskar/Jyoti/ Worthington/ Mather & Platt] , capable of discharging required flow against required Head-as below. mounted on common base plate and coupled with TEFC, squirrel cage induction motor, rating of motor 15% more BHP than that of pump, operating on 1500 rpm, 415V, 50Hz [make: Kirloskar/ABB/ Jyoti/Crompton Greaves/BHEL] pressure gauge, required size of Motorised sluice valve and non-return valve, standard fittings etc. including construction of MS Suction and delivery header, jointing it with Suction and Delivery line by providing required MS/CI pipes, flanges, reducer and specials, nuts bolts, packings etc. all complete as per the requirement, standards and instruction of E/I.(Contractor will again have to check the design of motor, pump & get it approved by the Deptt.) Discharge 790 LPM and Head 25M (1W+1S)

Power wiring with required 6 Sq 3 core 1.1 KV grade unarmored Copper cables, XLPE/PVC insulated armoured cable from Power distribution Panel (MCP) to Motors, including laying on wall or on floor as where required, jointing and making proper terminations. Etc all complete.

Providing / erecting Servo controlled Automatic voltage stabilizer (Output 415±/-1%) input 270 to 460 Volt 3 phase 50 Hz, with copper would transformer oil cooled of 20 KVA etc all complete with change over switch and all accessories including Earthling etc. all complete as per site requirement.